display Citroen C5 DAG 2007.5 (DC/DE) / 1.G Owner's Guide

66
II
3
5
4
2
1
C R U I S E C O N T R O L
To cancel the functionPress on button 5.
Select the cruise control func-tion.Or stop the engine.
The speed that was chosen is no longer memorised.
If there is a malfunction, a mes-sage is displayed accompanied by a sound signal and lighting of the SERVICE warning lamp.
Contact a CITROËN dealer.

67
II
3
5
4
2
1
A
S P E E D L I M I T E R
This driving aid allows you to choose a maximum speed that you do not wish to exceed. This has to be over 30 km/h (19 mph).
The speed limiter controls are located on the steering wheel.Note: The speed limiter informa-tion is displayed in zone A of the instrument panel.
To select the function
Press on button 4 to select speed limiter mode “LIMIT”.
The selection is confi rmed by the display of the function in zone A of the instrument panel.
To adjust the maximum speed
With the engine running, you can adjust the memorised maximum speed, displayed in zone A, by pressing on:Button 1 to increase the memo-rised maximum speed.
Button 2 to decrease the mem-orised maximum speed.
Remark: Successive presses will modify the cruise speed in steps of 1 km/h and a continuous press in steps of 5 km/h (3 mph).

68
II
3
5
4
2
1
A
S P E E D L I M I T E R
Suspension or resumption of maximum speed
Press on button 3.
Temporary override of the maximum speed
The accelerator pedal has an end-of-travel switch. In order to exceed the memorised maximum speed at any time, you can press the pedal all the way down. While the speed is being exceeded, the speed dis-played in zone A will fl ash. You have only to release the accelera-tor pedal to return below the maxi-mum speed, to restore the func-tion.
Remark: the speed will also fl ash if the speed limiter is not able to prevent the vehicle from exceeding the programmed speed (e.g. on a steep descent or under excessive acceleration).
To reactivate the speed limiter, release the accelerator to slow to a speed lower than the programmed speed.
To cancel the functionPress on button 5.Select the speed limiter func-tion.
Or stop the engine.
The speed that was chosen is no longer memorised.
If there is a malfunction, a mes-sage is displayed accompanied by a sound signal and lighting of the SERVICE warning lamp.
Contact a CITROËN dealer.

69
II
A
Defl ation detection
This function warns you of tyres that are defl ated or punctured.
Automatic detection
Sensors monitor the tyre pressures while driving. In the event of a n anom-aly, a message will appear on the instrument panel screen.
Driver request detection
You can check the tyre pressures at any given moment. To do so, press on button A (CHECK) ; the information will be displayed on the instrument panel screen.
Display of tyres in good condition
Automatic detection:
A message indicates to you which tyre is defl ated.
Driver request detection:
The vehicle outline indicates the defl ated tyre(s).
T Y R E D E F L A T I O N D E T E C T I O N
Tyre defl ation alert
The system indicates to you that the tyres are correctly infl ated.
This information is only available on the request of the driver.
Press on Check
Press on CheckAutomatic detection
The message is accompanied by the SERVICE warning lamp lighting up and a beep.
Check the tyre pressures as soon as possible.

73
II
A U T O M A T I C G E A R B O X
The engine can only be started when the lever is at position P or N.
A safety device ensures that starting is impossible in the other positions.
Once the engine has been started, with the gear lever at P, press on the brake pedal then place the lever at:D for automatic mode.
R for reverse gear.M to change to manual mode.
The change from position D (driving in automatic mode) to position M (driv-ing in sequential mode) or vice versa can be made at any time.
The gear selected is displayed on the instrument panel.

75
II
A
B
A U T O M A T I C G E A R B O X
Operation in SPORT or SNOW automatic mode
Lever at D:
Press on button A to select the SPORT driving mode.
Press on button B to select the SNOW driving mode.
Pressing again on button A or B returns you to NORMAL driving mode.
NORMAL mode is selected by default when the engine is started. This driving mode is suitable for normal driving conditions.
No warning lamp will light up in the instrument panel.
SNOW mode facilitates starting and smooth driving when road adherence conditions are poor.
The instrument panel display lights up.
SPORT mode is for more responsive driving, to provide maximum performance and acceleration.
The instrument panel display lights up.
Remark: The driving mode selected before you switched off the engin e will be retained the next time you start up.
If there is an operating fault, the gearbox is stuck in a gear, do not exceed 100 km/h (approx. 60 mph).
Juddering may be felt when selecting R for reverse gear or when returning to position D.
Consult a CITROËN dealer as soon as possible.
Do not stop your engine if the gear selector lever is in position D or R.

78
II
A
E L E C T R I C P A R K I N G B R A K E
ACTIVATION/DEACTIVATION OF THE AUTOMATIC FUNC-TIONS
The automatic application when the engine is switched off and the automatic release when you press the accelerator can be deacti-vated. Activation / deactivation is performed using the “Main Menu” of the instrument panel screen. To do so, select “Vehicle param-eters / Comfort / Automatic parking brake”.
The deactivation of these functions is confi rmed by the lighting of this warning lamp on the instrument panel.
With the automatic functions deacti-vated, the application and release of the parking brake are done manu-ally.
MANUAL OPERATION
Manual application / release of the parking brake is always possible.
To start the vehicle
With the ignition on or the engine running, to release the parking brake, press on the brake or accel-erator pedal, push then releasecontrol A.
The application of the parking brake is confi rmed by:The lighting of the warning lamp on control A and of the warning lamp on the instru-ment panel.
The display of the message “Parking brake applied” on the instrument panel screen.
When the driver’s door is opened, a beep is heard and a message displayed if the parking brake has not been applied.

79
II
E L E C T R I C P A R K I N G B R A K E
S P E C I A L F E A T U R E S
MAXIMUM APPLICATION
If necessary, you can utilise maximum application of the parking brake. It is obtained by means of a long pull on control A, until you see the message “Maximum parking brake application” and a beep is heard.
Maximum application is indispensable:In the case of a vehicle towing a caravan or a trailer, if the automatic functions are activated but you are applying the parking brake manually.
When the gradient you are parked on is variable in its effect (e.g. on a ferry, in a lorry, during towing).Note:In the case of towing, a loaded vehicle or parking on a gradient, turn the front wheels towards the pavement and engage a gear when you park.
After maximum application, the release time will be longer.
PARTICULAR SITUATIONS
In certain situations (starting the engine, etc), the parking brake can automatically alter its force. This is normal opera-tion.
To advance your vehicle a few centimetres without starting the engine, but with the ignition on, press on the brake pedal and release the parking brake by pushing then releasing control A.
The full release of the parking brake is confi rmed by the extinction of the warning lamp on control A, and of the warn-ing lamp on the instrument panel, and by the display of the message “Parking brake released” on the instrument panel screen.
If the parking brake malfunctions while applied or if the battery runs fl at, an emergency release is always possib le (see paragraph “Emergency unlocking”).

80
II
A
E L E C T R I C P A R K I N G B R A K E
D Y N A M I C E M E R G E N C Y B R A K I N G
Dynamic emergency braking
In the event of a failure of the vehicle’s main braking system or in an excep-tional situation (e.g. driver taken ill, under instruction, etc) a continuous pull on control A will stop the vehicle.
The electronic stability programme (ESP) provides stability during dynami c emergency braking.
If the dynamic emergency braking malfunctions, one of the following mes-sages will be displayed on the instrument panel screen:“Parking brake faulty”.
“Parking brake control faulty”.

82
II
E L E C T R I C P A R K I N G B R A K E
O P E R A T I N G A N O M A L I E S
SituationCONSEQUENCES
1Electronic parking brake fault and display of message “Parking brake faulty” and the following warning lamps:If the electronic parking brake fault warning lamp and the service warning lamp light up, position the vehicle in a safe location (on fl at ground, with a gear engaged).
2Display of the messages “Parking brake faulty” and “Anti-roll-back system faulty”, and the following warning lamps:The automatic functions are deactivated.The hill start assist is unavailable.The electronic parking brake is only available manually.