lock Citroen C4 DAG 2011 2.G Owner's Manual

CONTENTS
2
Monochrome screen A 50Monochrome screen C 52Colour screen and map 55Trip computer 58
2 - MULTIFUNCTION
SCREENS 50Î61
Ventilation 62Manual air conditioning 64Dual-zone digital air conditioning 66Rear screen demist - defrost 69Front seats 70Rear seats 75Mirrors 76Steering wheel adjustment 78
3 - COMFORT 62 Î 78
Remote control key 79Alarm 87Doors 89Boot 90Electric windows 91Panoramic sunroof 93Fuel tank 94Misfuel prevention 95
4 - ACCESS 79Î 95
Lighting controls 96Automatic illumination
of headlamps 99Welcome lighting 100Headlamp adjustment 100Directional lighting 101Wiper controls 103Automatic rain sensitive wipers 104Courtesy lamps 106Interior mood lighting 107Boot lamp 108
5 - VISIBILITY 96Î 108
Interior fi ttings 109Centre consoles 112Front armrest 113Boot fi ttings 118Luggage cover (enterprise version) 121
6 - FITTINGS 109Î121
Instrument panels 27Rev counter 31Warning and indicator lamps 32Indicators 43Manual test 46Time and units 47Customisation 49
FAMILIARISATION 4Î 26
1 - MONITORING27Î49
Child seats 122ISOFIX child seats 126Child lock 129
7 - CHILD SAFETY 122Î 129

6
OPENING

2-button remote control
3-button remote control Welcome lighting



A.
Unfolding/Folding the key
(fi rst press this button).



79


A.
Folding/unfolding the key
(fi rst press this button).



80
When a sensor detects a low level of
light, the remote switching on of the
dipped beam headlamps, the sidelamps
and the side spotlamps makes your ap-
proach to the vehicle easier.



100 Complete or selective unlocking
of the vehicle
(rapid fl ashing of the direction
indicators).
Normal locking
(press once; fi xed lighting of
the direction indicators). Complete or selective unlock-
ing of the vehicle
(rapid fl ashing of the direction
indicators).
Opening the windows
(hold until the desired level is
reached).
Selective unlocking of the
boot.
Normal locking
(press once; fi xed lighting of
the direction indicators).
Closing the windows
(hold until the desired level is reached). In the same way, the passenger compart-
ment lighting, such as the courtesy lamps
and the footwell lamps, comes on.



108

7
FAMILIARISATION
OPENING

Boot


2-button remote control

3-button remote control


Fuel tank Panoramic sunroof



1.
Unlocking the vehicle.

2.
Opening the boot.



79, 90



1.
Selective unlocking of the boot.

2.
Opening the boot.



80, 90



A.
Opening the fuel fi ller fl ap.
Capacity of the fuel tank: approximately
60 litres.

1.
Opening the blind (four positions
possible).

2.
Closing the blind (initial position).



94



93

10
INSTRUMENTS AND CONTROLS




1.
Steering lock and ignition.

2.
Steering mounted control paddles
for the 6-speed electronic gearbox
system.

3.
Wiper/screenwash/trip computer
control stalk.

4.
Speaker (tweeter).

5.
Windscreen demisting vent.

6.
Sunshine sensor.

7.
Passenger's airbag.

8.
Glove box/Audio/video sockets/
Passenger's airbag deactivation
switch.

9.
Heated seat control.

10.
Lumbar massage control.

11 .
Electric parking brake.

12.
Gear lever, 6-speed electronic
gearbox system.

13.
Large multifunctional storage unit.

13
FAMILIARISATION
SITTING COMFORTABLY

Front seats


Head restraint height and angle

Lumbar
Other functions available...
Lumbar massage.
Storing driving positions (driver's
electric seat).
Heated seats.



Steering wheel adjustmentFront armrest



73


1.
Release the adjustment mechanism.

2.
Adjust for height and reach.

3.
Lock the adjustment mechanism.



78
For your comfort, the front armrest can
be adjusted for longitudinal position and
for height, depending on version.
It also has a storage compartment; this
may be equipped with a 230 V/50 Hz
socket.



113, 114



72

As a safety precaution, these
operations must only be carried
out when stationary.

17
FAMILIARISATION
MONITORING

Instrument panels
Warning lamps Central switch panel



A.
With the ignition on, the bars indicate
the level of fuel remaining.

B.
With the engine running, its associ-
ated low level warning lamp should
go off.

C.
With the ignition on, the oil level indi-
cator should show for a few seconds
that the level is OK or correct, de-
pending on version.



27


1.
With the ignition on, the orange and
red warning lamps come on.

2.
With the engine running, these
warning lamps should go off.



32


A.
Make an emergency call.

134, 223

B.
Access to CITROËN services.

134, 223


C.
Hazard warning.



130

D.
Central locking.



85

E.
Black panel (black screen).



48
If the levels are not correct, top up the
levels which are low. If warning lamps remain on, refer to the
page concerned.

1
MONITORING
36


Warning lamp



is on



Cause



Action/Observations




Anti-lock
Braking
System (ABS)


fi xed. The anti-lock braking system
has a fault. The vehicle retains conventional braking.
Drive carefully at reduced speed and
contact a CITROËN dealer or a qualifi ed
workshop without delay.


Dynamic
stability control
(ESP/ASR)


fl ashing. The ESP/ASR regulation is
active. The system optimises traction and
improves the directional stability of the
vehicle.

fi xed. Unless it has been
deactivated (button pressed
and its indicator lamp on), the
ESP/ASR or hill start assist
system has a fault. Have it checked by a CITROËN dealer or
a qualifi ed workshop.

Engine
autodiagnosis
system


fi xed. The emission control system
has a fault. The warning lamp should go off when the
engine is started.
If it does not go off, contact a CITROËN
dealer or qualifi ed workshop without delay.

fl ashing. The engine management
system has a fault. Risk of destruction of the catalytic converter.
Have it checked by a CITROËN dealer or
a qualifi ed workshop.


Low fuel level


fi xed with the two
last bars fl ashing.
When it fi rst comes on there
remains approximately
6 litres of

fuel
in the tank. You must refuel as soon as possible to
avoid running out of fuel.
This warning lamp will come on every
time the ignition is switched on, until a
suffi cient addition of fuel is made.
Fuel tank capacity: approximately 60 litres.
Never continue to drive until you run out
of fuel as this could damage the emission
control and injection systems.

1
MONITORING
38


Water in Diesel


fi xed. The Diesel fuel fi lter contains
water. Risk of damage to the injection system
on Diesel engines.
Contact a CITROËN dealer or a qualifi ed
workshop without delay.

Particle
emissions fi lter
(Diesel)
fi xed,
accompanied by
an audible signal
message on the
risk of blockage
of the particle
emissions fi lter. This indicates that the particle
emissions fi lter is starting to
become saturated. As soon as driving conditions allow,
regenerate the fi lter by driving at a speed
of at least 35 mph (60 km/h) until the
warning lamp goes off.
fi xed, accompanied
by an audible
signal and and a
message that the
particle emissions
fi lter additive level
is too low. This indicates the low level of
the additive reservoir. Have the reservoir topped up as soon
as possible by a CITROËN dealer or a
qualifi ed workshop.

Warning lamp



is on



Cause



Action/Observations

1
MONITORING
45

Service overdue
For a few seconds after the ignition is
switched on, the spanner fl ashes
to
indicate that the service must be car-
ried out as soon as possible.

Example:
the service is overdue by
180 miles (300 km).
For a few seconds after the ignition is
switched on, the screen indicates:
A few seconds after the ignition is
switched on, the distance recorder re-
sumes its normal operation. The span-
ner remains on
.
The distance remaining may be
weighted by the time factor, de-
pending on the type of driving.
Therefore, the spanner may also
come on if you have exceeded
the two year service interval.







Service indicator zero reset
This operation cannot be car-
ried out while a reminder of the
servicing information is being
displayed.
Following this operation, if you
wish to disconnect the battery,
lock the vehicle and wait at least
fi ve minutes for the zero reset to
be registered.

Recalling the service information
You can recall the service information
at any time.


)
Briefl y press the ".../000"
trip dis-
tance recorder zero reset button.
The service information is displayed
for a few seconds, in the total distance
recorder line or in the instrument pan-
el central colour screen, according to
version.

After each service, the service indicator
must be reset to zero.
The procedure for resetting to zero is
as follows:


)
switch off the ignition,

)
press and hold the ".../000"
trip dis-
tance recorder zero reset button,

)
switch on the ignition; the distance re-
corder display begins a countdown,

)
when the screen indicates "=/0"
and
the spanner disappears, release the
button.

1
MONITORING
47
Distance recorders
The total and trip distances are dis-
played for thirty seconds when the ig-
nition is switched off, when the driver's
door is opened and when the vehicle is
locked or unlocked.

Trip distance recorder
Total distance recorder
Setting the time and the time
format in the instrument panel
without audio system

On the two-tone instrument panel with-
out audio system, to adjust the time,
use buttons A
and B
then carry out the
operations in the following order:


)
press buttons A
and B
simultane-
ously: the minutes fl ash,

)
press A
to increase the minutes or
B
to reduce the minutes,

)
press buttons A
and B
simultane-
ously: the hours fl ash,

)
press A
to increase the hours or B

to reduce the hours,

)
press buttons A
and B
simultane-
ously: 24 H or 12 H is displayed and
fl ashes,

)
press button A
or B
to change the
format,

)
press buttons A
and B
simultane-
ously to exit from time setting.


After approximately 30 seconds without any ac-
tion, the screen returns to the normal display.

Measures the total distance travelled by
the vehicle since its fi rst registration.

Measures a distance travelled since it
was reset to zero by the driver.


)
With the ignition on, press and hold
this button until zeros appear.

On the two-tone instrument panel with-
out audio system, to change the display
units, use buttons A
and B
then carry out
the operations in the following order:


)
press buttons A
and B
simultane-
ously for three seconds: km/h or
mph fl ashes,

)
press button A
or B
to change the
units,

)
press buttons A
and B
simultane-
ously to exit from setting units.
After approximately 30 seconds without
any action, the screen returns to the
normal display

Setting units in the instrument
panel without audio system
Settin
g the time and units in themultifunction screen
The other instrument panels are as-
sociated with an audio system and
a multifunction screen. Refer to the
corresponding section in "Audio and
Telematics".