buttons Citroen C5 RHD 2011.5 (RD/TD) / 2.G Owner's Manual

Page 4 of 340

CONTENTS
Monochrome screen C 43
16/9 colour screen (MyWay) 45
16/9 high defi nition colour screen
(NaviDrive 3D) 47„


II - MULTIFUNCTION
SCREENS 43 Î 48
Ventilation 49
Mono-zone digital
air conditioning 51
Dual-zone digital
air conditioning 54
Programmable heating 58
Front seats 62
Rear seats 66
Mirrors 67
Steering wheel adjustment 68„







III - COMFORT 49 Î 68
Remote control key 69
Alarm 75
Electric windows 77
Doors 79
Boot 81
Sunroof (Saloon) 84
Panoramic sunroof (Tourer) 85
Fuel tank 86
Misfuel prevention (Diesel) 87„








IV - ACCESS 69 Î 87
Lighting controls 88Automatic illumination of headlamps 90
Headlamp adjustment 91
Directional lighting 92
Wiper controls 94
Automatic rain sensitive
windscreen wipers 95
Courtesy lamps 96
Interior mood lighting 98„







V - VISIBILITY 88 Î 99
Interior fi ttings 100
Mats 101
Front armrest 101
Boot fi ttings 103„



VI - FITTINGS 100 Î 106
Instrument panels 26
Trip computer 29
Warning and indicator lamps 32
Adjustment buttons 42„



FAMILIARISATION 4 Î 23
I - MONITORING
26 Î 42
Child seats 107
ISOFIX child seats 111
Child lock 115„


VII - CHILD SAFETY 107 Î 11 5












































ECO-DRIVING 24 Î 25

Page 12 of 340

10
FAMILIARISATION
INSTRUMENTS AND CONTROLS

Audio. Instrument panel menu. Multifunction screen menu.
Telephone. Cruise control and speed
limiter.

The " SET +, PAUSE, VOL+,
and MUTE
" buttons have touch identifi cation to
make them easier to use. Activation of voice
recognition or reminder of
navigation guidance. MODE: selection of the type
of information displayed in
the multifunction screen.



150-151

Page 44 of 340

I
42
MONITORING












Total distance recorder

System which measures the total
distance travelled by the vehicle
during its life.
The total and trip distances are dis-
played for thirty seconds when the
ignition is switched off, when the
driver's door is opened and when
the vehicle is locked or unlocked.

In order to observe legislation,
change the units of distance (miles
or km) to those for the country you
are passing through, using the con-
fi guration menu.











Lighting dimmer

System for manual adjustment of
the brightness of the instruments
and controls in relation to the exte-
rior brightness.

Operation


)
Press button A
to decrease the
brightness of the instruments
and controls.

)
Press button B
to increase the
brightness of the instruments
and controls.

Deactivation
When the lighting is off, or in day
mode on vehicles fi tted with daytime
running lamps, pressing the buttons
does not have any effect.



Trip distance recorder

System which measures a distance
travelled during a day or other pe-
riod since it was reset to zero by the
driver.


)
With the ignition on, press the
button until zeros appear.

Page 60 of 340

III
58
COMFORT
PROGRAMMABLE HEATING

The programmable heating operates
independently of the engine.
When the engine is off, it pre-heats
the coolant circuit in order to benefi t
from an optimum engine operating
temperature from the time the en-
gine is switched on.
The programmable heating system
is switched on using the long range
remote control. Activation can be im-
mediate or deferred by means of a
programming function.

Programming remote control

The heating system programming
remote control consists of the fol-
lowing buttons and displays:


1.
Scrolling functions menu buttons.

2.
Function indicator lights: clock,
temperature, operating time, pro-
grammed time, heater operation,
heating management symbols.

3.
Digital displays: time, tempera-
ture, duration of operation, pro-
grammed time or level of heating.

4.
Off button.

5.
On button.



Displays on the remote
control screen

Press the buttons 1
in succession to
display the functions.
The fi rst press of the left-hand or
right-hand button displays the time.
Next, the left-hand button permits ac-
cess to the programming time then to
the level of heating (C1 to C5).
The right-hand button permits ac-
cess to the passenger compartment
temperature then to the duration of
operation of the heater if it is to be
switched on immediately.

If a malfunction of the program-
mable heating system occurs,
contact a CITROËN dealer.



Displaying the functions

The passenger compartment
temperature information is only
available when the engine is off.

Page 61 of 340

III
59
COMFORT

Setting the time

Once the time has been displayed,
by means of the buttons 1
, press
buttons 4
and 5
simultaneously with-
in 10 seconds.

Immediate activation

Press button 5
(ON) until the mes-
sage "OK"
appears.
When the signal has been received,
the message "OK"
is displayed
along with the duration of operation. Press the buttons 1
to display the
duration of operation.
This symbol fl ashes.
Set the time using the buttons 1
.
Press buttons 4
and 5
simultaneously
to save it.
This symbol is displayed (fi xed).

The heater starts and this
symbol is displayed.
To deactivate the function, press
button 4
(OFF) until the message
"OK"
appears.
This symbol is switched off.
When carrying out these opera-
tions, if the message "FAIL"
ap-
pears, the signal has not been
received. Repeat the procedure
after changing your location.


Setting the duration
of operation
This symbol is displayed.
Once the duration of operation has
been displayed, press buttons 4
and
5
simultaneously within 10 seconds.
This symbol fl ashes.
Set the duration by pressing the
buttons 1
(adjustment in steps of
10 mins and max value 30 mins).
Press buttons 4
and 5
simultaneously
to save the duration of operation.
This symbol is displayed (fi xed).

The factory setting value is 30 minutes.

Page 62 of 340

III
60
COMFORT

Programming the heating

You must programme your depar-
ture time in order for the system to
calculate the optimum heater start
time automatically.

Programming the departure time
Press the buttons 1
to display the
programming time.
Activation - deactivation
Once the programming time has
been displayed by means of the but-
tons 1
, press button 5
(ON) until the
message "OK"
appears.
This symbol is displayed.
Once the programming time has
been displayed, press buttons 4
and
5
simultaneously within 10 seconds.
This symbol fl ashes.
Set the time by pressing the buttons 1

and press buttons 4
and 5
simultane-
ously to save it.
This symbol is displayed (fi xed).

This symbol is displayed when
the heater starts.
HTM: Heat Thermo Management.

When the signal has been received,
the message "OK"
is displayed along
with the symbol "HTM"
.

To deactivate the programming,
press button 4
(OFF) until the mes-
sage "OK"
appears.

The symbol "HTM"
is switched off.

When carrying out these opera-
tions, if the message "FAIL"
ap-
pears, the signal has not been
received. Repeat the procedure
after changing your location.
Switching off the heating
Press button 5
(ON).

The symbol "HTM"
remains on.


Changing the level of heating
The system offers 5 levels
of heat-
ing (from the lowest level C1
to the
highest level C5
).
Once the level of heating has been
displayed by means of the buttons 1
,
press buttons 4
and 5
simultaneously.
The letter "C"
fl ashes.
Set the level of heating by pressing
the buttons 1
.
Press buttons 4
and 5
simultane-
ously to save the level selected. The
letter "C"
is displayed (fi xed).
The factory pre-sets are replaced
by the new settings entered. The
programmed times are stored until
the next time they are changed.
When the departure time is acti-
vated, the level of heating cannot
be changed. The departure time
must be deactivated fi rst.

Page 67 of 340

III
65
COMFORT












Storing driving positions

System which stores the settings of
the driver's seat and air conditioning.
Up to two positions can be stored
using the buttons on the side of the
driver's seat.
Storing a position

Using buttons M/1/2


)
Switch on the ignition.

)
Adjust your seat.

)
Press button M
, then press but-
ton 1
or 2
within four seconds.
An audible signal confi rms that the
settings have been stored.
Storing a new position cancels the
previous position.

Recalling a stored position

Ignition on or engine running


)
Briefl y press button 1
or 2
to re-
call the corresponding position.
An audible signal indicates the end
of the adjustment.
When the ignition is on, after a few
consecutive position recalls, the
function will be deactivated until the
engine is started, to prevent dis-
charging of the battery.
For your safety, avoid storing a
driving position while driving.









REAR HEAD RESTRAINTS

The rear head restraints can be
removed and have two positions:


- high, position for use,

- low, storage position.
To raise a head restraint, pull it up-
wards.
To lower it, press the lug then the
head restraint.
To remove it, place it in the high posi-
tion, push the lug and pull it upwards.
To r efi t it, engage the head restraint
rods in the holes taking care to re-
main in line with the seat back.
Never drive with the head restraints
removed, they must be in place and
correctly adjusted.

Page 76 of 340

IV
74
ACCESS














Lost keys

Visit a CITROËN dealer with the vehi-cle's V5 registration document and your personal identifi cation documents.
The CITROËN dealer will be able to
retrieve the key code and the transpon-
der code required to order a replace-
ment key.


Remote control

The high frequency remote control is
a sensitive system; do not operate it
while it is in your pocket as there is a
possibility that it may unlock the ve-
hicle, without you being aware of it.
Do not repeatedly press the buttons
of your remote control out of range
and out of sight of your vehicle. You
run the risk of stopping it from work-
ing and the remote control would
have to be reinitialised.
The remote control does not operate
when the key is in the ignition, even
when the ignition is switched off,
except for reinitialisation.


Locking the vehicle

Driving with the doors locked may
make access to the passenger com-
partment by the emergency services
more diffi cult in an emergency.
As a safety precaution (with children
on board), remove the key from the
ignition when you leave the vehicle,
even for a short time.


Anti-theft protection

Do not make any modifi cations to the
electronic engine immobiliser sys-
tem; this could cause malfunctions.


When purchasing
a second-hand vehicle
Have the key codes memorised by a
CITROËN dealer, to ensure that the
keys in your possession are the only
ones which can start the vehicle.









Do not throw the remote con-
trol batteries away, they contain
metals which are harmful to the
environment.
Take them to an approved collection
point.

Page 100 of 340

V
98
VISIBILITY











INTERIOR MOOD LIGHTING

Your vehicle is equipped with interior
mood lighting for the centre console
and the door handles.

Central console

The lamps are located on the roof
console, near the front interior lamp.
They illuminate the central console.

Lighting for door opening
controls

Operation
These lamps are activated with the
automatic illumination of headlamps,
when the ambient light is poor. They
are deactivated when the instrument
panel is off.
The intensity of the lighting varies
along with that of the instrument
panel.


)
Press buttons A
to increase or re-
duce the intensity of the lighting.

This is located on the front and rear
interior door opening controls.
The rear door opening controls light-
ing is deactivated if the child lock
is on.

Page 253 of 340

251
06
11
2
RADIONAV ESC TRAFFICRADIO
MEDIA
2ABC3DEF5JKL4GHI6MNO8TUV7PQRS9WXYZ0*#
1RADIO MEDIANAV ESC TRAFFIC
SETUPADDR
BOOK
RADIO
2ABC3DEF5JKL4GHI6MNO8TUV7PQRS9WXYZ0*#
1RADIO MEDIANAV ESC TRAFFIC
SETUPADDR
BOOK
2ABC3DEF5JKL4GHI6MNO8TUV7PQRS9WXYZ0*#
1RADIO MEDIANAV ESC TRAFFIC
SETUPADDR
BOOK
2ABC3DEF5JKL4GHI6MNO8TUV7PQRS9WXYZ0*#
1RADIO MEDIANAV ESC TRAFFIC
SETUPADDR
BOOK
2ABC3DEF5JKL4GHI6MNO8TUV7PQRS9WXYZ0*#
1RADIO MEDIANAV ESC TRAFFIC
SETUPADDR
BOOK

SELECTING A STATION


When the current radio station is
displayed on the screen, press OK.

The radio source short-cuts menu appears and provides access to
the following short-cuts:

Select the function required and
press OK to confi rm to gain access
to the corresponding settings.
TA


RDS, if displayed, allows you to continue listening to the same
station by automatic retuning to alternative frequencies. However,
in certain conditions, coverage of an RDS station may not be
assured throughout the country as radio stations do not cover
100 % of the territory. This explains the loss of reception of the
station during a journey.





The external environment (hill, building, tunnel, underground car park...)
may interfere with the reception, including in RDS following mode. This
phenomenon is a normal result of the way in which radio waves are
transmitted and does not in any way indicate a failure of the audio equipment.

RDS - REGIONAL MODE


Press the RADIO button to display
the list of stations received locally
sorted in alphabetical order.
Select the station required by turning
the ring and press to confi rm.


Press one of the buttons on the numeric keypad for more than
2 seconds to store the current station. A bleep confi rms that it has
been stored.
Press the button on the numeric keypad to recall the stored radio
station.



RDS



Radiotext



Regional prog.


AM



RADIO


When the "RADIO" screen is displayed, turn the
ring or use the 4-direction navigator to select the
previous or next station on the list.
While listening to the radio, press buttons

and 
for the automatic search for a lower or higher
frequency.

Page:   1-10 11-20 21-30 next >