parking brake Citroen C5 2009.5 (RD/TD) / 2.G Owner's Manual

Page 4 of 314

7
F A M I L I A R I S A T I O N

 124
I N T E R I O R

Electric parking brake
The electric parking brake combines automatic application when the
engine is switched off, and automatic release when the vehi cle is set in
motion (automatic function activated by default).
Manual locking/unlocking is possible.
Parking space sensor
The "Parking space sensor" func-
tion assists you in fi nding a parking
space.

Dual-zone
digital
air conditioning
This air conditioning system enables you to
adjust the comfort levels of the driver and the
front passenger independently.
Audio and communication systems
This equipment benefi ts from the latest
technology: MP3 compatible radio, Bluetooth ®

system, NaviDrive 3D, MyWay.

 50
 205

 145

Page 6 of 314

9
F A M I L I A R I S A T I O N
D A S H B O A R D

1. Sunlight sensor.

2. Soft diffusion air conditioning adjustment knob.

3. Passenger’s airbag.

4. Side window demist vent.

5. Passenger’s air vents.

6. Bonnet release.

7. Hazard warning lamps button.

8. Switch in the glovebox:
- Passenger’s airbag activation/deactivation

9. Glovebox:
- Vehicle document storage
- Audio-video sockets
- Fusebox access fl ap

10. ESP/Parking Sensors/Lane Departure Warning
System controls.

11. Suspension controls:
- Ground clearance adjustment
- Sport mode

12. Armrest with cup-holder.

13. Electric parking brake.

14. Automatic gearbox SPORT/SNOW mode controls.

15. Ashtray with cigar lighter.

16. Gear lever.

17. Storage.

18. Audio and telematics system.

19. Air conditioning controls.

20. Storage.

21. Multifunction screen.

Page 15 of 314

!!!
18
F A M I L I A R I S A T I O N
Electric parking brake Never leave a child alone inside
the vehicle with the ignition on,
as they could release the parking
brake. Hill start assist
Manual operation
The MANUAL application/release of
the parking brake is always possible by
pulling/pushing control B .
Before leaving the
vehicle, check that
warning lamp A (!) (red)
on the instrument panel
is on fi xed (not fl ashing) and that warning
lamp P (red) on control B is on.
If you leave the vehicle with the
engine still running, apply the
parking brake manually. Do not leave the vehicle while
it is being held in the temporary
immobilisation hill start assist
phase.
To aid starting on a gradient, your
vehicle is equipped with a system which
keeps it immobilised for a short time
(about 2 seconds), the approximate
time it takes to move your foot from the
brake pedal to the accelerator pedal.
This function is only active when:
- The vehicle is completely stationary,
with your foot on the brake pedal.
- In certain conditions on a gradient.
- With the driver’s door closed.
Before leaving the
vehicle, check that
warning lamp
A (!) (red)
on the instrument panel
is on fi xed (not fl ashing) and that warning
lamp P (red) on control B is on.
Automatic operation
The electric parking brake releases
automatically and progressively when
you press the accelerator. With the
vehicle stationary, the parking brake

is automatically applied when the
engine is switched off .
D R I V I N G

 125  131

Page 21 of 314

I
24M O N I T O R I N G
"Lighting" menu
Once you have selected this menu,
you can:

 Activate/deactivate the lighting
of the daytime running lamps * .

 Activate/deactivate the guide-
me-home lighting and adjust its
duration.

 Activate/deactivate the dual-
function Xenon directional head-
lamps. "Comfort" menu
Once you have selected this menu,
you can:

 Activate/deactivate the driver's
welcome lighting function.

 Select unlocking of all the doors
or just the driver's door.

 Activate/deactivate automatic
operation of the electric parking
brake.
* Depending on country.

Page 27 of 314

I
29
M O N I T O R I N G

Warning lamp is on Cause Action/Observations

Front
foglamps fi xed.
The front foglamps are switched on. Turn the ring on the stalk rearwards
twice to switch off the front foglamps.

Rear
foglamps fi xed.
The rear foglamps are switched on. Turn the ring on the stalk rearwards
to switch off the rear foglamps.

Diesel engine
pre-heating fi xed. The ignition switch is at the
2nd position (ignition on). Wait until the warning lamp has
switched off before starting. The duration for which the warning lamp is
on is determined by the climatic conditions.

Parking
brake fi xed.
The parking brake is applied or not
properly released. Release the parking brake to switch
off the warning lamp, keeping your
foot on the brake pedal.
Observe the safety recommendations.
For further information on the
parking brake, refer to the "Driving"
section.
fl ashing.
The parking brake is not fully applied
or is released.

Passenger's
airbag
system fi xed. The control switch, located in the
glove box, is in the "
ON " position.
The passenger's front airbag is
activated.
In this case, do not install a rear-
facing child seat. Turn the control switch to the "
OFF "
position to deactivate the front
passenger's airbag.
In this case you can install a rear-
facing child seat.
The passenger's airbag system is
automatically put into service on
starting the vehicle (" ON " position).

Page 30 of 314

I
32M O N I T O R I N G

Warning lamp is on Cause Action/Observations


Anti-lock
Braking System (ABS) fi xed.
The anti-lock braking system has a
fault. The vehicle retains conventional
braking.
Drive carefully at reduced speed
and contact a CITROËN dealer
without delay.

Electric
parking brake fl ashing. The electric parking brake is not
applied automatically. You must stop immediately where it
is safe to do so.
Park on level ground, switch off the
ignition and contact a CITROËN
dealer.

Electric
parking brake fault fi xed. The electric parking brake is faulty. Contact a CITROËN dealer without
delay.
The parking brake can be released
manually.
For further information about the
electric parking brake, refer to the
"Driving" section.


Deactivation of
the automatic
functions of the electric parking brake fi xed.
The "automatic application"
(on switching off the engine) and
"automatic release" functions are
deactivated or faulty. Activate the function (according to
country) via the vehicle confi guration
menu or contact a CITROËN dealer.

Page 140 of 314

IX
!
123
D R I V I N G
MANUAL PARKING BRAKE
Mechanical device for immobilising
the vehicle when stationary. This warning lamp comes
on if the parking brake is en-
gaged or not fully released.

If the parking brake is released,
the lighting of this warning lamp
along with the STOP warning lamp
indicates that the brake fl uid level
is low or a malfunction of the brake
force distributor.

It is essential to stop the vehicle.
Consult a CITROËN dealer.
Application

 Pull the parking brake lever up to
immobilise your vehicle.
To facilitate the action on the lever,
you are recommended to press the
brake pedal at the same time.
In all circumstances, as a pre-
cautionary measure, engage
fi rst gear.
On steep gradients, turn the steer-
ing wheel towards the pavement. Release

 Press on the end of the lever
whilst pulling it then lower it fully.

Page 141 of 314

IX!!
124
D R I V I N G
ELECTRIC PARKING BRAKE
The electric parking brake combines
2 operational modes:
- AUTOMATIC
Automatic application when the engine stops and automatic re-
lease on use of the accelerator
(automatic operation by default),
- MANUAL
Manual application/release of the parking brake is always pos-
sible by pulling control A while
pressing the brake pedal. Automatic operation
Application with the engine off
With the vehicle stationary, the park-
ing brake
is automatically applied
when the engine is switched off.
The application of the parking brake
is confi rmed by:
Application with the engine running
With the engine running and the ve-
hicle stationary, in order to immobil-
ise the vehicle you need to manually
apply the parking brake by pulling
on control A .
The application of the parking brake
is confi rmed by:
- the lighting of the warning
lamp on control A and on
the instrument panel,
Before leaving the vehicle,
check that warning lamp P on
the instrument panel is per-
manently lit.
Never leave a child alone inside the
vehicle with the ignition on, as they
could release the parking brake.
-
the display of a message "hand-
brake on" on the instrument panel
screen.
The noise of operation will confi rm
to you the application/release of
your electric parking brake.
- the lighting of warning
lamp P on control A and
on the instrument panel,
-
the display of a message "hand-
brake on" on the instrument panel
screen.
When the driver’s door is opened, a
beep is heard and a message dis-
played if the parking brake has not
been applied.
Before leaving the vehicle,
check that warning lamp P on
the instrument panel is per-
manently lit.

Page 142 of 314

IX!
!
125
D R I V I N G
Release
The electric parking brake releases
automatically and progressively
when you press the accelerator:

 with a manual gearbox (fi rst
gear or reverse gear engaged),
press down fully on the clutch
pedal then press on the accelera-
tor pedal and move off.

 with an automatic gearbox , ac-
celerate with the selector in posi-
tion D , M or R .
Full release of the parking brake is
confi rmed by: - the warning lamp P on
control A and on the in-
strument panel going out,
-
the display of a message "hand-
brake off" on the instrument panel
screen.
When stationary, with the engine
running, do not press the accelera-
tor pedal unnecessarily (particularly
when starting the engine, including
in neutral), as you may release the
parking brake. Activation/Deactivation of
the automatic functions *
Automatic application when switch-
ing off the engine and automatic
release when moving off can be de-
activated. The activation/deactiva-
tion is done in the instrument panel
screen confi guration menu. Select
"Vehicle parameters/Comfort/Auto
handbrake".
Deactivation of these func-
tions is signalled by this
warning lamp in the instru-
ment panel.
With the automatic functions deac-
tivated, the parking brake must be
applied and released manually.
Deactivation of the automatic
functions is recommended in
very cold weather (freezing) and
when towing (recovery, caravan...). Manual operation
Manual application/release of the
parking brake is always possible.
Application
With the vehicle stationary, to apply
the parking brake whether the engine
is running or off,
pull on control A .
The application of the parking brake
is confi rmed by: - the lighting of the warning lamp on control A and of
warning lamp P on the in-
strument panel,
-
the display of a message "hand-
brake on" on the instrument panel
screen.
When the driver’s door is
opened with the engine run-
ning, a beep is heard and a
message displayed if the parking
brake has not been applied.
* Depending on country.

Page 143 of 314

IX!
!
125
D R I V I N G
Release
The electric parking brake releases
automatically and progressively
when you press the accelerator:

 with a manual gearbox (fi rst
gear or reverse gear engaged),
press down fully on the clutch
pedal then press on the accelera-
tor pedal and move off.

 with an automatic gearbox , ac-
celerate with the selector in posi-
tion D , M or R .
Full release of the parking brake is
confi rmed by: - the warning lamp P on
control A and on the in-
strument panel going out,
-
the display of a message "hand-
brake off" on the instrument panel
screen.
When stationary, with the engine
running, do not press the accelera-
tor pedal unnecessarily (particularly
when starting the engine, including
in neutral), as you may release the
parking brake. Activation/Deactivation of
the automatic functions *
Automatic application when switch-
ing off the engine and automatic
release when moving off can be de-
activated. The activation/deactiva-
tion is done in the instrument panel
screen confi guration menu. Select
"Vehicle parameters/Comfort/Auto
handbrake".
Deactivation of these func-
tions is signalled by this
warning lamp in the instru-
ment panel.
With the automatic functions deac-
tivated, the parking brake must be
applied and released manually.
Deactivation of the automatic
functions is recommended in
very cold weather (freezing) and
when towing (recovery, caravan...). Manual operation
Manual application/release of the
parking brake is always possible.
Application
With the vehicle stationary, to apply
the parking brake whether the engine
is running or off,
pull on control A .
The application of the parking brake
is confi rmed by: - the lighting of the warning lamp on control A and of
warning lamp P on the in-
strument panel,
-
the display of a message "hand-
brake on" on the instrument panel
screen.
When the driver’s door is
opened with the engine run-
ning, a beep is heard and a
message displayed if the parking
brake has not been applied.
* Depending on country.

Page:   1-10 11-20 next >