towing Citroen C5 DAG 2007.5 (DC/DE) / 1.G Owner's Manual

Page 75 of 231

79
II
E L E C T R I C P A R K I N G B R A K E
S P E C I A L F E A T U R E S
MAXIMUM APPLICATION
If necessary, you can utilise maximum application of the parking brake. It is obtained by means of a long pull on control A, until you see the message “Maximum parking brake application” and a beep is heard.
Maximum application is indispensable:In the case of a vehicle towing a caravan or a trailer, if the automatic functions are activated but you are applying the parking brake manually.
When the gradient you are parked on is variable in its effect (e.g. on a ferry, in a lorry, during towing).Note:In the case of towing, a loaded vehicle or parking on a gradient, turn the front wheels towards the pavement and engage a gear when you park.
After maximum application, the release time will be longer.
PARTICULAR SITUATIONS
In certain situations (starting the engine, etc), the parking brake can automatically alter its force. This is normal opera-tion.
To advance your vehicle a few centimetres without starting the engine, but with the ignition on, press on the brake pedal and release the parking brake by pushing then releasing control A.
The full release of the parking brake is confi rmed by the extinction of the warning lamp on control A, and of the warn-ing lamp on the instrument panel, and by the display of the message “Parking brake released” on the instrument panel screen.
If the parking brake malfunctions while applied or if the battery runs fl at, an emergency release is always possib le (see paragraph “Emergency unlocking”).

Page 87 of 231

91
II
A
P A R K I N G A S S I S T A N C E
Activation/Deactivation
You can activate/deactivate the parking assistance by pressing button A. When the parking assist-ance is inactive, the warning lamp on button A is lit up.
Activation/deactivation of the park-ing assistance is memorised when you stop the vehicle.
Remark: If you are towing with a towing device not approvedby CITROËN, it is necessary to a towing device ing denot approved
deactivate parking assistance by pressing on button A. The warn-ing lamp on the button lights up.
Operation
When you engage reverse gear, a sound signal confi rms to you that the system is active. The out-line of your vehicle appears on the screen. Any obstacles located to the rear or to the front of the vehi-cle can be detected.
When going forward and at a speed below approx. 10 km/h (6 mph), whether in neutral or in gear, the outline of the vehicle appears on the display as soon as an obstacle is detected in front of the vehicle. Obstacles located in front of the vehicle will be detected.
Remarks:The proximity sensors cannot detect objects that are immedi-ately under or over the bump-ers.
A thin object such as a spike, a bollard or similar, can only be detected at the start of the manœuvre but not when the vehicle arrives close up to it.In poor weather or in winter, you need to ensure that the sensors are not covered with mud or with ice or snow.

Page 93 of 231

97
III
A U T O M A T I C A I R C O N D I T I O N I N G
G E N E R A L
You are advised to use the automatic air conditioning regulation. This automatically regulates the following functions for maximum comfort : air fl ow, passenger compartment temperature, and air distribution, using different sensors (external temperature, sunlight). This avoids the need to alter any of the settings, with the exception of the temperature displayed.
Take care not to obstruct the sunlight sensor A.
Provided you retain automatic mode (by pressing button “AUTO”) and all the air vents are open, you will main-tain an optimum comfort level, also removing humidity and misting, whatever the ambient climatic conditions.
The temperature inside the cabin cannot be lower than the temperature outside if the air conditioning is not operating.
To be effective, the air conditioning should only be used with the windows closed. If after a lengthy stop in bright sunlight the interior temperature is excessive, air the passenger compartment by opening the windows for a few moments, then close them again.
To ensure the correct operation of the air conditioning system, it is essential to operate the air conditioning at least once a month.
The air conditioning operates by using power from the engine. This results in a slight increase in fuel con-sumption.
In certain extreme operating conditions (e.g. carrying a full load up a steep gradient in high temperatures), the switching off of the air conditioning allows more power to be transferred to the engine, thereby increasing the towing capacity.
Air inlet
Check that the exterior grille for the air inlet, at the bot-tom of the windscreen, is clean and free of dead leaves, snow, etc.
If washing the vehicle with a high pressure jet, avoid targeting the air inlet zone.
Air circulation
For your comfort we advise you to maintain a proper distribution of air within the cabin, both at the front and at the rear.
To obtain an even distribution of air, ensure that you do obstruct the external air inlet grille located at the base of the windscreen, the air vents, the air outlets on the fl oor underneath the front seats, and the air extractor located behind the fl aps in the boot.
The front and rear air vents are fi tted with control knobs which allow you to control and direct the air fl ow. It is recommended to keep all the air vents open.
Dust/pollen fi lter
There is a fi lter for excluding pollen and dust.
This fi lter has to be changed according to the vehicle maintenance schedule. See “Maintenance Guide”.

Page 165 of 231

169
VI
S A F E T Y R E C O M M E N D A T I O N S
It is essential to install a CITROËN approved electronic unit when having a towbar fi tted, in order to prevent any risk of malfunction or damage (risk of fi re).
If you are towing another vehicle, the latter must be free-wheeling (gearbox in neutral).
Do not exceed the maximum permitted load.
For the maximum distributed load on the roof bars: see the chapter “General”.
Towing (Boat, caravan, etc.)
If you are climbing a steep gradient and the engine gets excessively hot, certain functions become unavailable (e.g. sequential control of the automatic gearbox, the air conditioning).
If you are towing with a device not approved by the CITROËN network, you must deactivate parking assistance usi ng the button on the dashboard. See “Parking assistance”.
It is recommended that you remove the towing ball, so that it does not interfere with the functioning of the prox-imity sensors, when you are not using a trailer.
Roof bars
For your safety and to avoid damage to the roof, you should use roof bars that are tested and approved by AUTOMOBILES CITROËN for the design of your par-should use roof bars that are tested and approved by bars that are
ticular vehicle.
Recommendations:Spread the load evenly, avoiding overloading on one side.
Position the heaviest weight as low down as pos-sible.Tie the load down securely and add warning signs if it is protruding.
Drive conservatively, as the vehicle will be more vul-nerable to side winds.
The stability of your vehicle may be altered.Remove the roof rack or roof bars when you are not using them.

Page 167 of 231

171
VI
3
6
7
1
2
4
5
C H A N G I N G A W H E E L
Access to the spare wheel
To access the spare wheel1. Lift up the boot fl oor using the fi rst strap.2. Fold back the boot carpet.3. Attach the second strap to the upper section of the boot.4. To remove the spare wheel, detach the strap then push the wheel forwards so as to be able to lift it.
Tools
The tools are to be found in a pro-tective holder inside the spare wheel. Pull back the retaining strap to have access.1. Handle2. Jack3. Tool for the removal/refi tting of bolt protectors4. Centring guide5. Handle extension6. Towing eye7. Movable chock
To reposition the spare wheel
To put the spare wheel back in the boot1. Position the spare wheel fl at in the boot, then pull it towards you.2. Next place the toolbox inside the wheel, then secure the assembly with the belt.3. Release the strap to return the boot fl oor to its initial position.
Tyre pressures
The tyre pressure is indicated on the label located on the left-hand door centre pillar. See “Vehicle identifi cation” and “User Precau-tions”. On this label, the pressures are specifi ed depending on the vehicle speed and load.

Page 170 of 231

174
VI
T O W I N G – L I F T I N G
TOWING WITH WHEELS ON THE GROUND
Towing eye fi xings are located at the front and at the rear of the vehicle.
Detach the cover:For the front cover, lever with a screwdriver at the top of the cover.
For the rear cover, press on the right hand side.
The ignition key must be in position M to retain steering.
Use a bar with attachments to the towing eyes as above.
The towing eye is removable, to be stowed in the jack protect ion box inside the spare wheel.

Page 173 of 231

177
VII
HDi 110BVM FAPHDi 138BVM FAPHDi 138BVA FAPHDi 173BVM FAPV6 HDi 208BVA FAP
Approximately 71 litres
Diesel fuel
-----
80100100125150
12121212,212,2
-----
15031608165817291766
20402155219022162310
9609709709801045
31403755349038163710
1100
(1370*)
1600
(1820*)
1300
(1560*)
1600
(1820*)
1400
(1690*)
11001800130018001400
750
5573637368
80
G E N E R A L
MTAC: Gross vehicle weight.
MTRA: Gross train weight.
Weights: Refer to the manufacturer's plate.
(*) Weight transfer: The braked tow-ing weight can be increased.
It is possible, when the towing vehi-cle is within the gross vehicle weight, to transfer weight allowance from the trailer.
In all cases, do not exceed the trailer and Gross Train Weight values indi-cated.
(1) In the case of a towing vehicle, the maximum speed is limited to 100 km/h (62 mph).
Observe your vehicle's towing lim-its. It is essential to comply with the max. Gross Trailer Weights and speed limits as specifi ed by legislation in each country.
Chainable tyres: All tyres are chain-able, except 18” or 19”.
For Belgium and Switzerland: See homologation documents.