sensor Citroen C4 PICASSO DAG 2009 1.G Owner's Guide

Page 206 of 337

171
XI
P R A C T I C A L I N F O R M A T I O N
Wheel for temporary use
If your vehicle is equipped with a
spare wheel for temporary use only,
when fi tting this it is normal to observe
that the wheel bolts do not come to
bear directly on the wheel rim.
The spare wheel is secured by the
conical tapering of the wheel bolt’s
shaft.
When refi tting the original wheel, en-
sure that the wheel bolts and wash-
ers are clean and in good condition.

Fitting a wheel

 Position the wheel with the aid of
the centring guide 3 .

 Do up the 3 bolts by hand, then
remove the centring guide 3 .
Position the 4 th bolt.

 Pre-tighten the wheel bolts, us-
ing the wheelbrace 4 .


Retract the jack 5 and disengage it.

 Tighten the wheel bolts, using
the wheelbrace 4 .

 Ensure that the tyre pressure is
correct.
Defl ation detection
Such wheels have tyre pressure
sensors. It is essential to have re-
pairs carried out by a CITROËN
dealer. The spare wheel does not
have a sensor.
Anti-theft bolts (alloy wheels)
Each wheel may be equipped with
one anti-theft bolt.
To remove it:

 Remove the protector that is
covering it by means of the tool for
removing the chrome covers 2 .

 Use the anti-theft socket 6 with
the wheelbrace 4 . Dimension of the spare
wheel
If your spare wheel has dimensions
different from those of the normal ve-
hicle wheels (identifi ed by a label), it
is imperative to use the spare wheel
only temporarily, to drive with cau-
tion, not to exceed 80 km/h (50 mph)
and to have the tyre repaired and
the normal wheel refi tted as soon as
possible.
Tyre pressures
These are indicated on the label on the front left-hand door pillar (see section "Technical Specifi cation - § Vehicle Identifi cation ").
The wheel bolts are specifi c to each type of wheel.
If new wheels are fi tted, check with your CITROËN dealer that the If new wheels are fi tted, check If new wheels are fi tted, check
wheel bolts are compatible with the new wheels.
Note: take care to note down the code number on the head of the anti-theft bolt socket. This will ena-ble you to obtain a replacement anti-theft socket from a CITROËN ble you to obtain a replacement ble you to obtain a replacement
dealership.

Page 337 of 337

302
05
The table below groups together the answers to the most frequently asked questions concerning the vi deo pack.
FREQUENTLY ASKED QUESTIONS
QUESTION SOLUTION
The player does not start. - Check the vehicle's fuses.
The player does not react to pressing of the remote control buttons. - The remote control batteries are fl at. Replace them. - The remote control sensor is hampered by objec ts or is dirty. Remove all objects on the remote control receiver or clean the surface using a damp cloth. - The video pack has overheated. Let it cool for a few minutes.
Image or sound interference while playing a DVD. The image remains frozen during play. The player cannot read the disc. The disc may be d amaged or dirty.
The player does not play the disc inserted. - The format of the disc does not correspond to the specifi cations of the player. - If it is cold, condensation may have formed on the laser. Wait approximately 5 minutes to allow t he humidity to evaporate.
When a DVD/VCD/SVCD is played, the image is of poor quality. - Remove the disc. - Using the SETUP button , adjust the brightness and insert the disc again.
No image is displayed on the monitor. - Press the SOURCE button until the image appea rs. - Press the SCREEN ON/OFF button.
There is no sound in the audio headphones. - Increase the volume using the VOLUME +/- buttons on the remote control or using the dial on the headphones. - Check that the correct channel is selected on the headphones. - Press the SOURCE button until the sound arrive s. - Replace the headphone batteries.
The start-up screen does not appear following ejection of the disc. - Insert another disc. - Switch the system off and then on again.

Page:   < prev 1-10 11-20 21-30