warning CITROEN C3 DAG 2009 Owners Manual

FAMILIARISATION Rear parking assistance
This equipment provides a warning when
reversing by detecting obstacles located
behind the vehicle.


 106
Guide-me-home lighting
After switching off the ignition, under
low lighting conditions the headlamps
remain on for a few seconds to help you
leave the vehicle.


 67 Temporary puncture repair kit
This kit is a complete system consisting
of a compressor and integral sealant
product, to allow the temporary repair
of a tyre.


 115
Zenith windscreen
This large windscreen provides incompa-
rable visibility and light in the passenger
compartment.


 6
EXTERIOR FEATURES

FAMILIARISATION
INSTRUMENTS AND CONTROLS

1. Steering lock and ignition.

2. Audio equipment steering wheel
controls.

3. Wipers/wash-wipe/trip computer
controls.

4. Microphone.

5. Scented air freshener.

6. Central locking button.

7. Multifunction screen.

8. Hazard warning lamps switch.

9. Central adjustable and closing vents.

10. Sunshine sensor.
HiFi audio system central speaker.

11. Passenger airbag.

12. Side adjustable and closing vent.

13. Glove box/Passenger airbag
deactivation/Audio/video sockets.

14. Parking brake.

15. Central armrest with storage.

16. Upper and lower storage.

17. MyWay or Audio system.

18. Heating/air conditioning controls.

FAMILIARISATION
MONITORING
Instrument panel

A. With the ignition on, the fuel gauge
bars for the fuel remaining should
light up.

B. With the engine running, the associ-
ated low level warning lamp should
switch off.

C. With the ignition on, the oil level in-
dicator should display "OIL OK" for
a few seconds.
If the levels are not correct, top up the
level which is low.


 18 Warning lamps

1. With the ignition on, the orange and
red warning lamps come on.

2. With the engine running, these
warning lamps should switch off.
If a warning lamp remains on, refer to
the page concerned.


 20 Switch panel
Lighting of the indicator lamp indicates
the status of the corresponding function.

A. Activation of the electric child lock.
 87

B. Deactivation of the ESP/ASR system.


 90

FAMILIARISATION
KEEPING YOUR PASSENGERS SAFE
Front passenger's airbag

1. Open the glove box.

2. Insert the key.

3. Select position:
"ON" (activation), with front passenger
or "forwards facing" child seat,
"OFF" (deactivation), with "rear facing"
child seat".

4. Remove the key keeping the switch
in this position.


 93 Front seat belts and
passenger's front airbag

A. Front seat belts not fastened or un-
fastened warning lamp.


 94 Electric child lock
The lighting of the indicator lamp indi-
cates the status of the corresponding
function.

A. Deactivation of the rear door controls.
or

B. Deactivation of the rear door and
rear elecric window controls.


 87

B. Front passenger's airbag deactiva-
tion indicator lamp.

C. Front passenger's airbag activation
indicator lamp.


 91

1
INSTRUMENTS and CONTROLS
Panel grouping together the vehicle operation indication dials and warning lamps.
PETROL - DIESEL MANUAL GEARBOX INSTRUMENT PANELS

5. Display management button
Servicing information.
Adjust the time and choose units.
Reset the maintenance indicator.

6. Instrument panel lighting button.
Adjusts the brightness of the lighting of the instruments and controls.
For further information, refer
to the paragraph relating to the
button or function and its associ-
ated display.
Dials

1. Rev counter.
Indicates the speed of rotation of the engine (x 1 000 rpm).

2. Vehicle speed.
Indicates the current speed of the moving vehicle (mph or km/h).

3. Fuel level.
Indicates the quantity of fuel remaining in the tank.

4. Screen.
A. Ambient temperature.
(°Celsius or °Fahrenheit)

B. Gear change indicator.

C. Time.

D. Engine oil level indicator.
Appears a few seconds after switch- ing on the ignition, then disappears.

E. Trip computer.

F. Maintenance indicato r.
(miles or km) then,
Total mileage.
These two functions are displayed successively when switching on the
ignition.
Screen

1
INSTRUMENTS and CONTROLS
PETROL - DIESEL MANUAL OR AUTOMATIC GEARBOX
INSTRUMENT PANELS
Panel grouping together the vehicle operation indication dials and warning lamps.
Dials

1. Rev counter.
Indicates the speed of rotation of the engine (x 1 000 rpm).

2. Vehicle speed.
Indicates the current speed of the moving vehicle (km/h or mph).

3. Fuel level.
Indicates the quantity of fuel remaining in the tank.

4. Screen.
5. Display management button
Alternates display between range and trip mileage recorder.
Servicing information.
Resets the selected function to zero (trip distance recorder or mainte-
nance indicator).

6. Instrument panel lighting button.
Adjusts the brightness of the lighting of the instruments and controls.
For further information, refer
to the paragraph relating to the
button or function and its associ-
ated display.
A. Speed limiter
(mph or km/h) or
Cruise control.

B. Gear change indicator.

C. Automatic gearbox information.

D. Range
(miles or km) or
Trip mileage recorder.

E. Maintenance indicator
(miles or km), then
Total mileage recorder
These two functions are displayed successively when switching on the
ignition

F. Engine oil level indicator
Appears a few seconds after switching on the ignition, then disappears.
Screen

1
INSTRUMENTS and CONTROLS
Indicator and warning lamps
Visual indicators informing the driver that a system is in operat ion (operation or
deactivation indicator lamps) or of the occurrence of a fault (wa rning lamp).
When the ignition is switched on
Certain warning lamps come on for a few seconds when the vehi cle's ignition is
switched on.
When the engine is started, these same warning lamps should switch off.
If they remain on, before moving off, refer to the informati on on the warning lamp
concerned.
Operation indicator lamps
If one of the following indicator lamps comes on, this confi rms that the corresponding
system has come into operation. The warning lamps may come
on continuously (fi xed) or fl ash.
Certain warning lamps may
come on in two different modes.
Only by relating the type of light-
ing to the operating status of the
vehicle can it be ascertained
whether the situation is normal
or whether a fault has occurred.
Associated warnings
The switching on of certain warning lamps may be accompanied b y an audible
signal and a message on the multifunction screen.

Warning lamp is on Cause Action/Observations

Left-hand
direction

indicato
r fl ashing with
buzzer. The lighting stalk is pressed
down.


Right-hand
direction
indicator fl ashing with
buzzer.
The lighting stalk is pushed up.

Sidelamps fi xed. The lighting stalk is in the
"Sidelamps" position. Turn the control to the desired position.

Dipped beam
headlamps fi xed. The lighting stalk is in the
"Dipped beam headlamps"
position. Turn the control to the desired position.

1
INSTRUMENTS and CONTROLS

Front
foglamps fi xed. The front foglamps are
switched on. Turn the ring on the stalk rearwards twice to
switch off the front foglamps.

Rear
foglamps fi xed. The rear foglamps are
switched on. Turn the ring on the stalk rearwards to switch off
the rear foglamps.

Diesel engine
pre-heating fi xed. The ignition switch is at the
2 nd position (ignition on).
Wait until the warning lamp has switched off before
starting.
The duration for which the warning lamp is on is
determined by the climatic conditions.

Parking brake fi xed. The parking brake is
applied or not properly
released. Release the parking brake to switch off the
warning lamp, keeping your foot on the brake
pedal.
Observe the safety recommendations.
For further information on the parking brake, refer
to the "Driving" section.

Engine
coolant
temperature fi xed blue On starting the engine, it
indicates that the engine is
cold. After a few minutes driving, it swiches off to
indicate that the engine temperature is normal.
In order to protect your engine, avoid driving too
hard until the warning lamp has switched off.

Foot on the
brake pedal fi xed. The brake pedal must be
pressed. To start the engine, put the automatic gearbox
selector lever in position
P .

Automatic
wiping fi xed. The wiper control is pushed
downwards. Automatic front wiping is activated.


Main beam
headlamps fi xed. The lighting stalk is pulled
towards you. Pull the stalk to return to dipped beam
headlamps.

Warning lamp is on Cause Action/Observations

1
INSTRUMENTS and CONTROLS
Deactivation warning lamps
If one of the following warning lamps comes on, th is confi rms that the corresponding system has been switched off intentionally.

Passenger's
air bag
system fi xed. The control, located in the
glove box, is set to the
OFF
position.
The passenger's front
airbag is deactivated. Set the control to the
ON position to activate the
passenger's front airbag. In this case, do not fi t a
child seat in the rear-facing position.
The passenger's airbag system is put into service
automatically when the vehicle is started.

ESP/ASR fi xed. The button, located at
the bottom left of the
dashboard, is pressed. Its
indicator lamp is on.
The ESP/ASR is
deactivated.
ESP: electronic stability
programme.
ASR: anti-skid regulation. Press the button to activate the ESP/ASR. Its
indicator lamp switches off.
From approximately 30 mph (50 km/h), the
system is reactivated automatically.
The ESP/ASR system is activated automatically
when the vehicle is started.

Warning lamp is on Cause Action/Observations

1
INSTRUMENTS and CONTROLS
Warning lamps
When the engine is running or the ve-
hicle is being driven, the switching on
of one of the following warning lamps
indicates a fault which requires action
on the part of the driver. Any fault resulting in the switching on of a warni
ng lamp must be investigated
further by reading the associated message on the mu ltifunction screen.
If you encounter any problems, do not hesitate to contact a CITROËN dealer.

STOP
fi xed, associated
with another warning
lamp and
accompanied by
an audible signal.
It is associated with the
braking system or the
engine coolant temperature. Stop as soon as it is safe to do so.
Park, switch off the ignition and call a CITROËN
dealer.

Service temporarily.
A minor fault has occurred
for which there is no
specifi c warning lamp. Identify the fault by reading the message shown
on the screen, such as, for example:
- the engine oil level,
- the screenwash level,
- the remote control battery,
- saturation of the particle emission fi lter (Die
sel).
For any other faults, contact a CITROËN dealer.
fi xed. A major fault has occurred
for which there is no
specifi c warning lamp. Identify the fault by reading the message shown
on the screen and contact a CITROËN dealer.

Braking fi xed.
The braking system
fl uid level has dropped
signifi cantly. Top up with brake fl uid recommended by
CITROËN.
If the problem persists, have the system checked
by a CITROËN dealer.
+
fi xed, associated with the ABS
warning lamp. The electronic brake force
distribution (EBFD) system
has a fault. Have it checked by a CITROËN dealer.

Warning lamp is on Cause Action/Observations