glove box Citroen DS4 2010.5 1.G Owner's Manual

Page 14 of 341

Lighting dimmer fixed. The lighting dimmer is making an adjustment. You can adjust the level of illumination of the instruments between 1 and 16.
Passenger's airbag system fixed in the seat belt and passenger’s front airbag warning lamps display.
The control switch, located in the glove box, has been placed in the "ON" position.The passenger's front airbag is activated. In this case, do not install a "rear facing" child seat.
Move the control switch to the "OFF" position to deactivate the passenger's front airbag. In this case, you can install a "rear facing" child seat.
Automatic wiping fixed. The wiper control is pushed downwards. Automatic front wiping is activated.
Warning lampis onCauseAction/Obser vations
Stop & Star t
fixed. The Stop & Star t system has put the engine in STOP mode at a vehicle stop (traffic lights, traffic jam, or other...).
The warning lamp goes off and the engine restar ts automatically in START mode, as soon as you want to move off.
flashes for a few seconds, then goes off.
STOP mode is temporarily unavailable. or START mode is invoked automatically.
Refer to "Driving - § Stop & Star t" for special cases with STOP mode and START mode.
Parking space sensors fixed. The parking space sensors function is selected. To star t measurement, operate the direction indica tor on the side of the space to be measured, and do not exceed 12 mph (20 km/h). A message is displayed once the measurement has been completed.

Page 16 of 341

49Monitoring
Passenger's
airbag system
fixed in the seat belt
and front passenger's airbag warning lamps display.
The control switch, located in the
glove box, is set to the OFF position. The passenger's front airbag is deactivated.
Set the control to the ON position to activate the
passenger's front airbag. In this case, do not fit a child seat in the rear-facing position.
Warning lampis onCauseAction/Obser vations
ESP/ASR fixed. The button, located at the bottom left of the dashboard, is pressed. Its indicator lamp is on. The ESP/ASR is deactivated. ESP: electronic stability programme. ASR: anti-skid regulation.
Press the button to activate the ESP/ASR. Its indica tor lamp goes off. The ESP/ASR system is activated automatically when the vehicle is star ted. If deactivated, the system is reactivated automatical ly from around 30 mph (50 km/h).
Deactivation indicator lamps
If one of the following indicator lamps comes on, this confirms that the corresponding system has been switch ed off intentionally. This is may be accompanied by an audible signal and a message on the multifunction screen.

Page 108 of 341


Interior fi ttings
1. Sun visor (see "Familiarisation - § Panoramic windscreen) 2. Ticket /card holder3. Storage compar tments4. Illuminated glove box (see details on a following page) 5. Door pockets6. USB por t /Auxiliar y socket (see details on a following page) 7. Cigar lighter/12 V accessor y socket (see details on following pages) 8. Por table ashtray (see details on following pages) 9. Centre armrest with storage (see details on a following page)

Page 109 of 341

143Fittings
Illuminated glove
box
Its lid has locations for storing a pen, a pair of glasses, tokens, maps, a cup...  To open the glove box, raise the handle. It is lit when the lid is opened. It houses the front passenger airbag deactivation switch A . If the vehicle is fitted with air conditioning, it provides access to the ventilation nozzle B , distributing the same cooled air as the vents in the passenger compar tment.
It gives access to the dashboard fusebox (see "Practical information - § Changing a fuse").
Portable ashtray
 Pull the cover to open the ashtray.  To empty it, remove the ashtray by pulling it upwards.
To avoid any problem of inter ference or risk of over turning, do not place the ashtray near the gear lever.

Page 118 of 341

143Fittings
Illuminated glove
box
Its lid has locations for storing a pen, a pair of glasses, tokens, maps, a cup...  To open the glove box, raise the handle. It is lit when the lid is opened. It houses the front passenger airbag deactivation switch A . If the vehicle is fitted with air conditioning, it provides access to the ventilation nozzle B , distributing the same cooled air as the vents in the passenger compar tment.
It gives access to the dashboard fusebox (see "Practical information - § Changing a fuse").
Portable ashtray
 Pull the cover to open the ashtray.  To empty it, remove the ashtray by pulling it upwards.
To avoid any problem of inter ference or risk of over turning, do not place the ashtray near the gear lever.

Page 159 of 341

Front airbags
System which protects the driver and front passenger in the event of a serious front impact in order to limit the risk of injury to the head and thorax. The driver's airbag is fitted in the centre of the steering wheel; the front passenger's airbag is fitted in the dashboard above the glove box.
Deployment
The airbags are deployed simultaneously, unless the passenger's front airbag is deactivated, in the event of a serious front impact to all or par t of the front impact zone A , in the longitudinal centreline of the vehicle on a horizontal plane and directed from the front to the rear of the vehicle.
The front airbag inflates between the thorax and head of the front occupant of the vehicle and the steering wheel, driver's side, and the
dashboard, passenger's side to cushion their for ward movement.

Page 213 of 341

243Practical information
Changing a wheel
Procedure for changing a faulty wheel for the spare w heel using the tools provided with the vehicle.
The tools are installed in the boot under the floor. To gain access to them:  open the boot,  raise the floor,  secure it by hooking its cord on the hook on the rear shelf suppor t,  with a standard size spare wheel, unclip and remove the box in the middle of the wheel containing the tools,
or  with a "space-saver" spare wheel; lift the wheel at the rear towards you for access to the storage box containing the tools.
Access to the tools
List of tools
All of these tools are specific to your vehicle. Do not use them for other purposes.
Wheel with trim
When removing the wheel , detach the trim first using the wheelbrace 1 pulling at the valve passage hole. When refitting the wheel , refit the trim star ting by placing its notch facing the valve and press around its edge with the palm of your hand.
3. "Bolt cover" tool.
For removing the bolt protectors (covers) on alloy wheels. 4. Socket for the security bolts (located in the glove box).
For adapting the wheelbrace to the special "security" bolts.
1. Wheelbrace.
For removing the wheel trim and the wheel fixing bolts. 2. Jack with integral handle. For raising the vehicle.

Page 228 of 341

257Practical information
Changing a fuse
The extraction tweezer is fitted to a carrier clipped to the dashboard fusebox cover. For access to it:  open the glove box lid,  unclip the carrier on the fusebox cover by pulling on the right
Access to the tools
 remove the tweezer,  open the fusebox cover by pulling at top right,
 fold down completely the fusebox cover.
Changing foglamp bulbs
These bulbs are replaced from outside the rear bumper:  pass your hand under the bumper, turn the bulb holder a quarter turn and remove it, turn the bulb a quar ter turn, pull it out and fit a new bulb.
For reassembly, carry out these operations in reverse order.
Take care not to touch the silencer; there is a risk of burns if changing a bulb within a few minutes of switching off the ignition.

Page 229 of 341

257Practical information
Changing a fuse
The extraction tweezer is fitted to a carrier clipped to the dashboard fusebox cover. For access to it:  open the glove box lid,  unclip the carrier on the fusebox cover by pulling on the right
Access to the tools
 remove the tweezer,  open the fusebox cover by pulling at top right,
 fold down completely the fusebox cover.
Changing foglamp bulbs
These bulbs are replaced from outside the rear bumper:  pass your hand under the bumper, turn the bulb holder a quarter turn and remove it, turn the bulb a quar ter turn, pull it out and fit a new bulb.
For reassembly, carry out these operations in reverse order.
Take care not to touch the silencer; there is a risk of burns if changing a bulb within a few minutes of switching off the ignition.

Page 232 of 341

Fuse N°RatingFunctions
F83 A Alarm siren, alarm ECU.
F1310 A Cigar lighter.
F1410 A 12 V socket in boot.
F163 A Lighting for the large multifunctional storage unit, rear map reading lamps, glove box illumination.
F173 A Sun visor illumination, front map reading lamps.
F2815 A Audio system, radio (after-market).
F3020 A Rear wiper.
F3210 A Hi-Fi amplifier.
Fuse N°RatingFunctions
F3615 A Rear 12 V socket.
F37- Not used.
F38- Not used.
F39- Not used.
F40- Not used.