wiper fluid CITROEN DS3 CROSSBACK 2022 Owners Manual

60
Lighting and visibility04
Wiper control stalk
In wintry conditions, remove snow, ice or
frost present on the windscreen, around
the wiper arms and blades and on the
windscreen seal, before operating the wipers.
Do not operate the wipers on a dry
windscreen. Under extremely hot or cold
conditions, ensure that the wiper blades are
not stuck to the windscreen before operating
the wipers.
Without AUTO wiping



With AUTO wiping

Windscreen wipers
►  To select the wiping speed: raise or lower the
stalk to the desired position.
Fast wiping (heavy rain)
Normal wiping (moderate rain)
Intermittent wiping (proportional to the
vehicle’s speed)
Off
Single wipe (press down and release).
or
Automatic.
Refer to the corresponding section.
In position 1 or 2, the wiping frequency is
automatically reduced when the speed of
the vehicle drops below 3 mph (5 km/h).
When the speed is above 6 mph (10 km/h)
again, the wiping frequency returns to the
original frequency (fast or normal).
If the ignition has been switched off with
the windscreen wiper active, it is
necessary to operate the control stalk to
reactivate the wiping when the ignition is
switched on (unless the ignition is off for less
than 1 minute).
Single wipe
►  Pull the stalk briefly towards you.
Front screenwash
► Pull the wiper control stalk towards you and
hold.
The screenwash and windscreen wipers operate
for as long as the control stalk is pulled.
Termination of the screenwash is followed by a
final wiping cycle.
With automatic air conditioning, any
action on the screenwash control results
in temporary closure of the air intake to avoid
odours inside the passenger compartment.
To avoid damaging the wiper blades, do
not operate the screenwash if the
screenwash reservoir is empty.
Only operate the screenwash if there is no risk
of the fluid freezing on the windscreen and
hindering visibility. During the winter period,
use "very cold climate" rated products.
Never top up with water.
Rear wiper

►  Turn the ring to align the desired symbol with
the marking.
Off
Intermittent wipe
Wash-wipe
Reverse gear
When reverse gear is engaged, the rear wiper will
come into operation automatically if the front
windscreen wipers are operating.
The function is activated or deactivated in
the Driving / Vehicle menu of the touch
screen.
This function is activated by default.
In the event of accumulation of snow or
hard frost or if a bicycle carrier is fitted to
a towing device, deactivate the automatic rear
wiper via the touch screen’s Driving/Vehicle
menu.
Rear screenwash
►  Turn the ring all the way towards the
dashboard and hold.
The screenwash and the wiper operate for as long
as the ring remains turned.
A final wiping cycle is performed when
screenwashing ends.

61
Lighting and visibility04
►  Turn the ring to align the desired symbol with
the marking.
Off
Intermittent wipe
Wash-wipe
Reverse gear
When reverse gear is engaged, the rear wiper will
come into operation automatically if the front
windscreen wipers are operating.
The function is activated or deactivated in
the Driving / Vehicle menu of the touch
screen.
This function is activated by default.
In the event of accumulation of snow or
hard frost or if a bicycle carrier is fitted to
a towing device, deactivate the automatic rear
wiper via the touch screen’s Driving/Vehicle
menu.
Rear screenwash
►  Turn the ring all the way towards the
dashboard and hold.
The screenwash and the wiper operate for as long
as the ring remains turned.
A final wiping cycle is performed when
screenwashing ends.
Special position of the
windscreen wipers
This maintenance position is used for cleaning or
replacement of the wiper blades. It can also be
useful, in winter (ice, snow), to release the wiper
blades from the windscreen.
To maintain the effectiveness of the flat
wiper blades, it is advisable to:
–

handle them with c
are.
–

clean them regularly using soap
y water.
–

a

void using them to hold cardboard on the
windscreen.
–

replac
e them at the first signs of wear.
Before removing a front wiper blade

► Within one minute of switching off the
ignition, any operation of the wiper control stalk
will position the wiper blades vertically.
►  Proceed with the desired operation or the
replacement of the wiper blades.
After refitting a front wiper blade
►  To return the wiper blades to their initial
position, switch on the ignition and operate the
wiper control stalk.
Changing a wiper blade
Removing/refitting at the front

►  Carry out these wiper blade replacement
operations from the driver's side.
►  Starting with the wiper blade farthest from
you, hold each arm by the rigid section and raise it
as far as possible.
Do not touch the wiper blades. Risk of
irreparable deformation.
Do not release them while moving them. Risk
of damaging the windscreen!
►  Clean the windscreen using screenwash fluid.

62
Lighting and visibility04
Do not apply "Rain X" type water-repellent
products.
►  Unclip the worn wiper blade closest to you and
remove it.
►  Install the new wiper blade and clip it to the
arm.
►  Repeat the procedure for the other wiper
blade.
►  Starting with the wiper blade closest to you,
once again hold each arm by the rigid section,
then guide it carefully onto the windscreen.
Removing/refitting at the rear
►  Hold the arm by the rigid section and raise it
as far as possible.
►  Clean the rear screen using screenwash fluid.
►  Unclip the worn wiper blade and remove it.
►  Install the new wiper blade and clip it to the
arm.
►  Once again hold the arm by the rigid section,
then guide it carefully onto the rear screen.
Automatic windscreen
wipers
In AUTO mode, the windscreen wipers operate
automatically, without any action on the part of
the driver. If rain is detected, the wiping adapts to
the intensity of the rainfall automatically.
Detection of rainfall is by means of a rain/
sunshine sensor at the top centre of the
windscreen, behind the rear view mirror.
Do not cover the rain/sunshine sensor.
When using an automatic car wash,
switch off the automatic wipers and the
ignition.
In winter, wait until the windscreen is
completely clear of ice before activating the
automatic wipers.
Switching on

►  Give a short downwards push to the control
stalk.
A wiping cycle confirms that the instruction has
been accepted.
This indicator lamp comes on in the
instrument panel, accompanied by a
message.
Switching off
►  Give the control stalk another brief push
downwards or place the control stalk in another
position (Int, 1 or 2).
This indicator lamp goes off in the
instrument panel, accompanied by a
message.
If the ignition has been off for more than
one minute, the automatic wipers must be
reactivated by pushing the control stalk
downwards.
Malfunction
If a fault occurs with the automatic wipers, the
wipers operate in intermittent mode.
Have them checked by a dealer or a qualified
workshop.

221
Alphabetical index
Connection, Bluetooth 178, 190, 208, 212–213
Connection, MirrorLink
189–190, 207
Connection, Wi-Fi network

208
Connectivity

206
Consumption figures

25
Container, AdBlue®

145
Control, emergency boot release

34
Control, emergency door

31–32
Control, heated seats

40
Controls, steering mounted

86–89
Control stalk, lighting

54–55
Control stalk, wipers

60–62
Control unit

132–133
Courtesy lamp, front

52
Courtesy lamps

51–52
Cover, load space

53
Cruise control

98, 100–102
Cruise control, adaptive

103
Cruise control by speed limit recognition

98
Cruise control, dynamic with Stop function

98
D
DAB (Digital Audio Broadcasting) -
Digital radio
176, 187–188, 210
Date (setting)

193, 215
Daytime running lamps

55, 156
Deactivating the passenger airbag

70, 74
Deadlocking

28, 30
Defrosting

47
Demisting

47
Demisting, rear

47
Demisting, rear screen

47
Dials and gauges

9
Dimensions

172
Dipstick 141
Direction indicators
55, 156–158
Display, head-up

10–11
Display screen, instrument panel

9, 91
Doors

33–34
Driving

80–81
Driving aids camera (warnings)

95
Driving aids (recommendations)

94
Driving economically

7
Driving modes

90
DS Park Pilot

124
Dynamic stability control (DSC)

66–67
E
EBFD 66
Eco-driving (advice)
7
ECO mode

90
Economy mode

138
Electric motor

5, 25, 130, 171
Electronic brake force distribution (EBFD)

66
Emergency braking assistance (EBA)

66
Emergency call

64
Emergency switching off

83
Emergency warning lamps

63, 148
Emissions control system, SCR

19, 144
Energy economy mode

138
Energy flows

25
Energy recovery

19, 90
Engine

144
Engine compartment

140
Engine, Diesel

129, 140, 148, 170
Engine, petrol

140, 169
Engines

168–170
Environment

7, 33, 80
ESC (electronic stability control) 66
Expanded traffic sign recognition
98–99
F
Filling the AdBlue® tank 142, 145
Filling the fuel tank
129–130
Filter, air

142
Filter, oil

143
Filter, particle

143
Filter, passenger compartment

43, 142
Fitting a wheel

153–154
Fitting roof bars

137–138
Fittings, boot

52
Fittings, interior

48–49
Flap, charging

25, 131, 134–136
Flap, fuel filler

129–130
Flashing indicators

55, 156
Fluid, brake

141
Fluid, engine coolant

141
Foglamp, rear

54, 158
Folding the rear seats

42–43
Frequency (radio)

209–210
Fuel

7, 129
Fuel consumption

7
Fuel tank

129–130
Fusebox, dashboard

159
Fusebox, engine compartment

159, 161
Fuses

159–161
Fuses, dashboard

160
Fuses, engine compartment

161