buttons Citroen C4 PICASSO RHD 2013 1.G User Guide

80
OFF
Access

Locking the vehicle
with exterior
perimeter
monitoring only
Deactivate the interior volumetric monitoringto avoid unwanted triggering of the alarm incertain cases such as:


- leaving a window par tially open,

- washing your vehicle,

- changing a wheel,


Deactivation of the volumetric monitoring
)
Switch of the ignition and within
ten seconds press this button until its indicator lamp is on fixed.
)Get out of the vehicle. )Immediately lock the vehicle using theremote control or the "Keyless Entry and Starting" system.
Only the exterior perimeter protection system is
active: the indicator lamp in the button flashes
once per second.
To be e
ffective, this deactivation must be doneevery time the ignition is switched off.
In the case of automatic locking of the vehicle (which occurs after a period of 30 seconds if a door or the boot is notopened), the monitoring system is not reactivated automatically. To reactivate it, it is necessary to unlock the vehicleand lock it again, using the remote control or the "Keyless Entry and Starting" system.

Deactivation
)Press one of the unlocking buttons on theremote control:
short press
long press
or )Unlock the vehicle using the "Keyless Entryand Starting" system.
The monitoring system is deactivated: the
indicator lamp in the button is off and the
direction indicators flash for about 2 seconds.

87
3
Comfort
System which registers the electrical settings of the driver's seat and door mirrors. It enables you to store and recall two positions using the buttons on the side of the driver's seat.
Storing driving positions
Storing a position
Usin
g buttons M / 1 / 2
) Switch on the ignition. )
Adjust your seat and the door mirrors. )
Press button M
, then press button 1or 2
within four seconds.
An audible signal indicates that the position
has been stored.
Storing a new position cancels the previousposition.

Recalling a stored position

I
gnition on or engine running
)
Press button 1or 2to recall the corresponding position.
An audible signal confirms that adjustment
is complete.
You can interrupt the current movement b
ypressing button M, 1
or 2
or by using one of theseat controls.
A stored position cannot be recalled while driving.
Recalling stored positions is deactivated
45 seconds after switching off the ignition.

106
Comfort

















Heating
Temperature adjustment
)
Press one of these buttons,or move the cursor from blue (cold) to red (hot) to adjust the
temperature to your wishes.
Air flow adjustment
) Press one of these buttons toincrease or decrease the speedof the booster fan.


Air distribution adjustment
The intake of exterior air prevents and eliminates misting of the windscreen and side
windows.
The recirculation of interior air prevents exterior
odours and smoke enterin
g the passenger compartment. Win
dscreen.
Footwells.
Centre and side vents. The air distribution can be varied b
y using more
than one button.
Each press of a button activates or deactivates
th
e function.

The indicator lamp is on when the button is activated. For an even distribution of air in the passenger compar tment, the three buttons can
be activated simultaneously.


Air intake / Air recirculation
)
Press this button to recirculate
the interior air. The indicator lamp
in the button comes on.) Press the button again to allow
the intake of exterior air. This is confirmed by the indicator lamp going off.



Avoid driving for too long withoutventilation (risk of misting and deterioration of air quality).
The heatin
g system works only when theengine is running.
Press the button for the " Air conditioning"menu to display the page for the system
controls. The s
ymbol for air flow (a fan) fills progressively
according to the air flow setting made.
By reducing the air flow to the minimum, you
are stopping ventilation of the passenger
compartment.

107
3
Comfort
Dual-zone manual air conditioning with temperature regulation
The air conditioning system operates with the engine running.
The temperature at the nozzles and vents
is re
gulated by the system according to the
temperature in the passenger compartment
and the temperature setting.
Press the button for the " Air conditioning"menu to display the system controls page.
Temperature adjustment
)
Press one of these buttons toreduce (blue) or increase (red)the value.


Air flow adjustment
Press one of these buttons to
increase or decrease the speed of
the air booster fan. The driver and
front passenger can each adjust
the temperature.
The value indicated corresponds to a level of comfor t and not to a temperature in degrees Celsius
or Fahrenheit (depending on the unit selected). A setting of around 21 provides optimumcomfort. Depending on your requirements, a
setting between 18 and 24 is normal.
In addition, it is recommended that a di
fference
between left and right of more than 3 should beavoided. The air
flow symbol (a fan) fills progressivelyaccording to the quantity of air wanted.
By reducing the air flow to minimum, you arestopping ventilation.


Avoid driving too long without ventilation(risk of misting and deterioration of air quality).

109
3
Comfort




















Dual-zone digital air conditioning

This air conditioning system operates with the engine running, but the ventilation and its controls
are available with the ignition on.
Operation of the air conditioning and regulation of temperature, air flow and air distribution in the passenger compartment are automatic.
Press the button for the " Air conditioning" menu to display the controls for the air conditioningsystem.


Temperature adjustment
1.
Automatic mode. 2.Driver's side temperature adjustment.3.Passenger's side temperature adjustment. The driver and
front passenger can each set
t
he temperature.
)Press one of these buttons
to increase the value.
)Press one of these buttons
to decrease the value.

The value indicated corresponds to a level of
comfor t and not to a precise temperature.
It is recommended that
you avoid a left /right setting difference of more than 3.
Dependin
g on the colour scheme chosen, the system controls page is displayed differently:
4.
Air conditioning On / Off.
5. Air distribution adjustment.6.
Air flow adjustment. 7.
Air intake / air recirculation.

111
3
Comfort
You can modulate the distribution of air in the
passenger compartment using these three buttons.
Air fl ow adjustment


Avoid driving for too long with theventilation off (risk of misting and deterioration of air quality).
Air distribution adjustment
)
Press one of these buttons toincrease or decrease the speedof the booster fan.
The air
flow symbol (a fan) is filled inprogressively in relation to the quantity of air wanted.
By reducing the air flow to minimum, you are
stopping ventilation.
"OFF" is displayed alongside the fan. Win
dscreen.
F
ootwells.
Centre and side vents.
Each
press on a button activates or deactivates
the function. The indicator lamp is on when the
button is activated. For a uniform distribution in
the passenger compar tment, all three buttons can be pressed simultaneously.


Resuming manual control


You can manually adjust one or more settings,
while retaining automatic control of the other
functions:


- air flow,

-
air distribution.
)
Press the "AUTO"
button again
to activate the automatic comfort
programme again.

As soon as you modify a setting, the indicator
lamp in the "AUTO
" button goes off.

In AUT
O mode, the indicator lamps in all three buttons are off.

112
Comfort

Avoid prolonged operation of the air recirculation function (risk of misting and of deterioration of the air quality).


"Mono" function

The comfort setting for the passenger's sidecan be indexed to the driver's comfort setting (mono-zone).

From the secondar
y page of the " Airconditioning " menu:
)
Press this button to activate / deactivate the "Mono" function.
The indicator lamp in the button
i
s on when the function isactivated.
The function is deactivated automaticall
y when
the passenger uses their temperature settingbuttons.

It allows you:
- in summer, to lower the temperature,
- in winter, above 3

114
Comfort
Front Demist - Defrost

)
Press this button to demist or defrost the windscreen and side
windows as quickly as possible.
The indicator lamp in the button
comes on.
With Stop & Star t, when demisting hasbeen activated, the STOP mode is notavailable. The s
ystem automatically manages the air
conditioning, air flow and air intake, and provides optimum distribution towards the
windscreen and side windows. )To switch it off press this button, the
indicator lamp goes off.


Ventilation with ignition on
function
With the ignition on, you can use the
ventilation system and have access to the " Airconditioning " menu to adjust the air flow and air distribution in the passenger compartment.
This function is available for a few minutes,
dependin
g on the state of charge of the battery
of your vehicle.
Thi
s function does not activate the air conditioning.
You can make use of the residual heat in theengine to warm the passenger compar tment
using the temperature setting buttons.

128
Comfort
1. Screen power switch 2.
Display adjustment buttons


Each head
phone set has a switch,
a connection indicator lamp (blue)and a channel selector (A or B).
) With the engine running, connect your
portable system to the RCA connectors (e.g. with AV1 on the left). ) Press the switch on the control panel,
the indicator lamp comes on and the AV1
indicator lamps come on.
) Make a long press on the switch, its
indicator lamp flashes in blue.) Make a long press on the control panelswitch, the pairing with the headphone set
is complete when the blue indicator lampson the headphones and on the system areon continuously. ) Repeat the operation for the other
headphone set.
) Press the screen switch if you have a video source. )
Start playing your por table system.


Operation


The Multimedia system allows theconnection of a third Bluetoothheadphone set, not supplied.


If your seat is in the table position,position a cover to avoid damaging thescreen.
These covers also conceal eachscreen.

)It is possible at any time to modify thesource for the video display (using button 6or 7
on the control panel: the indicator lamp for the source selected comes on) as well as the audio channel (using the selector on
the headphones).

169
4
Driving
)Turn wheel 1 to the "LIMIT"
position: thespeed limiter mode is selected but is notswitched on (Pause).)Switch the speed limiter back on bypressing button 4
, if the speed displayed
is suitable (by default, the last speedprogrammed).)You can temporarily stop the the speed limiter by pressing button 4 again: the
display confirms that it has been stopped(Pause).

You do not have to switch the speed limiter on
in order to set the speed.Once the function is selected, you can modify
the speed setting by:
- using buttons 2
and 3
, increasing or decreasing the speed displayed: )
by successive short presses, to modifyby + or -