CITROEN DS3 CABRIO 2016 Handbook (in English)
Page 371 of 450
4Dconcept
Diadeis
Interak
12-14
Labels
are
fitted
in
various
areas
of
your
vehicle.
They
carry
safety
warnings
as
well
as
vehicle
identification
information.
Do
not
remove
them:
they
form
an
integral
part
of
your
vehicle.
Automobiles
CITROËN
declares,
by
application
of
the
provisions
of
the
European
regulation
(Directive 2000/53)
relating
to
End
of
Life
Vehicles,
that
it
achieves
the
objectives
set
by
this
regulation
and
that
recycled
materials
are
used
in
the
manufacture
of
the
products
that
it
sells.
Printed
in
the EU
Anglais
For
any
work
on
your
vehicle,
use
a
qualified
workshop
that
has
the
technical
information,
competence
and
equipment
required,
which
a
CITROËN
dealer
is
able
to
provide.
Reproduction or translation of all or part of this document
is prohibited without written authorisation
from
Automobiles
CITROËN.
We draw your attention to the following
points:
- The fitting of electrical equipment or accessories not
listed by CITROËN may cause faults and
failures
with the electrical system of your vehicle.
Contact
a CITROËN dealer for information on the
range
of recommended accessories.
-
Any
modification or adaptation
not intended or
authorised
by
Automobiles
CITROËN or carried
out
without meeting the technical requirements
defined
by the manufacturer would lead to the
suspension
of the new vehicle warranty.
Page 372 of 450
15DS3.0030Anglais
Page 373 of 450
OWNER'S HANDBOOK - SUPPLEMENT
Page 374 of 450
Welcome
This document describes the special features relating to the presentation and use of your DS 3 CABRIO. Refer to the DS 3 owner's handbook for all other descriptions and specifications, and also to maintenance and warranty guide for servicing information for your vehicle.
Page 375 of 450
Contents
ACCESS
2 Soft top
10 Boot
12 Alarm
002 PR ACTICAL
INFORMATION
13 Rear shelf
010
008
TECHNICAL DATA
14 Changing a fuse
15 Recommendations on care
16 Petrol engines
17 Petrol weights
18 Diesel engine
19 Diesel weights
20 Dimensions
Key
safety warning
additional information
COMFORT 003
corresponds to a left hand drive vehicle.
corresponds to a right hand drive vehicle.
Page 376 of 450
2Access
Soft top
Your vehicle is fitted with an electric soft top roof.
The roof is opened and closed by pressing the control at the interior lamp, in the opening direction 1 and in the closing direction 2 .
Electric opening
and closing
Page 377 of 450
3Access
In order to maintain the state of charge of the battery, it is recommended that the roof be operated with the engine running .
Operation of the roof is possible: - engine running, or - ignition on.
During operation of the roof with just the ignition on, starting the engine may cause the roof to stop, depending on the state of charge of the battery. To have the roof continue the operation, operate the control again after the engine has started.
Operating zones
There are two operating zones: Zone A : horizontal operating zone, in manual or automatic mode. Zone B : vertical operating zone, in automatic mode only.
Before operating the roof, ensure that no occupant of the vehicle or person outside the vehicle could be subject to any risk related to the movement of the roof or the rear screen and that no object could inter fere with the operation.
Roof positions
Position 0 : Roof completely closed. Position 1 : Stop position for automatic roof closing. Position 2 : Roof open horizontally. Position 3 : Roof completely open.
Page 378 of 450
4Access
Opening
Manual mode Automatic mode
During automatic operation of the roof in zone A , pressing the control stops the roof. Opening of the roof in zone B can only be done in automatic mode.
In zone A , press the control beyond the point of resistance to begin opening the roof.
In zone A , press and hold the control without passing the point of resistance to open the roof.
The roof stops as soon as you release the control.
Page 379 of 450
5Access
During complete opening of the roof, the rear screen comes down onto the rear shelf. Ensure that no object is left on the shelf which might damage the rear screen or the roof.
Automatic opening of the roof in zone B
is not possible if the boot is open. In the event of a problem, check that the boot is fully closed .
During an operation in zone B , an instruction to stop the roof is not possible. Pressing the control reverses the direction of movement of the roof, whichever direction the control is pressed. This "anti-panic" function allows a quick change in direction of movement of the roof if suddenly required.
Release the control: opening of the roof continues up to the maximum horizontal position (position 2 ).
In zone B , a press on the control opens the roof completely (position 3 ).
Closing
Manual mode
In zone A , press and hold the control without passing the point of resistance to close the roof.
Page 380 of 450
6Access
Automatic mode
In position 3 , press the control to begin closing the roof.
When the roof is completely open, the rear screen rests on the rear shelf. Do not place any object on the rear screen.
Closing the roof in zone B can only be done in automatic mode.
Complete closing of the roof in zone Acan only be done in manual mode. Press and hold the control until the roof is heard to lock. If the roof does not lock correctly, operate the control again with the engine running.
If the problem persists, contact a CITROËN dealer or a qualified workshop.
Release the control: closing of the roof continues up to position 2 .
During an operation in zone B , an instruction to stop the roof is not possible. Pressing the control reverses the direction of movement of the roof, whichever direction the control is pressed. This "anti-panic" function allows a quick change in direction of movement of the roof in the event if suddenly required.
If the roof does not lock correctly, operate the control again with the engine running. If the problem persists, contact a CITROËN dealer or a qualified workshop.
The roof stops as soon as you release the control. To close the roof completely, press and hold the control until the the roof is heard to lock.