bulb Citroen DS4 2010.5 1.G User Guide

Page 227 of 341

Changing the LED lamps/sidelamps Number plate lamps (W5W) Third brake lamp (LEDs)
For the replacement of this type of LED lamp, contact a CITROËN dealer or a qualified
workshop.
For the replacement of this type of LED lamp, contact a CITROËN dealer or a qualified workshop.
To facilitate the removal of the lamp, carry out this operation with the tailgate half open.  Inser t a thin screwdriver into the lens cutout.
 Push it outwards.  Remove the lens.  Change the faulty bulb. To refit, press on the lens to clip it in place.

Page 228 of 341

257Practical information
Changing a fuse
The extraction tweezer is fitted to a carrier clipped to the dashboard fusebox cover. For access to it:  open the glove box lid,  unclip the carrier on the fusebox cover by pulling on the right
Access to the tools
 remove the tweezer,  open the fusebox cover by pulling at top right,
 fold down completely the fusebox cover.
Changing foglamp bulbs
These bulbs are replaced from outside the rear bumper:  pass your hand under the bumper, turn the bulb holder a quarter turn and remove it, turn the bulb a quar ter turn, pull it out and fit a new bulb.
For reassembly, carry out these operations in reverse order.
Take care not to touch the silencer; there is a risk of burns if changing a bulb within a few minutes of switching off the ignition.

Page 229 of 341

257Practical information
Changing a fuse
The extraction tweezer is fitted to a carrier clipped to the dashboard fusebox cover. For access to it:  open the glove box lid,  unclip the carrier on the fusebox cover by pulling on the right
Access to the tools
 remove the tweezer,  open the fusebox cover by pulling at top right,
 fold down completely the fusebox cover.
Changing foglamp bulbs
These bulbs are replaced from outside the rear bumper:  pass your hand under the bumper, turn the bulb holder a quarter turn and remove it, turn the bulb a quar ter turn, pull it out and fit a new bulb.
For reassembly, carry out these operations in reverse order.
Take care not to touch the silencer; there is a risk of burns if changing a bulb within a few minutes of switching off the ignition.

Page 246 of 341

273Practical information
"Multimedia":
audio systems, steering mounted audio controls, speakers, Hi-Fi module, Bluetooth hands-free system, portable satellite navigation system, semi-integral support bracket for portable
navigation system, speed camera detector, USB Box, reversing camera, portable video screen, portable video support bracket, 230 V/50 Hz socket, 230 V/12 V adaptor, Wi-Fi on board...
By visiting a CITROËN dealer you can also obtain cleaning and maintenance products (interior and exterior) - including ecological products in the "TECHNATURE" range, products for topping up (screenwash...), paint touch-up pens and aerosols for the exact colour
of your vehicle, refills (sealant car tridge for the temporary puncture repair kit...), ...
Installation of radio communication transmitters
Before installing any after-market radio communication transmitter, you can contact a CITROËN dealer for the specification of transmitters which can be fitted (frequency, maximum power, aerial position, specific installation requirements), in line with the Vehicle
Electromagnetic Compatibility Directive (2004/104/EC).
The fitting of electrical equipment or accessories which are not recommended by CITROËN may result in a failure of your vehicle's electronic system and excessive electrical consumption. Please note this precaution. You are advised to contact a CITROËN representative to be shown the range of recommended equipment and accessories.
Depending on the legislation in force in the country, it may be compulsory to have a high visibility safety vest, warning triangle and spare bulbs and fuses available in the vehicle.

Page:   < prev 1-10 11-20