headlamp Citroen DS5 2013.5 1.G User Guide

145Visibility


Selection ring for main lighting
mode
Turn the ring to position the symbol required
facing the mark.

Lighting off.






Automatic illumination of headlamps.


Sidelamps only.

Dipped or main beam headlamps.


Dipping the headlamps

Pull the stalk to switch the lighting between
dipped / main beam headlamps.

In the lighting off and sidelamps modes, the
driver can switch on the main beam headlamps
temporarily ("headlamp flash") by maintaining a
pull on the stalk.


Displays

Illumination of the corresponding indicator lamp
in the instrument panel confirms the lighting
switched on.

Foglamps selection ring

The foglamps operate with dipped and main beam headlamps.









Front and rear foglamps

Rotate and release the ring:



for wards a first time to switch on the front
foglamps,


for wards a second time to switch on the
rear foglamps,


rear wards a first time to switch off the rear
foglamps,


rear wards a second time to switch of the
front fog lamps. When the headlamps switch off with automatic
illumination of headlamps (AUTO model)
or when the dipped beam headlamps are
switched off manually, the foglamps and
sidelamps remain on.



Turn the ring rear wards to switch off
the foglamps, the sidelamps will then
switch off.








In good or rainy weather, both day
and night, the front foglamps and the
rear foglamps are prohibited. In these
situations, the power of their beams
may dazzle other drivers. They should
only be used in fog or snow.
In these weather conditions, it is your
responsibility to switch on the foglamps
and dipped headlamps manually as the
sunshine sensor may detect sufficient
light.
Do not forget to switch off the front
foglamps and the rear foglamps when
they are no longer needed.

147Visibility

Lighting left on audible
signal
An audible signal when a front door
is opened warns the driver that the
vehicle's exterior lighting is on, with the
ignition off and in manual lighting mode.
In this case, switching off the lighting
stops the audible signal.
With the ignition off, if the dipped
headlamps remain on, the vehicle goes
into "ECO" mode to avoid discharging
the battery.
In some weather conditions (e.g. low
temperature or humidity), the presence
of misting on the internal sur face of the
glass of the headlamps and rear lamps
is normal; it disappears after the lamps
have been on for a few minutes.

The daytime running
lamps can be activated
and deactivated via the
configuration menu.

The lighting goes off when you switch
off the ignition, but you can always
switch it on again using the lighting
control stalk.











Daytime running lamps
(LEDs)
They come on when the engine is started.
Depending on the country of sale or where
required by regulations, they are used for:


- daytime running lamps in day mode and
sidelamps in night mode (they are brighter
when daytime running lamps),
or


- sidelamps in day and night mode.

The sidelamps and dipped beam headlamps are
switched on automatically, without any action on
the part of the driver, when a low level of external
light is detected or in certain cases of activation of
the windscreen wipers.
As soon as the brightness returns to a sufficient
level or after the windscreen wipers are switched
off, the lamps are switched off automatically.












Automatic illumination of headlamps


Activation




Turn the ring to the "AUTO "
position,
automatic illumination of headlamps is
activated and a message is displayed in
the screen.



Deactivation




Turn the ring to another position.
Deactivation is accompanied by a message
in the screen.



Association with the automatic
"Guide-me-home" lighting
Association with the automatic lighting provides
the "guide-me-home" lighting with the following
additional options after the ignition is switched
off:


- selection of the lighting duration of 15, 30
or 60 seconds in the vehicle parameters in
the vehicle configuration menu,

- automatic activation of "guide-me-home"
lighting when automatic illumination of
headlamps is in operation.



Operating fault

In the event of a malfunction
of the sunshine sensor,
the lighting comes on, this
warning lamp is displayed in the instrument
panel and/or a message appears in the screen,
accompanied by an audible signal.
Contact a CITROËN dealer or a qualified
workshop.
In fog or snow, the sunshine sensor
may detect sufficient light. In this
case, the lighting will not come on
automatically.
Do not cover the sunshine sensor,
coupled with the rain sensor and
located in the centre of the windscreen
behind the rear view mirror; the
associated functions would no longer
be controlled.

149Visibility






Automatic headlamp dipping


Switching on

System which automatically changes between
dipped and main beam according to the lighting
and traffic conditions, using a camera located
in the rear view mirror.


Put the lighting control stalk ring
in the "AUTO" position.

This automatic headlamp dipping
system is a driving aid. The driver
remains responsible for the vehicle's
lighting, its correct use for the prevailing
conditions of light, visibility and traffic
and obser vation of driving and vehicle
regulations.

Flash the headlamps (pull
the stalk beyond the point
of resistance) to activate
the function.
This indicator lamp comes
on in the instrument panel
to confirm activation.



Press the button, its indicator
lamp comes on.

Switching off




Press the button, its indicator
lamp goes off, the lighting
system changes to "automatic
illumination of headlamps" mode.



Pause




Flashing the headlamps
again pauses the
function and the lighting
system changes to
"automatic illumination of
headlamps" mode.


Flash the headlamps
again to reactivate the
system.


The system will be operational as soon as
you have exceeded 15 mph (25 km/h).
If the speed drops below 9 mph (15 km/h),
the system no longer operates.


Operation

If the situation requires a change of headlamp
beam, the driver can take over at any time.
Once activated, the system operates as follows:


- if there is adequate light and/or if the traffic
conditions do not allow the use of main
beam, then dipped beam is maintained,

- if the light level is low and the traffic
conditions allow, main beam comes on
automatically.

Parking lamps

Side markers for the vehicle by illumination of
the sidelamps on the traffic side only.



Within one minute of switching off the
ignition, operate the lighting control stalk
up or down depending on the traffic side
(for example: when parking on the left;
lighting control stalk upwards; the right
hand sidelamps are on).
This is confirmed by an audible signal and
illumination of the corresponding direction
indicator warning lamp in the instrument panel.
To switch off the parking lamps, return the
lighting control stalk to the middle position or
switch on the ignition. Temporarily keeping the dipped beam
headlamps on after the vehicle's ignition has
been switched off makes the exit of the vehicle's
occupants easier when the light is poor.






Manual guide-me-home
lighting

Switching on




Within one minute after switching of the
ignition, "flash" the headlamps using the
lighting stalk.


A further "headlamp flash" switches the
function off.



Switching off

The manual guide-me-home lighting switches
off automatically after a set time (this time is
programmable in the configuration menu).

The system may suffer inter ference or
not work correctly:


- under conditions of poor visibility
(for example, snowfall, heavy rain
or thick fog, ...),

- if the windscreen is dirty, misted or
obscured (by a sticker, ...) in front of
the camera,

- if the vehicle is facing highly
reflective signs.


The system is not able to detect:


- road users that do not have their
own lighting, such as pedestrians,

- road users whose lighting is
obscured, such as vehicles running
behind a safety barrier (on a
motor way, for example),

- road users at the top or bottom of
a steep slope, on twisty roads, on
crossroads.

151Visibility





Exterior welcome
lighting
The remote switching on of the lighting makes
your approach to the vehicle easier in poor
light. It is activated according to the level of
light detected by the sunshine sensor.

Switching on

Switching off


The exterior welcome lighting switches off
automatically after a set time, when the ignition
is switched on or on locking the vehicle.



Programming


The lighting duration is selected via
the vehicle configuration menu.
The duration of the welcome lighting is
associated with and identical to that of
the automatic guide-me-home lighting.




Press the open padlock on the
remote control or the door handle
with Keyless Entry and Starting.








Door mirror spotlamps


Switching on

The spotlamps come on:


- when you unlock the vehicle,

- when you switch off the ignition,

- when you open a door,

- when you use the remote control to locate
the vehicle.



Switching off

They are timed to go off automatically.
To make your approach to the vehicle easier,
these illuminate:


- the zones facing the driver’s and
passenger’s doors,

- the zones for ward of the door mirrors and
rear ward of the front doors.
The dipped beam headlamps and the
sidelamps come on; your vehicle is also
unlocked.

Manual adjustment
of halogen
headlamps







Automatic adjustment of xenon headlamps


To avoid causing a nuisance to other road
users, the height of the halogen headlamps
should be adjusted according to the load in the
vehicle.

0.
1 or 2 people in the front seats.

-.
Intermediate setting.

1.
5 people + maximum authorised load.

-.
Intermediate setting.

2.
Driver + maximum authorised load.

-.
Intermediate setting.

3.
5 people + maximum load in the boot.

The initial setting is position "0"
.

If a fault occurs, this
warning lamp is displayed
in the instrument panel,
accompanied by an audible signal and a
message in the instrument panel screen.
The system then places your headlamps in the
lowest position. In order to avoid causing a nuisance to other
road users, this system corrects the height of the
xenon headlamps beam automatically and when
stationary, in relation to the load in the vehicle.
If a fault occurs, do not touch the xenon
bulbs. Contact a CITROËN dealer or a
qualified workshop.

153Visibility

When the dipped or main beam headlamps
are on, this function, allows the light beams to
better follow the road.
The use of this function, coupled with the
xenon headlamps and the cornering lighting,
considerably improves the quality of your
lighting round bends.








Directional lighting


with directional lighting


without directional lighting



Programming

Operating fault

The system is activated or
deactivated in the vehicle
configuration menu.
The system is activated by default.
The state of the system stays in
memory on switching off the ignition.

This function is inactive:


- when stationary or at low speeds,

- when reverse is engaged.
If a fault occurs, this warning lamp
flashes in the instrument panel,
accompanied by a message in the
screen.
Contact a CITROËN dealer or a
qualified workshop.

Rear wiper

If a significant accumulation of snow
or ice is present, or when using a
bicycle carrier on the boot, deactivate
the automatic rear wiper via the
configuration menu. park,
intermittent wipe,
wash-wipe (set duration).

Reverse gear

When reverse gear is engaged, the rear wiper
will come into operation if the windscreen
wipers are operating.
The function is activated or
deactivated via the configuration
menu.
This function is activated by default.



Programming




Pull the windscreen wiper stalk towards
you. The windscreen wash then the
windscreen wipers operate for a fixed
period.
The headlamp washers only operate when the
dipped or main beam headlamps are on
,
with the vehicle moving
.










Windscreen and headlamp
wash
Rear wiper selection ring:

To reduce the consumption of the fluid by the
headlamp washers, they operate only with
every seventh use of the screenwash or every
25 miles (40 km) during a given journey.