Citroen GRAND C4 PICASSO RHD 2013 1.G Owner's Manual

219
5
Visibility






Courtesy lamps
1.Front courtesy lamp2.Front map reading lamps 3.Rear cour tesy lamp4.Rear map reading lamp s
Front - rear courtesy lamps
)
With the ignition on, press thecorresponding switch.


Front - rear map reading
lamps
With the "permanent lighting" mode, the lightingtime varies according to the circumstances:


- with the ignition off, approximately ten minutes,

- in energy economy mode, approximatelythirty seconds,

- with the engine running, unlimited.


In this position, the courtesy lamp comes on gradually:
Permanentl
y off.

Permanent lighting. - when the vehicle is unlocked
,
- when the electronic key is removed from
the reader,
- when opening a door,
- when the remote control locking button is
activated, in order to locate your vehicle.
It switches o
ff gradually:
- when the vehicle is locked,
- when the i
gnition is switched on,
- 30 seconds after the last door is closed.


Take care to avoid leaving anything in contact with the courtesy lamps.

Dependin
g on
version, you canalso switch the courtesy lamp on or
off by pressing thisbutton.

220
Visibility














Panoramic sunroof
)Rotate the control Ato slide the roof blindto the desired position (positions 1
to 4 ).



Closing the roof blind
Anti-pinch
It is fitted with an electrically controlled blind.
Opening the roof blind
)
Rotate the control A
to position 0
to closethe roof blind.

The blind has an anti-
pinch function. At the end of its travel, when the blind encounters an obstacle on closing, it stops andmoves back slightly.
Following a fault or after a batterydisconnection during the movement of the blind
or after it has stopped, you must re-initialise the
anti-pinch function:)place the blind in the closed position,)press control knob Bfor approximatelytwo seconds.

221
5
Visibility








Interior mood lighting

The dimmed passenger compar tment lighting improves visibility in the vehicle when the light is poor.
The interior mood lighting can be activatedor deactivated via the "Driving assistance
"
menu, then " Vehicle settings ".

The soft li
ghting provided by the footwell lamps
improves visibility in the vehicle when the light
is poor. At night, the lighting of the dashboard, centre console, cour tesy lamp... come on
automatically when the sidelamps are switched
on.
The interior mood lighting switches off
automatically when the sidelamps are switched off.

Switching on






Foot well lighting


Activation

Its operation is identical to that of the cour tesy
lamps. The lamps come on when one of the doors is opened.

222
Safety











Direction indicators
)Left: lower the lighting stalk passing thepoint of resistance.)Right: raise the lighting stalk passing the point of resistance.
Three fl ashes of the directionindicators
)Press briefly upwards or downwards,
without going beyond the point of resistance; the direction indicators will flash 3 times.









Hazard warning lamps

A visual warning by means of the directionindicators to alert other road users to a vehiclebreakdown, towing or accident.)
Press this button, the direction indicatorsflash.
They can operate with the ignition off.
Automatic operation of
hazard warning lamps
When braking in an emergency, depending on
the deceleration, the hazard warning lampscome on automatically.
The
y switch off automatically the first time youaccelerate. )
You can also switch them off by pressing
the button.





Horn
Audible warning system to alert other road
users to an imminent danger.)Press the central part of the steering
wheel.

Use the horn moderately and only in the following circumstances:


- immediate danger,

- over taking a cyclist or pedestrian

- approaching a location lacking
visibility.

223
6
Safety
This system allows you to make an emergency
or assistance call to the emergency services or
to the dedicated CITROËN service.








Emergency or
assistance call

For more information on the use of this function, refer to the "Audio and telematics"section.












Warning triangle
This safety device should be used in addition to
the hazard warning lamps.
Its presence in the vehicle is mandatory.

A location
for stowing the warning triangle isprovided in the tailgate interior trim.


Placing the triangle in the road
)
Place the triangle behind the vehicle, as
required by the legislation in force in your
country.




Before leaving your vehicle to set up and install the triangle, switch on thehazard warning lamps and put on your high visibility vest.


Refer to the manufacturer's instructions on unfolding and installing supplied withthe triangle.

224
Safety








Ty r e u n d e r - i nfl ation detection
The system continuously monitors thepressures on the four tyres, once the vehicle is moving.
It compares the information given by the four
wheel speed sensors with reference values,
which must be reinitialised ever
y time the tyre pressures are adjusted or a wheel changed. The system triggers an aler t as soon as it
detects a drop in the inflation pressure of one
or more tyres.
The under-inflation detection system does not replace the vigilance or theresponsibility of the driver. This system does not avoid the need tocheck the tyre pressures (including the spare wheel) every month as well as before a long journey. Driving with under-inflated tyres impairsroad holding, extends braking distances and causes premature tyre wear,particularly under arduous condition(high loading, high speed, long journey). S
ystem which automatically checks the pressure of the tyres while driving.

The inflation pressures defined for your vehicle can be found on the tyrepressure label (see the "Identificationmarkings" section). Tyre pressures should be checkedwhen the tyres are "cold" (vehicle stopped for 1 hour or after a journey of less than 6 miles (10 km) at moderatespeeds). Other wise, add 0.3 bar to the pressures shown on the label.

Driving with under-inflated tyresincreases fuel consumption.

225
6
Safety

Under-inflation alert
Reinitialisation
This is given by fixed illumination of
this warning lamp, accompanied byan audible signal and, depending on
equipment, the display of a message.
A label reminds you of the need to reinitialise
the system every time one or more tyre
pressure is adjusted, and after changing one or
more wheels.
)Reduce speed immediately, avoidexcessive steering movements and sudden
braking .)Stop the vehicle as soon as it is safe
to do so.
) In the event of a puncture, use the
temporary puncture repair kit or the spare
wheel (depending on equipment),or ) if you have a compressor, such as the one in the temporary puncture repair kit, check
the pressures of the four tyres when cold, or )
if it is not possible to make this check
immediately, drive carefully at reduced speed.



The loss of pressure detected does not always cause visible bulging of the tyre. Do not satisfy yourself with just a visual check. The aler t is maintained until the system is reinitialised.

226
Safety


Reinitialisation of the system is done with the ignition on and the vehicle stationary.
From the secondary page of the " Drivingassistance" menu:
)Press " Under-inflation initialisation".
)
Confirm the instruction by pressing "Yes".


The new pressure settings registered are considered to be reference values by the
system.


Operating fault

The flashing and then fixed illumination of the
under-inflation warning lamp accompanied
by illumination of the "ser vice" warning lamp
indicates a fault with the system.
In this case, under-inflation monitorin
g of the
tyres is no longer assured.
Have the system checked by a CITROËN
dealer or a qualified workshop.

Before doing anything to the system,the pressures of the four tyres must bechecked and the system reinitialised.

The under-inflation aler t can only beconsidered reliable if reinitialisation of the system is done with the the four tyrepressures correctly set.



Snow chains
The system does not have to be reinitialised after fitting or removingsnow chains.


Before reinitialising the system, ensure that the pressures of the four tyres arecorrect for the use of the vehicle and inline with the recommendations on thetyre pressure label.
The under-inflation detection systemdoes not give a warning if a pressure isincorrect at the time of reinitialisation.

227
6
Safety

Electronic Stability Programme (ESC: Electronic Stability Control) incorporating the
following systems:


- the anti-lock braking system (ABS) and the electronic brake force distribution (EBFD),

- the emergency braking assistance,

- the anti-slip regulation (ASR) or tractioncontrol,

- the dynamic stability control (DSC).











Electronic stability programme (ESC)
Definitions
Anti-lock braking system (ABS)and electronic brake force
distribution
(EBFD)
This system improves the stability and
manoeuvrability of your vehicle when braking and provides improved control in corners, in par ticular on poor or slippery road surfaces.
The ABS prevents wheel lock in the event of
emergency braking.
The electronic brake force distribution system
manages the braking pressure wheel by wheel.
Emergency braking assistance
In an emergency, this system enables you to reach the optimum braking pressure more quickly and therefore reduce the stopping
distance.
It is triggered according to the speed at which
the brake pedal is pressed. This is felt by a reduction in the resistance of the pedal and an increase in the effectiveness of the braking.

Anti-slip regulation (ASR)

The ASR system (also known as Traction Control) optimises traction in order to avoid
wheel slip by acting on the brakes of the driving
wheels and on the engine. It also improves
the directional stability of the vehicle onacceleration.


Dynamic stability control (DSC)

If there is a difference between the path followed by the vehicle and that required bythe driver, the DSC monitors each wheel and
automaticall
y acts on the brake of one or more
wheels and on the engine to return the vehicle
to the required path, within the limits of the laws
of physics.

228
Safety
Intelligent traction control
s
ystem ("Snow motion")
When this warning lamp comes on,coupled with the STOPwarning lamp,
accompanied by an audible signal and a
message, it indicates that there is a fault
with the electronic brake force distribution(EBFD), which could cause loss of control of the vehicle when braking.

Operation
When this warning lamp comes on,
accompanied by an audible signaland a message, it indicates that there
is a fault with the ABS, which could cause loss of control of the vehicle
when braking.
Your vehicle has a system to help driving onsnow: intelligent traction control.This system detects situations of difficult surface adhesion that could make it difficult to move off or make progress on deep fresh snow
or compacted snow.
In these situations
, the intelligent traction control limits the amount of wheel slip to provide the best traction and trajectory controlfor your vehicle.
In extremely severe conditions (deep snow,mud, ...), when it proves impossible to move off,
it may be useful to temporarily deactivate theESP/ASR systems to allow the wheels to spin
freely and so allow movement of the vehicle.
The use o
f snow tyres is strongly recommended on sur faces offering low levels of adhesion.

Anti-lock braking system (ABS)
and electronic brake force
distribution
(EBFD)

When changing wheels (tyres and rims),make sure that these are approved for your vehicle.
Normal operation of the ABS may make itself felt by slight vibrations of the brake pedal.
In emergency braking, press very firmly without releasing the pressure.
You must stop as soon as it is safe to do so.
In both cases, contact a CITROËN dealer or a qualified workshop.