tow CITROEN C3 2009 Owners Manual

FAMILIARISATION
SEEING CLEARLY
Lighting
Ring A
Ring B


 67 Lighting off.
Automatic lighting.
Sidelamps.
Dipped/main beam headlamps.
Rear foglamps.
or
Front and rear foglamps. Wipers

2. Fast wipe.

1. Normal wipe.

Int. Intermittent wipe.

0. Park.

AUTO 
Automatic wiping or single wipe.


 71


 72 Park.
Intermittent wipe.
Wash-wipe.
Stalk A: windscreen wipers
Wash-wipe: pull the control towards
you.
Switching on "AUTO" mode

 Push the stalk downwards and re-
lease it.
Switching off "AUTO" mode

 Push the stalk upwards and return it
to position "0" .
Ring B: rear wiper


 73

1
INSTRUMENTS and CONTROLS

Front
foglamps fi xed. The front foglamps are
switched on. Turn the ring on the stalk rearwards twice to
switch off the front foglamps.

Rear
foglamps fi xed. The rear foglamps are
switched on. Turn the ring on the stalk rearwards to switch off
the rear foglamps.

Diesel engine
pre-heating fi xed. The ignition switch is at the
2
nd
position (ignition on).
Wait until the warning lamp has switched off before
starting.
The duration for which the warning lamp is on is
determined by the climatic conditions.

Parking brake fi xed. The parking brake is
applied or not properly
released. Release the parking brake to switch off the
warning lamp, keeping your foot on the brake
pedal.
Observe the safety recommendations.
For further information on the parking brake, refer
to the "Driving" section.
Warning lamp is on Cause Action/Observations


Engine
coolant
temperature fi xed blue. On starting the engine, it
indicates that the engine is
cold. After a few minutes driving, it swiches off to
indicate that the engine temperature is normal.
In order to protect your engine, avoid driving too
hard until the warning lamp has switched off.

Foot on the
brake pedal fi xed. The brake pedal must be
pressed. To start the engine, put the automatic gearbox
selector lever in position
P .

Automatic
wiping fi xed. The wiper control is pushed
downwards. Automatic front wiping is activated.


Main beam
headlamps fi xed. The lighting stalk is pulled
towards you. Pull the stalk to return to dipped beam
headlamps.

3
COMFORT
RECOMMENDATIONS FOR VENTILATION AND AIR
CONDITIONING
In order for these systems to be fully effective, follow the operation and
maintenance guidelines below:

 To obtain an even air distribution, take care not to obst ruct the exterior
air intake grilles located at the base of the windscreen, th e nozzles,
the vents and the air outlets, as well as the air extractor lo cated in the
boot.

 Do not cover the sunshine sensor, located on the dashboard; this is
used for regulation of the air conditioning system.

 Operate the air conditioning system for 5 to 10 minutes, on ce or twice a
month to keep it in perfect working order.

 Ensure that the passenger compartment fi lter is i n good condition and have
the fi lter elements replaced regularly (refer to th e "Checks" section).
We recommend the use of a combined passenger compa rtment fi lter.
Thanks to its special active additive, it contribut es to the purifi cation of the air
breathed by the occupants and the cleanliness of th e passenger compart-
ment (reduction of allergic symptoms, bad odours an d greasy deposits).

 To guarantee correct operation of the air conditioning syste m, you are
also advised to have it checked regularly.

 If the system does not produce cold air, do not use it and contact a
CITROËN dealer.
When towing the maximum load on a steep gradient in high temperatures,
switching off the air conditioning permits the recovery of engi ne power and
therefore improvement of the towing capacity. If after an extended stop in sun-
shine, the interior temperature is
very high, fi rst ventilate the cabin
for a few moments.
Put the air fl ow control at a set-
ting high enough to quickly
change the air in the cabin.
The air conditioning system
does not contain chlorine and
does not present any danger to
the ozone layer.
The condensation created by
the air conditioning results in a
discharge of water under the
vehicle which is perfectly normal.

3
COMFORT
4. Air conditioning on/off Press this button to switch off
the air conditioning.
Stopping the air conditioning may cause
some problems (humidity, misting).
Automatic operation of the air condi-
tioning is resumed when the button is
pressed again. The symbol "A/C" is
displayed.
5. Air intake/Air recirculation
Press this button for recircula-
tion of the interior air. The air
recirculation symbol 5 is dis-
played.
Air recirculation enables the passenger
compartment to be isolated from exte-
rior odours and smoke. 6. Air distribution adjustment
Avoid prolonged recirculation of
interior air (risk of condensation
or deterioration of the air quality).
Pressing this button several
times in succession enables
the air fl ow to be directed in
turn towards:
- the windscreen and the side win- dows (demisting or defrosting),
- the windscreen, side windows and air vents,
- the windscreen, the side windows, the air vents and the footwells,
- the windscreen, the side windows and the footwells,
- the footwells,
- the air vents and the footwells,
- the air vents. 7. Air flow adjustment
Press the "full fan" symbol to
increase the air fl ow.
The air fl ow symbol, the fan, fi lls pro-
gressively according to the value re-
quested.
Switching the system off
Avoid driving for long periods
with the air conditioning switched
off (risk of misting and reduction
of the air quality in the cabin). Press the air fl ow
"empty fan"
button of air fl ow 7 until the fan
symbol disappears.
This action switches off all of the func-
tions of the air conditioning system.
Thermal comfort is no longer control-
led. A slight fl ow of air resulting from the
movement of the vehicle, remains per-
ceptible however.
Pressing the air fl ow "full fan" button of
air fl ow 7 or on "AUTO" reactivates the
system with the values set before it was
switched off. Press the
"empty fan" symbol
to decrease the air fl ow.
For maximum cooling or heating
of the cabin, it is possible to go
beyond the minimum 14 or maxi-
mum 28 values.

 Press the blue button 2 until

"LO" is displayed or the red
button 2 until "HI" is displayed. Press this button again or press the

"AUTO" button to resume automatic
management of the intake of air. The air
recirculation symbol 5 is switched off.

4
ACCESS
Remote control problem
Following disconnection of the vehicle
battery, replacement of the remote con-
trol battery or in the event of a remote
control malfunction, you can no longer
unlock, lock or locate your vehicle.

 First of all, use the key in the lock to
unlock or lock your vehicle.

 Then, reinitialise the remote control.
If the problem persists, contact a
CITROËN dealer as soon as possible.
Reinitialisation

 Switch off the ignition.


Turn the key to position 2 (Ignition) .

 Press the closed padlock immedi-
ately for a few seconds.

 Switch off the ignition and remove
the key from the ignition switch.
The remote control is fully operational
again. Changing the battery
Battery ref.: CR1620/3 volts.
This replacement battery is available
from CITROËN dealers.
If the battery is fl at, you
are informed by light-
ing of this warning lamp,
an audible signal and a
message on the multi-
function screen.

 Unclip the casing using a coin at the
notch.

 Slide the fl at battery out of its location.

 Slide the new battery into its loca-
tion observing the original direction.

 Clip the casing.

 Reinitialise the remote control.
Starting the vehicle

 Insert the key in the ignition switch.
The system recognises the starting code.

 Turn the key fully towards the fascia
to position 3 (Starting) .

 When the engine starts, release the
key.
Switching the vehicle off

 Immobilise the vehicle.

 Turn the key fully towards you to posi-
tion 1 (Stop) .

 Remove the key from the ignition
switch.
Do not attach any heavy objects
to the key as this could weigh
down on it when in the ignition
switch and cause a fault.
Key reminder
If the key is left in the igni-
tion switch, an audible signal
sounds when the driver's door is
opened.

5
VISIBILITY
Rear wiper
park,
intermittent wipe,
wash-wipe (set duration).
Reverse gear
When reverse gear is engaged, the
rear wiper will come into operation if the
windscreen wipers are operating.
Programming
The function is activated or deactivated
via the multifunction screen confi gura-
tion menu.
This function is activated by default. Windscreen wash
Pull the wiper stalk towards you. The
windscreen wash, then the windscreen
wipers, operate for a specifi ed time.

B. rear wiper selection ring:
If a signifi cant accumulation of
snow or ice is present, or when
using a tailgate bicycle car-
rier, deactivate the automatic
rear wiper via the multifunction
screen confi guration menu.

6
FITTINGS
SUN VISOR
Component which protects against sun-
light from the front or the side.
Version without Zenith windscreen
GLOVE BOX

 To open the glove box, raise the
handle.
It houses the front passenger airbag de-
activation switch A .
It gives access to the dashboard fuse-
box (see the "Practical information - §
Changing a fuse" section).
CENTRE ARMREST
Comfort and storage system for the
driver and front passenger.
Storage

 For access to the closed storage
box, lift the lever to open the lid.

 For access to the open storage box
below the armrest, lift the complete
armrest towards the rear.
These can be used for portable devices
(mobile phone, MP3 player...) which
can be connected to the USB port/Jack
socket or charged from the 12 V socket
in the centre console.
Version with Zenith windscreen
Refer to the "Familiarisation - § Zenith
windscreen" section.
The sun visors are fi tted with a courtesy
mirror, with concealing fl ap for the driver
and a ticket/card holder.

6
FITTINGS
SUN VISOR
Component which protects against sun-
light from the front or the side.
Version without Zenith windscreen
GLOVE BOX

 To open the glove box, raise the
handle.
It houses the front passenger airbag de-
activation switch A .
It gives access to the dashboard fuse-
box (see the "Practical information - §
Changing a fuse" section).
CENTRE ARMREST
Comfort and storage system for the
driver and front passenger.
Storage

 For access to the closed storage
box, lift the lever to open the lid.

 For access to the open storage box
below the armrest, lift the complete
armrest towards the rear.
These can be used for portable devices
(mobile phone, MP3 player...) which
can be connected to the USB port/Jack
socket or charged from the 12 V socket
in the centre console.
Version with Zenith windscreen
Refer to the "Familiarisation - § Zenith
windscreen" section.
The sun visors are fi tted with a courtesy
mirror, with concealing fl ap for the driver
and a ticket/card holder.

6
FITTINGS
BOOT FITTINGS

1. Rear shelf
(see following page for details)

2. Hooks
(see following page for details)

3. Location for Hi-Fi amplifi er

4. Stowing rings

5. Luggage retaining net
(see following page for details)

6. Storage box (version equipped with
a temporary puncture repair kit)
(see following page for details)
or
Tool box (version equipped with a
spare wheel)
(refer to section "Practical Information - § Changing a wheel")

6
FITTINGS
Rear shelf
To remove the shelf:

 unhook the two cords,

 raise the shelf slightly, then unclip it
on each side. Hooks
The hooks permit the securing of
shopping bags.
Luggage retaining net
Hooked onto the stowing rings, this en-
ables you to secure your luggage to the
bottom of the boot. Storage box

 Raise the boot carpet to gain access
to the storage box.
This has areas for storing a temporary
puncture repair kit, a box of spare bulbs,
a fi rst aid kit, two warning triangles, ...

 refi t the boot fl oor carpet by folding it
slightly in two.