sensor Citroen C5 2009.5 (RD/TD) / 2.G Owner's Guide

IX
148
D R I V I N G
Reactivation
In bad weather or in winter, ensure
that the sensors are not covered
with mud, ice or snow. When re-
verse gear is engaged, an audible
signal (long beep) indicates that the
sensors may be dirty.
When the speed of the vehicle is
below about 6 mph (10 km/h), some
sources of noise (motorcycle, lorry,
pneumatic drill, ...) may trigger the
audible parking sensor signals.

 Press button A again, the warn-
ing lamp switches off, the system
is reactivated.
"HYDRACTIVE III +" ELECTRONIC SUSPENSION
The suspension automatically and
instantly adjusts to different driving
styles and to the profi le of the road,
providing the best compromise be-
tween occupant comfort and vehicle
road holding.
The system alternates between soft
and fi rm suspension settings, maxi-
mising comfort at the same time as
constantly ensuring the highest level
of safety. It also automatically cor-
rects ride height, according to the
vehicle load and driving conditions.
In addition, the "Hydractive III +" sys-
tem allows you to choose between
two modes of suspension.
A change of suspension mode can
be made either when the vehicle is
moving or when stationary, by press-
ing button A . Display on the instrument
panel
The suspension mode selected is
displayed on the instrument panel
screen.
Normal mode
This mode favours soft
damping for maximum com-
fort.
If the speed authorised for a
particular position is exceed-
ed, the vehicle reverts automatically
to the normal road position.
SPORT mode
This mode favours dynamic
driving.
The warning lamp on but-
ton A comes on in addition
to the message on the in-
strument panel screen.

SPORT mode is retained when you
switch off the engine.

X
153
C H E C K S
BLEEDING THE DIESEL FUEL FILTER
Protective cover
Removal of the cover Bleeding water from the fuel
filter
Bleed regularly (at each oil change).
To bleed the water, slacken the bleed
screw or the water in diesel fuel sen-
sor, located at the base of the fi lter.
Continue until all the water has
fl owed out.
Then retighten the bleed screw or
the water detection sensor.

HDi 110, HDi 163 and V6 HDi 240
engines

 Pull the protective cover upwards
to remove it.

HDi 140 engine


Remove the protective cover by fi rst unclipping at 3 , then 1 and 4.

 Unclip at 2 by pulling towards you,
then lift up.
Refi tting

 Firstly clip in at 2 .

 Lower and centre the cover.

 Clip in at 3 and 4 , pushing verti-
cally and gently from the rear.

 Clip in at 1 pushing vertically.

XI
181
P R A C T I C A L I N F O R M A T I O N
FUSEBOX A Table of fuses

Fuse N° Rating
Function

G29 - -

G30 5 A Heated door mirrors

G31 5 A Rain and brightness sensor

G32 5 A Seat belt not fastened warning lamps

G33 5 A Electrochrome rear view mirror

G34 20 A Sunroof (saloon)

G35 5 A Passenger door lighting - passenger door mirror adjustment

G36 30 A Electric tailgate (tourer)

G37 20 A Heated front seats

G38 30 A Driver’s electric seat

G39 30 A Passenger’s electric seat - HIFI amplifi er

G40 3 A Trailer relay unit supply
FUSEBOX B

Fuse N° Rating
Function

G36
15 A 6 speed automatic gearbox

5 A 4 speed automatic gearbox

G37 10 A Daytime-running lamps - Diagnostic socket

G38 3 A ESP

G39 10 A Hydraulic suspension

G40 3 A STOP switch