fuse Citroen C3 PICASSO DAG 2010.5 1.G Owner's Manual

Page 39 of 224

42
COMFORT
VENTILATION
System which creates and maintains
comfortable conditions in the vehicle's
passenger compartment. Air flow paths
The incoming air follows various routes
depending on the controls selected by
the driver:
- direct arrival in the passenger com-
partment (air intake),
- passage through a heating circuit (heating),
- passage through a cooling circuit (air conditioning).
The temperature control enables you to
obtain the level of comfort required by
mixing the air of the various circuits. The air distribution control enables you
to diffuse the air in the passenger com-
partment combining several air vents.
The air fl ow control enables you to
increase or reduce the speed of the
ventilation fan.
Air intake
The air circulating in the passenger com-
partment is fi ltered and originates either
from the outside via the grille located at
the base of the windscreen or from the
inside in air recirculation mode. Control panel
The controls of this system are grouped
together on control panel
A on the cen-
tre console. Depending on the model,
the functions offered are:
- the level of comfort required,
- air fl ow,
- air distribution,
- demisting and defrosting,
- manual or digital air conditioning controls.
Air distribution

1. Windscreen demisting or defrosting
vents.

2. Front side window demisting or de-
frosting vents.

3. Side adjustable air vents.

4. Central adjustable air vents.

5. Air outlets to the front footwells.

6. Air outlets to the rear footwells.

Page 46 of 224

i
i
!
48
COMFORT As a safety precaution, do not car-
ry out any action on the cartridge
while driving.
Do not dismantle the cartridges.
Do not attempt to refi ll the fragrance
diffuser or the cartridges.
Avoid all contact with the skin and
eyes.
Keep out of reach of children and
animals.
Leave the central vents open.
The intensity of diffusion of the fra-
grance may depend on the ventila-
tion or air conditioning settings.
SCENTED AIR FRESHENER
System permitting the diffusion of a fra-
grance in the passenger compartment
in accordance with your requirements,
by means of the adjustment dial and the
various fragrance cartridges available.
Fitting the cartridge

 Remove the cartridge from the
sealing case.

 Install the cartridge (fl ower at top
right).

 Press the dial and turn it a quarter of
a turn clockwise.
Adjustment dial
This dial is located on the dashboard or
in the upper glove box.
It allows you to adjust the intensity of
diffusion of the fragrance.

 Turn the dial to the right to permit
diffusion of the fragrance.

 Turn the dial to the left to stop diffu-
sion of the fragrance. Fragrance cartridge
This cartridge can be removed easily.
You can change it at any time and store
it in the sealed case which keeps it
closed once it has been opened.
You can obtain different fragrance
cartridges from CITROËN dealers.
Removing the cartridge

 Press the dial and turn it a quarter of
a turn anti-clockwise.

 Remove the cartridge.

 Refi t its sealing case.
Do not discard the original cartridge
as this serves as a plug when no
fragrance cartridge is in use.
In order to preserve the service
life of the cartridge, turn the dial to
the left when you no longer wish to
diffuse the fragrance in the passen-
ger compartment.

Page 129 of 224

10
115
CHECKS
PETROL ENGINES

1. Screenwash fl uid reservoir.

2. Coolant header tank.

3. Air fi lter.
4. Brake fl uid reservoir.

5. Battery.

6. Fusebox.
7. Engine oil dipstick.

8. Engine oil fi ller cap.

Page 130 of 224

116
CHECKS
DIESEL ENGINES

1. Screenwash fl uid reservoir.

2. Coolant header tank.

3. Air fi lter.
4. Brake fl uid reservoir.

5. Battery.

6. Fusebox.
7. Engine oil dipstick.

8. Engine oil fi ller cap.

9. Priming pump (on fuel fi lter).

Page 150 of 224

i
!
135
PRACTICAL INFORMATION CITROËN will not accept respon-
sibility for the cost incurred in
repairing your vehicle or for recti-
fying malfunctions resulting from
the installation of accessories not
supplied and not recommended
by CITROËN and not installed in
accordance with its instructions,
in particular when the combined
consumption of all of the addition-
al equipment connected exceeds
10 milliamperes.
Installing electrical accessories
Your vehicle's electrical system is
designed to operate with standard
or optional equipment.
Before installing other electrical
equipment or accessories on your
vehicle, contact a CITROËN dealer.
CHANGING A FUSE
Procedure for replacing a failed fuse
with a new fuse to rectify a failure of the
corresponding function.
Access to tools
The extraction tweezer and the spare
fuse storage compartment are installed
on the back of the dashboard fusebox
cover.
For access to them:

 unclip the cover by pulling on the
side,

 remove the cover completely,

 remove the tweezer. Changing a fuse
Before changing a fuse, the cause of
the failure must be identifi ed and recti-
fi ed.

 Identify the faulty fuse by checking
the condition of its fi lament.

 Use the special tweezer to extract
the fuse from its housing.

 Always replace the faulty fuse with a
fuse of the same rating.

 Check that the number marked on
the fusebox, the rating marked on
the fuse and the following tables all
agree.
Good Failed

Page 151 of 224

136
PRACTICAL INFORMATION
Dashboard fuses
The fusebox is placed in the lower sec-
tion of the dashboard (left-hand side).
Access to fuses

 refer to the paragraph "Access to
tools". Fuse tables

Fuse N° Rating Functions

FH36 5 A Trailer relay unit.

FH37 15 A Trailer accessories socket supply.

FH38 20 A Aftermarket navigation.

FH39 20 A Heated seats.

FH40 30 A Trailer relay unit.

Fuse N° Rating Functions

F1 15 A Rear wiper.

F2 - Not used.

F3 5 A Airbags and pretensioners control unit.

F4 10 A Steering wheel angle sensor, air conditioning,
clutch switch, particle fi lter pump, diagnostic
socket, airfl ow meter.

F5 30 A Electric window switch panel, passenger's electric
window control, front electric window motor.

F6 30 A Rear electric window motor and driver's electric
window motor.

F7 5 A Courtesy and front map reading lamps, glove box
lighting, torch, rear reading lamps.

Page 152 of 224

137
PRACTICAL INFORMATION

Fuse N° Rating Functions

F8 20 A Multifunction screen, audio system, navigation
radio.

F9 30 A Audio system (aftermarket), 12 V socket.

F10 15 A Steering wheel controls.

F11 15 A Ignition, diagnostic socket.

F12 15 A Rain/sunshine sensor, trailer relay unit.

F13 5 A Main stop switch, engine relay unit.

F14 15 A Parking assistance control unit, seat belt
unfastened warning lamp, airbag control unit,
instrument panel, air conditioning, USB Box.

F15 30 A Locking.

F16 - Not used.

F17 40 A Rear screen and door mirrors demist/defrost.

SH - PARC shunt.

Page 153 of 224

138
PRACTICAL INFORMATION
Engine compartment fuses
The fusebox is placed in the engine
compartment near the battery (left-hand
side).
Access to fuses

 Unclip the cover.

 Change the fuse (see corresponding
paragraph).

 When you have fi nished, close the
cover carefully to ensure the correct
sealing of the fusebox. Fuse table

Fuse N° Rating Functions

F1 20 A Engine control unit supply, cooling fan unit control,
multifunction engine control main relay.

F2 15 A Horn.

F3 10 A Front/rear wash-wipe.

F4 20 A Daytime running lamps.

F5 15 A Diesel heater (Diesel engine), fuel pump
(petrol engine).

F6 10 A ABS/ESP control unit, ABS/ESP cut-off relay,
secondary stop switch.

F7 10 A Electric power steering.

F8 25 A Starter motor control.

F9 10 A Switching and protection unit (Diesel).

F10 30 A Diesel engine injection pump valve, injectors and
ignition coils (petrol engine).

F11 40 A Air conditioning fan.

Page 154 of 224

139
PRACTICAL INFORMATION

Fuse N° Rating Functions

F12 30 A Windscreen wipers slow/fast speed.

F13 40 A Built-in systems interface supply (ignition positive).

F14 30 A Valvetronic supply (petrol).

F15 10 A Right-hand main beam headlamp.

F16 10 A Left-hand main beam headlamp.

F17 15 A Left-hand dipped beam headlamp.

F18 15 A Right-hand dipped beam headlamp.

F19 15 A Multifunction engine management supply
(petrol engine), air cooling electrovalves (Diesel).

F20 10 A Multifunction engine management supply (petrol
engine), Turbo pressure regulation electrovalve
(Diesel), engine coolant level sensor (Diesel).

F21 5 A Fan assembly control supply, APC, ABS ESP
relays.

Page 155 of 224

140
PRACTICAL INFORMATION
Table of maxi-fuses

Fuse N° Rating
Functions

MF1 * 60 A Cooling fan assembly.

MF2 * 30 A ABS/ESP control unit.

MF3 * 30 A ABS/ESP control unit.

MF4 * 60 A Built-in Systems Interface (BSI) supply.

MF5 * 60 A Built-in Systems Interface (BSI) supply.

MF6 * - Not used.

MF7 * - Passenger compartment fusebox.

MF8 * - Not used.
* The maxi-fuses provide additional protection for the e lectrical systems. All work on the maxi-fuses must be carried out by a
CITROËN dealer.

Page:   1-10 11-20 next >