roof CITROEN C5 2009 Owners Manual

4
F A M I L I A R I S A T I O N
E X T E R I O R

Stop & Start
This system puts the engine tempo-
rarily into standby during stops in the
traffi c (red lights, traffi c jams, etc...).
The engine restarts automatically as
soon as you want to move off.
Stop & Start reduces fuel consumption,
exhaust emissions and noise when
stationary.

Lane departure warning system
This driving aid warns you when you
unwittingly cross a lane marking.
Parking sensors
(visual and audible)
This system warns you if an obsta-
cle is detected in front of or behind
the vehicle.
Tyre under-infl ation detection
This system checks the pressure
of the tyres automatically while
driving.

Xenon dual-function directional
headlamps
This system automatically provides
you with extra visibility on bends.
This lighting is linked with the cor-
nering lighting which maximises the
illuminated area at intersections and
when parking.

 140
 90

 153  156  114

Panoramic sunroof (Tourer)
This roof provides you with perfect
brightness in the passenger com-
partment.

Sunroof (Saloon)
This also provides you with im-
proved ventilation in the passenger
compartment.

 82-83

IV
82
A C C E S S
PANORAMIC SUNROOF (SALOON)
Sunroof closed
- Press B to fi rst notch: tilting.
- Press B to second notch: auto-
matic complete tilting.
- Press A to fi rst notch: sliding to-
wards rear.
- Press A to second notch: auto-
matic total sliding towards rear. Sunroof open
- Press
B to fi rst notch: closure.
- Press B to second notch: auto-
matic total closure.
Always remove the ignition key
when leaving the vehicle, even if
for a short time .
In the event of anything being
caught by the sunroof closing, you
must reverse the roof movement.
Do this by reversing the position of
the control switch .
When the driver is operating the
sunroof, they must always make
sure that the passengers are not
preventing it from closing properly.
The driver must ensure that pas-
sengers use the sunroof control
correctly.
Pay special attention to where chil-
dren are when operating the sunroof.
The fi tting of a sunroof as an ac-
cessory is prohibited
Operation
Tilted sunroof
- Press A to fi rst notch: closure.
- Press A to second notch: auto-
matic total closure.
Your sun roof is fi tted with a manually-
operated blind.
Anti-pinch
An anti-pinch device stops the sun
roof from closing, whether sliding or
tilting. If it meets an obstacle, it re-
opens. Reinitialisation
After a battery disconnection or if
there has been a malfunction, you
have to re-initialise the anti-pinch
function.

 move control B until the roof is in
the complete tilting position,

 keep control B pressed down for
a minimum of 1 second.

During these operations, the anti-
pinch function does not operate
.

IV
83
A C C E S S
PANORAMIC SUNROOF (TOURER)
This comprises a tinted glass pan-
oramic area 1 to improve brightness
and vision in the passenger com-
partment.
It is fi tted with an electric blind 2 to
help maintain a comfortable temper-
ature and reduce noise. Opening

 Press control A .
Pressing to the 1st notch allows you
to open the blind step by step.
Pressing to the 2nd notch allows
you to fully open the blind.
The blind stops in the closest pre-
defi ned position (11 positions) as
soon as you release the control.
Closing

 Press control B .
Press to the fi rst notch to close the
blind step by step.
Press to the second notch to close
the blind completely.
The blind stops at the nearest pre-
set position (11 positions) as soon
as you release the control. After a battery disconnection, or if
there has been a malfunction, you
have to re-initialise the anti-pinch
function:

 press control B to the 2nd notch
(fully closed),

 wait until the blind is fully
closed,


press control B for at least 3 seconds.
If the blind opens randomly during a
closing operation, and straight after
the blind stops:

 Press control B until the blind
closes fully.

During these operations, the anti-
pinch function does not operate.
In the event of anything being
caught when the blind is moving,
you must reverse the movement
of the blind. To do so, reverse the
position of the control.
When the driver is operating the
blind, he or she must always make
sure that the passengers are not
preventing it from closing properly.
The driver must ensure that pas-
sengers use the blind correctly.
Pay particular attention to children
when operating the blind .
Anti-pinch
If the blind meets an obstacle whilst
closing, it stops and opens partially
again.
You must re-initialise the anti-pinch
function within 5 seconds of the
blind stopping:

 press control B until the blind is
fully closed (closing in steps of a
few centimetres).
SEQUENTIAL ELECTRIC BLIND

XI
188
P R A C T I C A L I N F O R M A T I O N
Interior lamps
Roof lamps

 Unclip the transparent cover of
the roof lamp to reach the bulb.

Bulb: W 5 W
Rear reading lamps (Tourer)

 Detach the cover of the reading
lamp to access the bulb.

Bulb: W 5 W
Map reading lamp

 Detach the cover.

 If necessary, detach the partition
of the affected map reading lamp. Boot lamp

 Detach the cover and use a W 5W
bulb.
Pavement lighting

 Detach the cover and use a W 5W
bulb. Floor lighting

 Detach the cover and use a W 5W
bulb.
Glovebox

 Detach the cover and use a W 5W
bulb.

XI
!
199
P R A C T I C A L I N F O R M A T I O N
ROOF BARS
The design of your vehicle requires
the use of roof bars that are tested
and approved by CITROËN, for your
safety and to avoid damage to the
roof and tailgate.
Regardless of the type of loading
equipment to be transported on the
roof (bicycle carrier, ski carrier...), it
is imperative that you add transverse
roof bars. Any securing or lashing to
components other than the roof bars
is strictly prohibited.
Recommendations

 Distribute your load evenly, avoid-
ing overloading on one side.

 Arrange the heaviest part of the
load as close as possible to the
roof.

 Anchor the load securely and
draw attention to it if any part of
it is overhanging.

 Drive gently, as the vehicle will
be more liable to the effects of
side winds (vehicle stability may
be altered).

 Remove the roof bars as soon
as they are no longer needed. Maximum load that can be
distributed on the roof bars
(for a loading height not ex-
ceeding 40 cm; except bicycle car-
rier): 80 kg.
If the height exceeds 40 cm, adapt
your speed to the profi le of the road
to avoid damaging the roof bars
and the fi xings on the roof.
Please refer to national legislation
in order to comply with the regula-
tions concerning the transportation
of objects which are longer than
the vehicle.
Blanking cover
When towing, you must remove the
blanking cover in the front bumper
as well as the bonnet seal if fi tted.
Contact a CITROËN dealer for this.