ESP Citroen DS3 2011 1.G Owner's Manual

11Familiarisation
Instruments and controls


1.
Cruise control/speed limiter controls.

2.
Headlamp height adjustment.

3.
Steering wheel adjustment.

4.
Lighting and direction indicator stalk

5.
Instrument panel.

6.
Driver's airbag.
Horn.

7.
Gear lever.

8.
12 V accessory socket
USB port /auxiliary socket.

9.
Heated seat control.

10.
Bonnet release lever.

11.
Door mirror controls.
Electric window controls.

12 .
Fusebox.

13.
Stop & Star t button
Electronic stability programme button
(ESP/ASR).

14 .
Front door window demisting/defrosting vent.

15.
Speaker (tweeter).

16.
Windscreen demisting/defrosting vent.

Monitoring

On switching on, the dial needles go to the
extent of their travel then return to 0.


A.
With the ignition on, the fuel gauge bars for
the fuel remaining should light up.

B.
With the engine running, the associated
low level warning lamp should go off.

C.
With the ignition on, the oil level indicator
should display "OIL OK"
for a few
seconds.
If the levels are not correct, top up the level
which is low.

Instrument panels




26, 28



1.
With the ignition on, the orange and red
warning lamps come on.

2.
With the engine running, these warning
lamps should go off.
If a warning lamp remains on, refer to the page
concerned.

Warning lamps



30, 35

Illumination of the indicator lamp indicates the
state of the corresponding function.


A.
Deactivation of the ESP/ASR system.


Switch panel

14 4


B.
Deactivation of Stop & Start.
167

31Monitoring

Operation indicator lamps

If one of the following indicator lamps comes on, this confirms that the corresponding system has come into operation.



Warning lamp



is on



Cause



Action/Observations








Left-hand
direction indicato

r

flashing with buzzer. The lighting stalk is pushed down.







Right-hand
direction indicator

flashing with buzzer. The lighting stalk is pushed up.







Sidelamps


fixed. The lighting stalk is in the "Sidelamps"
position.






Dipped beam
headlamps


fixed. The lighting stalk is in the "Dipped
beam headlamps" position.






Main beam
headlamps


fixed. The lighting stalk is pulled towards
you. Pull the stalk to return to dipped beam headlamps.






Front foglamps


fixed. The front foglamps are switched on. Turn the ring on the stalk rear wards twice to switch off
the front foglamps.





Rear foglamps


fixed. The rear foglamps are switched on. Turn the ring on the stalk rear wards to switch off the
rear foglamps.






Hazard warning
lamps


flashing with audible
signal. The hazard warning lamps switch,
located on the dashboard, has been
operated. The left-hand and right-hand direction indicators and
their associated indicator lamps flash simultaneously.

Deactivation indicator lamps

If one of the following indicator lamps comes on, this confirms that the corresponding system has been switched off intentionally.
This is may be accompanied by an audible signal and a message on the multifunction screen.



Warning lamp



is on



Cause



Action/Observations








Passenger's
airbag system


fixed. The control, located in the glove box,
is set to the OFF
position.
The passenger's front airbag is
deactivated.
In this case you can install a "rear
facing" child seat. Set the control to the ON
position to activate the
passenger's front airbag.
In this case, do not fit a child seat in the rear-facing
position.





ESP/ASR


fixed. The button, located at the bottom
left of the dashboard, is pressed. Its
indicator lamp is on.
The ESP/ASR is deactivated.
ESP: electronic stability programme.
ASR: anti-skid regulation. Press the button again to manually reactivate the ESP/
ASR. Its indicator lamp goes off.
From approximately 30 mph (50 km/h), the system is
reactivated automatically (except for the 1.6 litre THP
150 and R ACING engines).
The ESP/ASR system is activated automatically when
the vehicle is star ted.

Braking


fixed, associated with
the STOP warning
lamp. The braking system fluid level is too
low. You must stop as soon as it is safe to do so.
Top up with brake fluid recommended by CITROËN.
If the problem persists, have the system checked by a
CITROËN dealer or a qualified workshop.

+

fixed, associated with
the STOP and ABS
warning lamp. The electronic brake force distribution
(EBFD) system has a fault. You must stop as soon as it is safe to do so.
Have it checked by a CITROËN or a qualified
workshop.

Warning lamp



is on



Cause



Action/Observations








Anti-lock Braking
System (ABS)


fixed. The anti-lock braking system has a
fault. The vehicle retains conventional braking.
Drive carefully at reduced speed and contact a
CITROËN dealer or a qualified workshop without delay.






Dynamic stability
control (ESP/
ASR)


flashing. The ESP/ASR regulation is active. The system optimises traction and improves the
directional stability of the vehicle.

fixed. Unless it has been deactivated (button
pressed and its indicator lamp on) the
ESP/ASR system has a fault. Have it checked by a CITROËN or a qualified
workshop.

Languages

Once the "Languages" menu has been selected,
you can change the language used by the display
(Français, Italiano, Nederlands, Portugues,
Portugues-Brasil, Deutsch, English, Espanol).


Units

Once the "Units" menu has been selected,
you can change the units of the following
parameters:


- temperature (°C or °F),

- fuel consumption (l/100 km, mpg or km/l).
Once the fuel consumption units have
been set to mpg, the information in the
instrument panel screen on speed and
distance will also be in mph and miles. For safety reasons, configuration by the
driver of the multifunction screen must
only be done when stationary.


Display settings

Once the "Display settings" menu has been
selected, you can gain access to the following
settings:


- year,

- month,

- day,

- hour,

- minutes,

- 12 or 24 hour mode.

)
Once you have selected a setting, press
the " 
" or " 
" buttons to change its value.

)
Press the " 
" or " 
" buttons to switch
respectively to the previous or next setting.

)
Press the "OK"
button to save the change
and return to the normal display or press
the "ESC"
button to cancel.

Display confi guration

Once this menu has been selected, you can
gain access to the following settings:


- brightness-video setting,

- date and time setting,

- selection of units.
Once the fuel consumption units have
been changed to mpg, the information
in the screen relating to speed and
distance also changes to mph and
miles respectively. For safety reasons, configuration by the
driver of the multifunction screen must
only be done when stationary.



Choice of language

Once this menu has been selected, you can
change the language used by the display
(Deutsch, English, Espanol, Français, Italiano,
Nederlands, Portugues, Portugues-Brasil,
Türkçe * ).

*
According to country of destination. With Audio system on, once this menu is
selected you can configure your Bluetooth
hands-free system (pairing), view the various
telephone directories (list of calls, ser vices...)
and manage your calls (call, hang up, second
call, secret mode...).
For more information on the "Telephone"
function, refer to the Audio system par t of the
"Audio and telematics" section.


"Telephone" Menu

59Multifunction screens














16/9 colour screen (MyWay)

It displays the following information
automatically and directly:


- time,

- date,

- altitude,

- ambient temperature (the value displayed
flashes if there is a risk of ice),

- check of the doors,

- warning and vehicle function status
messages, displayed temporarily,

- audio functions,

- trip computer information (see the
"Monitoring" section),

- satellite navigation system information.



Displays on the screen

MyWay To select one of the applications, at the
control panel:


)
press the dedicated "RADIO"
, "MUSIC"
,
"NAV"
, "TRAFFIC"
, "SETUP"
or
"PHONE"
button for access to the
corresponding menu,

)
turn the dial to change the selection,

)
press the dial to confirm the selection,
or

)
press the "ESC"
button to abandon the
current operation and return to the previous
display.


Controls

For more information on these applications,
refer to the "Audio and Telematics" section or
to the specific user guide given to you with the
other owner's documents.

"SETUP" menu




)
Press the "SETUP"
button to gain access
to the "SETUP"
menu. This allows you to
select from the following functions:


- "System language",

- "Date and time",

- "Display",

- "Vehicle",

- "Units",

- "System".




System language

This menu allows you to select the language
used by the display: Deutsch, English,
Espanol, Français, Italiano, Nederlands, Polski,
Portugues, Türkçe * .


Date and time

This menu allows you to set the date and time,
the format of the date and the format of the time
(refer to the "Audio and Telematics" section or
to the specific user guide given to you with the
other owner's documents).


Display

This menu allows you to set the brightness of
the screen, the screen colour scheme and the
colour of the map (day/night or auto mode).

*
According to country.


Vehicle

This menu allows you to activate or deactivate
cer tain driving and comfor t equipment:


- wiper linked with reverse gear (refer to the
"Visibility" section),

- guide-me-home lighting and duration (refer
to the "Visibility" section),

- parking sensors (refer to the "Driving"
section).



Units

This menu allows you to select the units:
temperature (°C or °F) and fuel consumption
(km/l, l/100 or mpg).


System

This menu allows you to restore the factory
configuration, display the software version and
activate scrolling text.
For safety reasons, configuration of the
multifunction screen by the driver must
only be done when stationary.

71Comfort

















Digital air conditioning
The air conditioning operates when the engine is running, as well as in STOP mode with Stop & Start.


Automatic operation


1. Automatic "comfort"
programme
Press the "AU TO "
button. The
"AU TO "
symbol is displayed.
We recommend that you use
this mode. It provides optimised
automatic control of all of the following
functions: passenger compar tment
temperature, air flow, air distribution and air
intake, in accordance with the comfort value
that you have chosen.
This system is designed to operate effectively
in all seasons, with the windows closed. For your comfor t, when the engine is
switched off, the settings are retained
until the engine is switched on again.
To prevent too great a distribution of
cold air when the engine is cold, the air
flow will only reach its optimum level
gradually.


2. Temperature adjustment

The value indicated on the display corresponds
to a level of comfor t and not to a temperature in
degrees Celsius or Fahrenheit. On entering the vehicle, if the interior
is very cold or hot, there is no need to
change the value displayed in order
to reach the required level of comfor t.
The system corrects the temperature
difference automatically and as quickly
as possible.
Press the "



"
and "



"
buttons to
change this value. A setting around
the value 21
enables optimum
comfor t to be obtained. However,
depending on your requirements, a
setting between 18 and 24 is usual.

3. Automatic "visibility"
programme

The automatic comfor t programme
may not be sufficient for rapid
demisting or defrosting of the
windscreen and side windows
(humidity, several passengers, ice, etc.).
In this case, select the automatic visibility
programme. The button 3
indicator lamp
comes on.
The system automatically controls the air
conditioning and the flow of air and provides
optimum air distribution to the windscreen and
side windows. It deactivates air recirculation 5
.
To exit this programme, press button 3
again or
"AU TO "
, the indicator lamp on the button goes
off and "AU TO "
is displayed.







With Stop & Star t, when demisting has
been activated, the STOP mode is not
available.