boot Citroen C6 DAG 2008 1.G Owner's Manual

6
B
A
IN BRIEF
1. Lift the boot fl oor using the strap B.2. Anchor the strap on the roof of the boot.3. To remove the spare wheel, detach the belt then push the wheel forwards so as to be able to lift it.
SPARE WHEEL
Note: The tools are to be found in a protective holder inside the spare wheel.
157
O P E N I N G
This can be unlocked, vehicle stopped:With either the remote control or the key.Using the interior central unlocking button, or simply by opening a door.
From the outside, press on lever A.

I
99
23
24
25
33
27
28
29
32
20
30
26
22
19
2131
IN BRIEF
19. Suspension controls - Ground clearance
adjustment/Sport mode
20. Multifunction display
21. Hazard lamps button
22. Controls - Electronic stability programme
(ESP/ASR)/Central locking of doors and boot/
Parking assistance
23. Controls - Lane Departure Warning System/
Anti-intrusion alarm
24. Air conditioning controls
25. Cup-holder
26. RD4 radio or RT3 NaviDrive
27. Glovebox
28. Sunlight sensor
29. Lateral air vent
30. Central air vents
31. Ashtray
32. Passenger's airbag
33. Front passenger's airbag deactivation
D A S H B O A R D

23
II
K E Y S
It is dangerous to operate the deadlocking when a person is in the vehicle as unlocking is impos-sible from the inside (without the remote control).
The key number is on the label attached to the key.
Should you lose your key or remote control, a CITROËN d ealer can supply replacements.
If you unlock your vehicle using the key because of a problem with the battery, be aware that opening/closing a door with the window closed can ser iously damage the glass, even to the point of breaking it. See "Access".
ELECTRONIC IMMOBILISER KEY
The key operates all the vehicle’s locks as well as the ignition.Note: For safety reasons, a buzzer will sound if you have switched off the ignition and opened the driv-er’s door without having removed the ignition key.
The key can be used to deactivate the front passenger’s airbag. See "Airbags".
CENTRAL LOCKING USING THE KEY
A brief action with the key locks the vehicle.
Deadlocking: Central locking using the key
A second action straightaway with the key deadlocks the vehicle. It is then impossible to open the doors from either inside or outside the vehicle.Note:With the vehicle stationary and the engine switched off, locking is signalled by the fl ashing of the interior locking control wa rning lamp.If any of the doors, or the boot, is open or not properly clo sed, the central locking does not operate.
ELECTRONIC IMMOBILISER
The ELECTRONIC IMMOBILISER device locks the engine supply system.
The system activates automatically as the key is removed from the igni tion.
All the vehicle’s keys contain an electronic immobiliser device.
After you switch on the ignition, a dialogue starts between the key and the electronic immobiliser device.
If the key is not recognised, you cannot start the vehicle .
If this occurs, leave your vehicle immobilised and contact a CITRO ËN dealer.

25
II
AB
A N T I - I N T R U S I O N A L A R M
OPERATING THE ALARM
First make sure all the doors are closed.
The alarm is armed by pressing button B on the remote control.
With the alarm armed, the protections are active after 5 seconds (perimeter) and 45 seconds (volumetric).
When the alarm is armed (on standby), any intrusion will trigger the siren for 30 seconds, accompanied by the direction indicators lighting up.
The alarm then goes back on standby, but the trigger-ing remains memorised and is signalled by the rapid fl ashing of the warning lamp on control 1 after you have deactivated the alarm with a press on the unlocking button A. The fl ashing stops when you switch on the ignition.
The siren is also triggered if there is a cutting of the electrical supply. To stop it, restore the electrical supply then press on the unlocking button A.Note:If you want to lock your vehicle without arming the alarm, just lock with the key only.
If you lock your vehicle and a door, or the boot, is still open, the central locking does not operate but the alarm will arm itself after approx. 45 seconds.Note: The siren is automatically deactivated (for exam-ple for disconnecting the battery) as soon as the vehicle is unlocked using the remote control.

46
II
T R I P C O M P U T E R
Tyre defl ation alert
The SERVICE warning lamp comes on and a vehicle outline is displayed.
The location of the wheel(s) concerned is clear from the vehicle outline, on which the affected wheel(s) will be fl ash-ing. Check the tyre pressures as soon as possible.
Colour screen CNaviDrive colour display
Tyre very defl ated
Tyre defl ated
Stop immediately, avoiding any sudden actions with the steering wheel or the brakes.
Change the wheel with the affected tyre (whether punctured or very defl ated), then have the tyre repaired and all the pressures checked at the earliest opportunity.
The wheel with a damaged tyre (either in the boot or under repair) can no longer be detected (information given by the vehicle outline or by a message) nor is the spare wheel able to be detected.
Puncture
The "STOP" and tyre(s) punctured warning lamps light up, and a vehicle ou tline is displayed. The location of the wheel(s) concerned is clear from the vehicle outline, on which the affected wheel(s) will be fl ashing.
Colour screen CNaviDrive colour display

82
III
A
B
A C C E S S
BOOT
This can be unlocked, vehicle stopped:With either the remote control or the key.
Using the interior central unlocking button, or simply by opening a door.
Opening from the outside
Press upwards on the lever A.Note:In any event, as soon as the vehicle is moving at more than around 10 km / h (6 mph), the boot is locked.
When the vehicle is stationary, the boot unlocks when a door is opened or if the interior central locking/unlocking button is pressed.

84
III
A U T O M A T I C A I R C O N D I T I O N I N G
AIR CONDITIONING
This system automatically adjusts the temperature, the fl ow of air and the distribution of air inside the cabin, depending on your desired comfort level.
Provided you retain automatic mode (by pressing button "AUTO") and all the air vents are open, you will main-tain an optimum comfort level, also removing humidity and misting, whatever the ambient climatic conditions.
The temperature inside the cabin cannot be lower than the temperature outside if the air conditioning is not operating.
To be effective, the air conditioning should only be used with the windows closed. If after a lengthy stop in bright sunlight the interior temperature is excessive, air the passenger compartment by opening the windows for a few moments, then close them again.
To keep the air conditioning compressor well sealed, it is essential to operate the air conditioning at least once in every month.
The air conditioning operates by using power from the engine. This results in a slight increase in fuel con-sumption.
Sensors
The automatic regulation of the air conditioning inside the cabin makes use of a number of sensors, relieving you of the need to make adjustments, other than the desired cabin temperature.
Take care not to obstruct sensor A.
Air inlet
Check that the exterior grille for the air inlet, at the bot-tom of the windscreen, is clean and free of dead leaves, snow, etc.
If washing the vehicle with a high pressure jet, avoid targeting the air inlet zone.
Air circulation
For your comfort we advise you to maintain a proper distribution of air within the cabin, both at the front and at the rear.
The air vents to the face have thumbwheels so that you can adjust the fl ow of air, and grilles to orient the direction.
There are air vents on the fl oor underneath the front seats and on the rear control panel, for enhanced heat-ing of the rear seat positions.
Do not obstruct the air outlets located in the boot area.
Dust/pollen fi lter
There is a fi lter for excluding pollen and dust.
This fi lter has to be changed according to the vehicle maintenance schedule. See "Maintenance Guide".

97
III
A
BC
D
R E A R S E A T S
Seat cushion folded.
Stow the head restraints.
Press the control A located at the end of the backrest and fully tilt for-wards.
The benchseat backrest can be folded in two sections. When you reposition the backrest, make sure that it locks in place.
Your vehicle's boot can be kept isolated from the passenger com-partment.
To lock the access to the boot:1. Place the benchseat in its correct position.The red warning lamp on control A should no longer be visible.
2. Insert the ignition key in the lock.3. Lock it.
Before moving the seats
So as to avoid damaging the seat belts by jamming them, take care to keep them to the sides of the backrest.
LOCKING/UNLOCKING OF THE ACCESS INTO THE BOOT VIA THE REAR BENCHSEATREAR CENTRAL SEAT BELT
For easier opening of the seat belt cover D, you should fi rst raise the central head restraint.
Insert the fi rst fastening C into the front left hand(black) buckle, then insert the second fastening B into the front right hand buckle.

114
III
5
4
4
1
3
2
6
1 Pull strap (spare wheel stowage).2 Boot lamp.To change the bulb, detach the cover and use a bulb W 5 W.
3 Elastic straps.4 12 V accessories socket (functions with the ignition switched on).5 Boot lateral net.6 Changer for 6 CDs.
B O O T

126
IV
CD CHANGER
This equipment S (if present) is located in the vehicle boot and comprises a magazine that holds up to 6 CDs.
TO INSERT/REMOVE A CD1. Remove the magazine from the CD changer1. Remove the magRemo
Open the sliding door of the CD changer.Press on the "EJECT" button to eject the magazine partially.Remove the magazine carefully.Close the sliding door.2. Removing a compartmentTake out just one drawer at a time.3. Inserting/removing a CDInsert a single CD, printed side upwards. Otherwise the CD Insert a single CD, printed sida single CD, printed s
changer will not operate.Pull out the CD by pulling on the part that is showing.4. Repositioning the compartmentRefi t the drawer by pushing it into the magazine. Do not push directly on the CD.into the magazine. Dgazine
5. Repositioning the magazineOpen the sliding door.Hold the magazine, narrow side towards the opening of the CD Hold the magazine, narrow side , narrow sid
changer.Push the magazine gently into the aperture of the changer until Push the magazine gently into agaz
there is a click.Reclose the sliding door to prevent entry of dust or of Reclose the sliding door to sliding door to
foreign bodies.prevent entry of dust or of prevent entry of dust or of