Citroen C3 PLURIEL 2008 1.G Owners Manual
Page 91 of 129
1
2
IV
9 3
C A B R I O L E T
Page 92 of 129
1
2
IV
9 4
S P I D E R
Page 93 of 129
1
2
1
IV
9 5
S P I D E R
Page 94 of 129
A
IV
9 6
C A B R I O L E T
Page 95 of 129
IV
9 7
C A B R I O L E T
Page 96 of 129
1
IV
9 8
B O O T C O M P A R T M E N T C O V E R
This movable cover consists of the main section and two side covers that are secured on the cover’s inner face.
The main section enables the boot to be closed off in Cabriolet or Spi- d e r c o n fi g u r a t i o n .
The side covers the bases of the a r c h e s w h e n i n S p i d e r c o n fi g u r a -tion.A. Positioning the boot compart-ment cover:Place yourself at one sde of the vehicle.
Unlock and tilt the rear seat backrest.
Lift the boot cover on one side then remove it from the boot.
Page 97 of 129
1
2
IV
99
B O O T C O M P A R T M E N T C O V E R
D. To lock the boot compartment cover: First close the tailgate 1then the boot cover 2.
The tailgate opening control is a c c e s s e d v i a t h e m o b i l e fl a p i n t h e boot compartment cover.
To remove the boot compartment cover, proceed in reverse order.
Do not place any object on the boot compartment cover.
Page 98 of 129
IV
1 0 0
S I D E C O V E R S
The side covers are to be found on the interior face of the boot com-partment cover.
Positioning the side covers:
Deploy the ring located beneath the cover.
Make sure that the telescopic han-dles are in the fully up position when placing the side covers.
Place the cover in the location vacated by the arch.
Lower the telescopic handle with the palm of your hand to lock the cover in position.
Page 99 of 129
A
IV
1 0 1
A C O U S T I C C O M F O R T
A e r o - a c o u s t i c d e fl e c t o r
Y o u r v e h i c l e i s e q u i p p e d w i t h a n a e r o - a c o u s t i c m o b i l e d e fl e c t o r f o r s u p - p r e s s i n g a n y a i r t u r b u l e n c e w h i c h m a y o c c u r w h e n d r i v i n g i n s a l o o n c o n fi g u -ration with the roof open.
Operation
T h e d e fl e c t o r d e p l o y s a u t o m a t i c a l l y w h e n t h e r o o f i s o p e n e d .
The latch A permits you to immobilise it.
Advice:
T o i m p r o v e y o u r c o m f o r t w h e n i n c a b r i o l e t o r s p i d e r c o n fi g u r a t i o n , i t i s r e c -ommended:to have the front and rear windows up
t o i m m o b i l i s e t h e a c o u s t i c d e fl e c t o r i n t h e c l o s e d p o s i t i o n .
I n s a l o o n c o n fi g u r a t i o n w i t h t h e r o o f c l o s e d f o r d r i v i n g a t h i g h s p e e d , y o u a r e r e c o m m e n d e d t o i m m o b i l i s e t h e a e r o - a c o u s t i c d e fl e c t o r i n t h e c l o s e d position.
Page 100 of 129
1
2
A
V
1 0 2
B O N N E T R E L E A S E
Bonnet release
This operation should only be performed while the vehicle is stationary.
To release the bonnet, pull the con-trol located under the dashboard towards you.
Bonnet stay: Unclip and swivel the strut, to insert it in notch 1, then in notch 2 (See arrow indication).
Warning: Do not pull the strut towards the front.
To close
Fit the strut in its place.
Lower the bonnet carefully, then let it drop shut. Avoid opening the bonnet in high winds.
Action the control A situated below the chevrons, then lift.Note: The panel may be hot after the vehicle has been in use.
Check that the bonnet is properly secured.