service CITROEN C5 2009 Owners Manual

Page 40 of 336

I
39
M O N I T O R I N G
Engine oil temperature gauge
Under normal operating conditions,
the bars should be within section
1 .
In severe operating conditions, the
bars may extend into section 2 .
In this event, slow down, and if neces-
sary, stop the engine and check the
levels (see corresponding chapter). Coolant temperature
indicator
Under normal operating conditions,
the bars should be within section
1 .
In severe operating conditions, the
bars may extend into section 2 , the
engine coolant temperature warning
lamp A and the STOP warning lamp
will light up, stop immediately .
Switch off the ignition. The cooling
fan may continue to operate for a
certain time .
Consult a CITROËN dealer.
If the SERVICE warning lamp lights
up, check the levels (see correspond-
ing chapter). On horizontal ground, the lighting of
the fuel low warning lamp warns you
that you are at the reserve level.
A message alert is displayed on the
instrument panel.

Fuel gauge indicator

Page 133 of 336

VIII
114
S A F E T Y
TYRE UNDER-INFLATION DETECTION
System which automatically checks the
pressures of the tyres while driving. Tyres OK display
Choice of detection
This function provides warning of tyres
that are under-infl ated or punctured.
Automatic detection
Sensors monitor the tyre pressures.
In the event of an anomaly, a mes-
sage will appear on the instrument
panel screen.
Driver request detection
You can check the tyre pressures at
any time.

 Press on button A (CHECK); the
information will be displayed on
the instrument panel screen.
 Press on button A (CHECK).
The system indicates to you that the
tyres are correctly infl ated.
This information is only available on
the request by the driver. Under-inflated tyre

automatic detection

detection on request
Automatic detection:
A message indicates which tyre is
under-infl ated.
Driver request detection:
The vehicle outline indicates the un-
der-infl ated tyre(s).
The message is accompanied by
lighting of the SERVICE warning
lamp and an audible beep.

 Check the tyre pressures as
soon as possible.

Page 134 of 336

VIII
115
S A F E T Y
Punctured tyre

automatic detection

detection on request
Automatic detection:
A message indicates which tyre is
punctured.
Driver request detection:
The vehicle outline indicates the
punctured tyre(s).
The message is accompanied by
lighting of the STOP warning lamp
and an audible beep. Wheel not monitored

automatic detection

detection on request
Automatic detection:
A message indicates to you which
wheel is not monitored. Driver request detection:
The vehicle outline indicates the
wheel(s) which is/are not monitored.

 The message is accompanied by
lighting of the SERVICE warn-
ing lamp and an audible beep.
Consult a CITROËN dealer.

 If you have fi tted wheels that
are not equipped with tyre defl a-
tion detection (wheels with snow
tyres, etc.), contact a CITROËN
dealer.
The defl ation detection system is a
driving aid, but which does not ab-
solve the driver from the need to be
vigilant and responsible.
This system does not dispense
with the requirement to check
the tyres on a regular basis (see
"Identifi cation markings") to ensure
optimum vehicle behaviour and to
avoid premature tyre wear under
certain conditions (high load, high
speed).
Do not forget to check the tyre
pressure of the spare wheel .
Any repair or replacement of a tyre
on a wheel that is equipped with
a sensor must be carried out by a
CITROËN dealer .
The system may suffer from tem-
porary interference caused by radio
transmissions on neighbouring fre-
quencies .

Page 171 of 336

IX
150
D R I V I N G
In the event of a steep descent or
under excessive acceleration, the
speed limiter (which does not act
on the brakes) may not be able to
prevent the vehicle from exceeding
the programmed speed.
Use of a fl oor mat other than that
recommended by CITROËN may
affect the normal operation of the
accelerator pedal and hamper the
operation of the speed limiter.
Floor mats approved by CITROËN
are fi tted with a 3rd fi xing located in
the pedal area to avoid any risk of
interference with the pedals.
Suspension/Resumption

 Press on button 3 .
This action causes the information

"PAUSE" to appear in zone A of the
instrument panel.
This action does not cancel the
memorised maximum speed which
remains displayed in zone A of the
instrument panel. Overriding the programmed
speed
The accelerator pedal has an end-
of-travel switch. In order to exceed
the memorised maximum speed at
any time, you can press the pedal
all the way down. While the speed
is being exceeded, the speed dis-
played in zone
A will fl ash. You have
only to release the accelerator pedal
to return below the maximum speed,
to restore the function.
The speed will also fl ash if the speed
limiter is not able to prevent the vehi-
cle from exceeding the programmed
speed (e.g. on a steep descent or
under excessive acceleration).
To reactivate the speed limiter, re-
lease the accelerator to slow to a
speed lower than the programmed
speed. Return to normal driving

 Either press on button 5 .


Or select the speed limiter function.

 Or stop the engine.
Operating fault
If there is a malfunction, a mes-
sage is displayed accompanied by
an audible signal and lighting of the

SERVICE warning lamp.
Have it checked by a CITROËN
dealer.

Page 173 of 336

IX
!
152
D R I V I N G
Cruise control must only be
used wh e re the traffi c condi-
tions permit driving at a con-
stant speed .
Do not use it on congested
roads or when the weather or the
road conditions are poor .
The driver must remain attentive
and in complete control of the ve-
hicle .
You are recommended to keep your
feet within range of the pedals .
Overriding the programmed
speed
While cruise control is in operation,
it is always possible to go above the
programmed speed simply by press-
ing the accelerator pedal (for exam-
ple to overtake another vehicle).
The speed displayed in zone
A
fl ashes.
You only have to release the ac-
celerator pedal to return to the pro-
grammed speed.
Suspension/Resumption

 Either by pressing the brake
pedal or the clutch pedal.

 Or by pressing button 3 .

 Or by the ESP or ASR systems
being active.
For vehicles with a manual gearbox,
cruise control is deactivated if the
gear lever is in neutral. Reactivation
-
By recalling the memorised
speed
After deactivation, press button 3 .
Your vehicle automatically returns
to the memorised cruising speed.
The memorised speed and "ON"
are displayed in zone A .
If the memorised cruising speed is higher than the current speed,
the vehicle will accelerate strong-
ly to reach the current speed.
- By selecting the current speed
Press button 1 or 2 once the de-
sired speed has been reached.
The new speed and "ON" will
appear in zone A .
Return to normal driving

 Either press on button 5 .


Or select the cruise control function.

 Or stop the engine.
The speed that was chosen is no
longer memorised.

"PAUSE" will be displayed in zone A
of the instrument panel.
These actions do not cancel the
cruising speed which remains dis-
played on the instrument panel. Operating fault

If there is a malfunction, a mes-
sage is displayed accompanied by
an audible signal and lighting of the

SERVICE warning lamp.
Have it checked by a CITROËN
dealer.