steering Citroen C5 2009.5 (RD/TD) / 2.G Owner's Guide

Page 177 of 314

X!
159
C H E C K S
Check all of these levels regularly
and top them up if necessary, unless
otherwise indicated.
If a level drops signifi cantly, have the
corresponding system checked by a
CITROËN dealer.
Oil level Oil change
Refer to the Maintenance and
Warranty Guide for details of the in-
terval for this operation.
Oil specifi cation
The oil must correspond to your engine
and conform to the manufacturer's
recommendations. Brake fluid level
Fluid change
Refer to the Maintenance and
Warranty Guide for details of the in-
terval for this operation.
This fl uid must be changed regularly.
Fluid which has been used exces-
sively may cause a loss of braking
effi ciency.
Fluid specifi cation
The brake fl uid must conform to the
manufacturer's recommendations
and meet the DOT4 standard.
The reading will only be
correct if the vehicle is on
level ground and the engine
has been off for more than
15 minutes.
The check is carried out either when
the ignition is switched on using the
oil level indicator on the instrument
panel, or using the dipstick.
Check this level also between each
scheduled service and before long
journeys. The brake fl uid level should
be close to the "MAX" mark.
If it is not, check the brake
pad wear.
In order to maintain the reli-
ability of the engine and emis-sion control system, the use
of additives in the engine oil is
prohibited. Power steering fluid or power
steering and suspension
fluid level
This fl uid must be topped up
by a CITROËN dealer.
Dipstick
There are 2 marks on the
dipstick:
-
A = max; never ex-
ceed this level,
- B = min; top up the level
via the oil fi ller cap, us-
ing the type of oil suited
to your engine.

Page 181 of 314

XI
163
P R A C T I C A L I N F O R M A T I O N
TEMPORARY PUNCTURE REPAIR KIT Using the kit
The kit is located in the boot under
the fl oor.
 Switch off the ignition.

 Affi x the speed limitation sticker
to the vehicle's steering wheel
to remind you that a wheel is in
temporary use.

 Check that the switch A is in po-
sition "0" .

 Connect the pipe of the bottle 1
to the valve of the tyre to be re-
paired.


Connect the compressor's electric
plug to the vehicle's 12 V socket.

 Start the vehicle and leave the
engine running.
Complete system consisting of a
compressor and a bottle of sealant
product which permits
temporary
repair of the tyre so that you can
drive to the nearest garage.
This repair kit is available from
CITROËN dealers.
It is designed to repair holes of a
maximum diameter of 6 mm, locat-
ed exclusively on the tyre tread or
shoulder. Avoid removing any for-
eign bodies which have penetrated
the tyre.

Page 258 of 314

238
3
11
2
3
208
Press the end of the steering mounted control to accept the call or end the call in progress.
Select the "Yes" tab to accept or "No" to refuse and confi rm by pressing OK.
RECEIVING A CALL MAKING A CALL
An incoming call is announced by a ring and a supe
rimpperimposed display on the screen.
To hang up, press the HANG UP TEL button or press OK and select "End call" then confi rm by pressing OK.
END CALL
Press the PICK UP TEL button.
Press the end of the steering mounted control for more than two seconds to open the address book.
It is also possible to select a number from the address book. You can select “Dial from address book”. The NaviDrive 3D c an record up to 4 096 entries.
Select "Dial number", then dial the telephone number using the virtual keypad.
Select the "Phone" menu function and press OK to confi rm.
DIAL NUMBER
"PHONE" MENU
The list of the last 20 calls made and received in the vehicle appears under "Phone" menu. You can select a number and pre ss OK to make the call. YESNO
The PICK UP TEL button accepts, the HANG UP TEL bu tton refuses The PICK UP TEL button accepts, the HANG UP TEL button refuses the incoming call.
USING THE TELEPHONE

Page:   < prev 1-10 11-20 21-30