engine Citroen DS5 HYBRID4 2012 1.G User Guide

Hybrid system

Before starting




- Place the selector lever in position N
.

- If your vehicle has Keyless Entry and Starting, simply having the key inside the
vehicle is sufficient.

- If not, place the electronic key in the reader.

- Press the brake
pedal.
- Make a single shor t press (about a second) on the START/STOP
button.
- The steering column locks (noticeable
noise and movement of the steeringwheel).
- Keep your foot on the brake pedal until theHybrid4 system starts up (the instrument panel and the Readylamp come on, confirmed by an audible signal).
The hybrid system determines whether it isnecessary to star t the Diesel engine.
Starting with temperatures
above zero














Starting - switching off the engine


With temperatures below zero, you must initiate
pre-heating of the Diesel engine:

-
Without putting your foot on the brakepedal
, make an initial shor t press (about asecond) on the START/STOP button.

- The steering column unlocks (noticeablenoise and movement of the steering wheel).

- Wait until the pre-heater warning lampgoes off.
-
With your foot on the brake pedal
, make
a second short press on the START/STOP
button.

- Keep your foot on the brake pedal until the Hybrid4 system starts up (the Ready
lamp comes on, confirmed by an audible signal)and the Diesel engine star ts.


Starting with temperatures
below zero

33Hybrid system











Anti-theft protection
Electronic engine immobiliser
The keys contain an electronic chip which hasa secret code. When the ignition is switched
on, this code must be recognised in order for
starting to be possible. This electronic engine immobiliser locks the
engine management system a few minutes after the ignition is switched off and prevents
starting of the engine by anyone who does not have the key.
In the event of a malfunction, you are informed
by a message in the instrument panel screen.
In this case, your vehicle does not start; contacta CITROËN dealer as soon as possible.
Ignition on without starting
the engine
(accessory position)

With the electronic key in the reader or the
Keyless Entry and Star ting key inside the
vehicle, pressing the "START/STOP" button,
with no action on the pedals, allows the ignition
to be switched on and so activate the ancillary equipment.
)
Press the "START/STOP" button,
the instrument panel comes on but the engine does not star t.) Press the button again to switch
off the ignition and so allow the
vehicle to be locked.
If you use the accessory position for toolong, the system automatically goes intoeconomy mode to avoid the risk of a flatbattery.

Back-up starting with the Keyless Entry and Starting
system
When the electronic key is in the defined zone and your vehicle does not star t after pressingthe "STA R T/STOP" button: )Inser t the electronic key in the reader. )Press the brake pedal. )Press the "STA R T/STOP" button.
The hybrid system is active.



Back-up switch- off

In the event of an emergency only, the enginecan be switched of without any conditions. To
do this, press and hold the "STA R T/STOP"button for about 3 seconds.
In this case the steering column locks as soon
as the vehicle stops.
Electronic key not recognised bythe "Keyless Entry and Starting"
system
If the electronic key is no longer in the defined
zone when driving or when you (later) request switching off of the hybrid system, a message
appears in the instrument panel.
)Press and hold the "STA R T/STOP" button for about 3 seconds if you want to forceswitching off of the hybrid system (note that restar ting will not be possible without theelectronic key in the defined zone).
The electronic ke
y must always remain inside
the vehicle when in use.

35
Hybrid system








Hybrid4 mode selector
The selector allows the user to choose between 4 drive modes for the vehicle.
Turn the dial to the ri
ght or left; the mode selected is confirmed by illumination of the corresponding indicator.
ZEVmode, to force electric runnin
g.Spor
tmode, to make use of the maximum
performance of the vehicle.
4WDmode, to force the vehicle into 4x4 mode.

AUTOmode, for normal use and optimised fuelconsumption.

On star ting the vehicle: with the gear selector in position N, press the brake pedal and press
the STA R T/STOP button to activate the hybrid system.
This lamp comes on when the vehicle is ready
to move off ("Auto" mode is on by default) andso the driver can press the accelerator.
This lamp comes on more or less instantly but may take a few seconds in some cases (inparticular, the time needed for pre-heating the
Diesel engine in cold weather or, for example,
in energy economy mode, ...).








Ready lamp
With the vehicle stationary, press the STA R T/STOP button and check that the Readylampyis off when leaving the vehicle, other wise thehybrid system will still be active.


For more information, refer to the section on "Underbonnet precautions / warnings".

ZEV mode *
(all electric)

Zero emissions vehicle operation is assured10 0 % by electric drive.
This mode forces silent running
at moderate speeds.
It
can be activated when therequired conditions are met, particularly if the state of charge of high voltage battery is sufficient (from 4 bars).


Auto mode
It automatically manages the operation of theDiesel engine and the electric motor, according
to inherent vehicle parameters, traffic conditions and driving style so as to optimise
the vehicle's fuel consumption.
In particular, this mode activates "zero emissions" electric runningwhen theconditions allow.
In auto mode, the electric motor:

- can drive the vehicle on its own up
to around 36 mph (60 km/h) in "zeroemissions" electric running, dependingon the state of charge of the battery, if the conditions specific to the vehicle are met
and if acceleration is moderate,

- supplements the Diesel en
gine
when
moving off and changing gear, duringacceleration and when traction from the front wheels is inadequate (it automatically adds4 wheel drive),

- is no longer active above 70 mph (120 km/h).



*
ZEV: Z
ero Emissions Vehicle.
This standardmode to use in preference
is activated automaticallyon starting the hybrid system.

37
Hybrid system

Sport mode
(Diesel and
electric)


4WD mode **

(Diesel and
electric)
This mode allows more dynamic driving byproviding additional performance.Vehicle acceleration and pick-up are
maximised by using the capacity of the electric
motor, supplementing the power of the Diesel
engine.
This mode manages the progressiveness of theaccelerator, the electronic gearbox and the use of the electric motor.
In Sport mode:
- The electric motor can be used up to 70 mph (120 km/h).


This mode provides additional traction
***
at
low speed by driving all 4 wheels of the vehicle continuously: the Diesel engine (front wheel
drive) and the electric motor (rear wheel drive)operate simultaneously and permanently.
Their coupling is managed electronically tooptimise traction on slippery sur faces.
In 4WD mode:


- Power for the electric motor is provided,
i
f needed, by the alternator-star ter motor
of the front engine. The Diesel engine
operates continuously.

- The additional traction from the electricmotor is available up to 75 mph (120 km/h).
In ZEV m
ode:


- The accelerator control is progressive.

- Range and acceleration capacity are
limited. The maximum speed possible is
around 36 mph (60 km/h).

- Under high load or a priority requirement causing the star t of the Diesel engine, thesystem changes automatically to AUTO mode.I
f the conditions do not allow this mode, a message that the "electricmode is not currently available"appears in the screen. The ZEV
warning lamp flashes for a few seconds then goes off and the selector comes on in AUTO.
This mode should be used on snowcovered roads or difficult ground (mud, sand, ...). In this mode, in severe conditionsand if the circumstances allow, it isrecommended that you acceleratestrongly to ensure that you move off andavoid any risk of getting stuck.



For more information on "Automatic restarting of the Diesel engine or ZEV mode not available", refer to the corresponding section.
**

4WD: 4 Wheel Drive.
***
This mode will be even more effective if suitable tyres are fitted (winter tyres in
particular).

Energy consumption / generation indicator
The indicator dial provides real time information
on the total power used, combining electric and
Diesel.
It comprises three main zones.

ECO zone

Zone which indicates that the vehicle is optimising its energy consumption
, electric, Diesel or a combination of both.
This zone corresponds to phases of electric
running as well as to phases of optimum use of
the Diesel engine, which are easily accessible
with a suitable driving style (smooth "eco-citizen" driving).

CHARGE zone

Zone which indicates that the vehicle is
in electrical energy recovery phase: on ydeceleration, braking or foot off the accelerator, ...
This allows the high voltage battery to be
recharged using "free" energy which can then be reused
for future energy requirements.

39Hybrid system

POWER zone

Zone which indicates an increased cumulative power demand
from your hybrid vehicle,
taking account of the combined capacities of
the Diesel engine and the electric motor.

View hybrid fl ow information
Hybrid modes
1.
Hybrid mode selected (AUTO, ZEV, SPORT, 4WD).
2.
Messages, e.g.: "Zero Emission" if the Diesel engine is off (0 g/km CO2).


Operation / Energy flows
6.
The Diesel engine supplies the battery (if needed).
7.Arrow from left to right: the battery powers the electric motor (when
the electric motor is operating).
Arrow from right to left: the electric motor/generator recharges the
battery (energy recovery phases).8. The Diesel engine drives the front wheels. 9.The electric motor drives the rear wheels.
Vehicle infrastructure
3.
Diesel engine.4.
Tr a c t i o n b a t t e ry state of charge. 5.
Electric Motor/Generator. Information on the active h
ybrid mode, arrows for energy flows and the state of charge of the battery, is displayed in the instrument panel screen or the screen.

41Hybrid system

Examples of displays


On starting and when stationary

There is no flow of energy (the Stop & Star t system stops and
restar ts the Diesel engine automatically).

Energy recovery

During this phase (deceleration, braking, foot off the
accelerator, … all modes), the battery is recharged by the electric motor/generator, then being driven by the rear wheels.
You can maximise this energy recovery by taking your foot off
the accelerator pedal, deceleration will then be less marked
th
an with a conventional vehicle.

100% electric

In all electric running (AUTO or ZEV modes), only the electric motor, powered by the battery, drives the rear wheels.
The display of "Zero Emission" indicates that the Diesel engine
is off and the vehicle is producing no CO2.