Citroen C3 2012 2.G Manual Online

Page 81 of 252

5
79
VISIBILITY

* According to country.
Daytime running lamps *


On vehicles fi tted with daytime run-
ning lamps, the dipped beams come on
when the vehicle is started.
Manual guide-me-home lighting
Temporarily keeping the dipped beam
headlamps on after the vehicle's igni-
tion has been switched off makes the
driver's exit easier when the light is
poor.

Switching on


)
With the ignition off, "fl ash" the
headlamps using the lighting stalk.

)
A further "headlamp fl ash" switches
the function off.


Switching off
The manual guide-me-home lighting
switches off automatically after a set
time.

The sidelamps and dipped beam head-
lamps are switched on automatically,
without any action on the part of the
driver, when a low level of external light
is detected or in certain cases of activa-
tion of the windscreen wipers.
As soon as the brightness returns to a
suffi cient level or after the windscreen
wipers are switched off, the lamps are
switched off automatically.

Activation


)
Turn ring to the "AUTO"
position.
The automatic illumination of head-
lamps is accompanied by a mes-
sage in the screen.


Deactivation


)
Turn ring to a position other than
"AUTO"
. Deactivation is accompa-
nied by a message in the screen.
This warning lamp comes on in
the instrument panel.
The instruments and controls (instru-
ment panel, multifunction screen, air
conditioning control panel, etc.) are not
illuminated, except on switching to the
automatic lighting mode or when the
lighting is switched on manually.
This function can be activated/deacti-
vated by a CITROËN dealer or a quali-
fi ed workshop. In some weather conditions (e.g.
low temperature or humidity),
the presence of misting on the
internal surface of the glass of
the headlamps and rear lamps
is normal; it disappears after the
lamps have been on for a few
minutes.

Page 82 of 252

5
80
VISIBILITY
To avoid causing a nuisance to other
road users, the height of the headlam-
ps should be adjusted in relation to the
load in the vehicle.

0

.

Driver only or driver + front passenger.


-
. Intermediate setting

1.
5 people.

-
. 5 people + load in the boot.

2.
Driver only + maximum authorised
load in the boot.
This position is suffi cient to avoid causing
dazzle.
Higher settings may limit the spread of
light from the headlamps.
The initial setting is position "0"
.
HEADLAMP ADJUSTMENT

Association with the automatic
"Guide-me-home" lighting
Association with the automatic illumination of headlamps provides "guide-me-home"
lighting with the following additional op-
tions:


- selection of the lighting duration to 15,
30 or 60 seconds in the functions that
can be set in the vehicle confi gura-
tion menu (except in the case of the
monochrome screen A, for which the
duration is set: 60 seconds),

- automatic activation of "guide-me-
home" lighting when automatic illumi-
nation of headlamps is in operation.


Operating fault In fog or snow, the sunshine sen-
sor may detect suffi cient light.
Therefore, the lighting will not
come on automatically.
Do not cover the sunshine sen-
sor, coupled with the rain sensor
and located in the centre of the
windscreen behind the rear view
mirror; the associated functions
would no longer be controlled.

In the event of a fault with the
sunshine sensor, the lighting
come on, this warning lamp
is displayed in the instrument panel and/
or a message appears in the screen,
accompanied by an audible signal.
Contact a CITROËN dealer or a qualifi ed
workshop.

Page 83 of 252

5
81
VISIBILITY
WIPER CONTROLS
System for selection and control of the
various front and rear wiping modes for
the elimination of rain and cleaning.
The vehicle's front and rear wipers are
designed to improve the driver's visibil-
ity progressively according to the cli-
matic conditions.

Programming

Various automatic wiper control modes
are also available according to the fol-
lowing options:


- automatic rain sensitive windscreen
wipers,

- rear wiping on engaging reverse
gear.


Model with intermittent wiping



Model with AUTO wiping



Manual controls

The wiper commands are issued directly
by the driver by means of the stalk A
and
the ring B
.

Windscreen wipers

A.
Wiping speed selection stalk:
single wipe (press down and re-
lease),





or fast (heavy rain),
normal (moderate rain),
intermittent (proportional to the
speed of the vehicle),
park,

automatic, then single
wipe (see following
page).

Page 84 of 252

5
82
VISIBILITY












Rear wiper
park,
intermittent wipe,
wash-wipe (set duration).

Reverse gear
When reverse gear is engaged, the
rear wiper will come into operation if the
windscreen wipers are operating.

Programming
The function is activated or deactivated
via the vehicle confi guration menu.
This function is activated by default.







Windscreen wash
Pull the wiper stalk towards you. The
windscreen wash, then the windscreen
wipers, operate for a pre-determined
time.

B.
Rear wiper selection ring:
If a signifi cant accumulation of
snow or ice is present, or when
using a tailgate bicycle car-
rier, deactivate the automatic
rear wiper via the multifunction
screen confi guration menu.

Page 85 of 252

5
83
VISIBILITY
Automatic rain sensitive
windscreen wipers
The windscreen wipers operate automati-
cally, without any action on the part of the
driver, if rain is detected (sensor behind
the rear view mirror), adapting their speed
to the intensity of the rainfall.

Activation

Switching off
Operating fault
If an automatic wiping fault occurs,
the wipers will operate in intermittent
mode.
Have it checked by a CITROËN dealer
or a qualifi ed workshop.
Vertical windscreen wiper position

To retain the effectiveness of the
"fl at-blade" wiper blades, it is ad-
visable to:


- handle them with care,

- clean them regularly using
soapy water,

- not use them to hold a sheet
of cardboard against the
windscreen,

- replace them at the fi rst signs
of wear.
Do not cover the rain sensor,
linked with the sunshine sensor
and located in the centre of the
windscreen behind the rear view
mirror.
Switch off the automatic wiping
when using an automatic car
wash.
In winter, it is advisable to wait
until the windscreen is complete-
ly clear of ice before activating
the automatic wiping.
The automatic wiping must be re-
activated if the ignition has been
off for more than one minute, by
pushing stalk A
downwards.
This position allows the wiper blades to
be lifted for winter parking, cleaning or re-
placement without damaging the bonnet.
In the minute following switching off of
the ignition, any action on the wiper
stalk positions the wipers vertically.
To park the wipers after this has been
done, switch on the ignition and operate
the wiper stalk. This is controlled manually by the driver by
pushing stalk A
to the "AUTO"
position.
This is controlled manually by the driver
by moving stalk A
upwards, returning it
to position "0"
. It is accompanied by the indica-
tor lamp in the instrument panel
going off and a message in the
multifunction screen.
It is accompanied by the illumina-
tion of this indicator lamp in the
instrument panel and a message
in the multifunction screen.

Page 86 of 252

5
84
VISIBILITY


A.
Central courtesy lamp





1.
Rear side reading lamps


2.
Rear courtesy lamp




Central or rear courtesy lamps


Version without Zenith windscreen

Front side reading lamps



)
With the ignition on, the fi rst press of
the corresponding switch switches
on the reading lamp concerned in
permanent lighting mode.

)

Following a second press, it comes on:


- when the vehicle is unlocked,

- when the key is removed from the
ignition,

- when a door is opened,

- when the remote control locking
button is pressed, in order to lo-
cate your vehicle.
In permanent lighting mode, the
lighting duration varies, according
to the circumstances:


- with the ignition off, approxi-
mately ten minutes,

- in energy economy mode,
approximately thirty seconds,

- with the engine running, un-
limited.

Version with Zenith windscreen In this position, the courtesy
lamp comes on gradually:


- when the vehicle is unlocked,

- when the key is removed from the
ignition,

- when a door is opened,

- when the remote control locking but-
ton is activated, in order to locate
your vehicle.
It switches off gradually:


- when the vehicle is locked,

- when the ignition is switched on,

- 30 seconds after the last door is
closed.
Permanently off.
Permanent lighting.
It switches off gradually:


- when the vehicle is locked,

- when the ignition is switched on,

- 30 seconds after the last door is
closed.
To switch off the rear courtesy lamp,
place it in the "permanently off" position.
COURTESY LAMPS

Selection and control of the various
passenger compartment lamps.

Page 87 of 252

5
85
VISIBILITY
INTERIOR MOOD LIGHTING
The dimmed passenger compartment
lighting improves visibility in the vehicle
when the light is poor.

Switching on

At night, the illumination of the central
dashboard storage compartment comes
on automatically when the sidelamps
are switched on.
Switching off
The interior mood lighting switches off
automatically when the sidelamps are
switched off.
It can be switched off manually using
the instrument panel lighting rheostat
button.


)
With the lighting on, press several
times on the left hand button of the
instrument panel to progressively
reduce the dashboard lighting level.

)
Press again to reduce the lighting
level to the minimum and switch off
the interior mood lighting.
This comes on automatically when the
boot is opened and switches off auto-
matically when the boot is closed.




BOOT LAMP






The lighting time varies according
to the circumstances:


- when the ignition is off, ap-
proximately ten minutes,

- in energy economy mode, ap-
proximately thirty seconds,

- when the engine is running,
no limit. On certain versions, three lamps locat-
ed in the support between the roof and
the automatic day/night interior mirror
come on as well.

Page 88 of 252

6
FITTINGS
INTERIOR FITTINGS


1.
Sun visor


2.
Illuminated
glove box

(see details on following page)

3.
Door pocket

s


4.
Upper storage compartment


5.
Lower storage compartment with
non-slip mat


6.
USB port / Auxiliary socket

(see details on following page)
or
Coin holder


7.
12 V
accessory
socket

(see details on following page)

8.
Centre armrest with storage

(see details on the following page)
or
Cup/bottle holder

Page 89 of 252

6
87
FITTINGS
SUN VISOR
Component which protects against sun-
light from the front or the side.

Version without Zenith windscreen
ILLUMINATED GLOVE BOX


This can be used to hold a water bottle.
Its lid has a location for storing the vehicle's
handbook pack.


)
To open the glove box, raise the
handle.
It is lit when the lid is opened.
It houses the front passenger's airbag
deactivation switch A
.
Depending on your vehicle version, it pro-
vides access to the ventilation nozzle B
,
distributing the same conditioned air as
the vents in the passenger compartment.

Comfort and storage system for the driver
and front passenger.

Storage



)
For access to the closed storage
box, lift the lever to open the lid.

)
For access to the open storage box
below the armrest, lift the complete
armrest towards the rear.
These can be used for portable devices
(mobile phone, MP3 player...) which can
be connected to the USB port/auxiliary
socket or charged from the 12 V socket
in the centre console.
Version with Zenith windscreen
Refer to the "Familiarisation - § Zenith
windscreen" section.
The sun visors are fi tted with a courtesy
mirror, with concealing fl ap for the driver
and a ticket/card holder.

Page 90 of 252

6
88
FITTINGS
USB PLAYER

The USB port is located in the "AUX"

box on the centre console.
It permits the connection of a portable
device, such as a digital audio player of
the iPod
® generation 5 and later type or
USB memory stick type.
It reads the audio fi le formats (mp3,
ogg, wma, wav...) which are transmitted
to your audio equipment and played via
the vehicle's speakers.
You can manage these fi les using the
steering mounted controls or the audio
equipment control panel and display
them on the multifunction screen.

When it is in use, the portable
device charges automatically.

For more information on the use of this
equipment, refer to the Audio system part
of the "Audio and Telematics" section.
12 V ACCESSORY SOCKET



)
To connect a 12 V accessory (max
power: 120 W), lift the cover and
connect a suitable adaptor.







AUXILIARY SOCKET


The auxiliary socket is located in the
" AUX
" box on the centre console.
It permits the connection of a portable
device, such as a digital audio player of
the iPod
® type, to listen to your music
fi les using the vehicle's speakers.

For more information on the use of
this equipment, refer to the MyWay or
Audio system part of the "Audio and
Telematics" section. The management of the fi les is
done using your portable device.

Page:   < prev 1-10 ... 41-50 51-60 61-70 71-80 81-90 91-100 101-110 111-120 121-130 ... 260 next >