CITROEN XSARA PICASSO 2008 Owners Manual

IVIVF U S E S
Number RatingFunctions
F10 15 ARight hand dipped beam
F11 10 ALeft hand main beam
F12 10 ARight hand main beam
F13 15 AWarning
F14 10 AWindscreen/rear screen wash pump
F15 30 A Engine sensors, ignition coils, injectors, Electrov alves
F16 30 AAir pump
F17 30 AWindscreen wiper
F18 40 AAir conditioning blower
฀1฀0฀7

VVF u e l
Locking filler cap
Turn the key a quarter turn to lock
and unlock the filler cap.
When refuelling, place the cap in
the support provided on the inside
of the filler flap.For petrol engines with catalytic converter, use of unleade
d fuel is ob-
ligatory
The filler neck has a narrower aperture to permit unleaded pe trol only.
If you are filling up with fuel, do not persist in topping up af ter the third
cut- off; this could cause your vehicle to malfunction.
Tank capacity (litres):
- 55 Approximately (Petrol models:).
- 60 Approximately (Diesel models:).
FUEL QUALITY
A label on the inside of the fuel filler flap indicates the app roved fuel quality
type.
UNLEADED PETROL DIESEL FUEL
Petrol engines are designed to run on RON 95 fuel; however, fo r better vehi-
cle performance (petrol engines), we recommend RON 98.
If you have put in fuel that is wrong for your vehicle, it is ess en-
tial to have the tank drained before you start the engine.
฀1฀0฀8

1
3
2
VVR E P L A C I N G B U L B S
Headlamp
�Headlamp dipped beam /
Main beam
�Sidelamp
�Direction indicator
Note: A light mist of condensation
may appear on the surface of the
headlamp glass under certain con-
ditions of use. Headlamp dipped beam /
Main beam
Disconnect the connector, remove
the rubber protector.
Press and release the slides.
Remove the bulb- holder.
Bulb:
H4 (anti U.V.).
Sidelamp:
Rotate the bulb-holderDa quarter
turn and pull.
Bulb: W 5 W.
The halogen bulbs should not be changed until they have been o ff
for a few minutes (risk of serious burns). Do not touch the new bulb
directly with your fingers; use a lint-free cloth.
It is essential that only anti- U.V. type bulbs are used in ord er not to
damage the headlamp.
฀1฀0฀9

VVR E P L A C I N G B U L B S
Front direction indicator
Rotate the bulb-holder a quarter
turn and pull.
Reconnect and refit the direction in-
dicator in its housing, engaging the
tabs in their guides
Bulb:PY 21 W. Side repeater direction indica-
tor
Push the unit forwards or towards
the rear to unclip it, then pull it to-
wards you.
Turn the bulb holder a quarter of a
turn.
Bulb:
PY 5 W. Front foglamps
Contact your CITROËN dealer.
Bulb:
H1.
฀1฀1฀0

VVR E P L A C I N G B U L B S
Interior lamp
Unclip the cover to gain access to
the bulb.
Bulb:W 6 W (N3 xénon). Boot lighting
Unclip the lens cover then pull out
the bulb holder.
Bulb:
W 5 W. Glovebox lighting
Unclip the cover to gain access to
the bulb.
Bulb:
W 5 W.
฀1฀1฀1

1
2
3
4
VVR E P L A C I N G B U L B S
Rear lamp unit
Identify the failed bulb
Bulbs:
�Stop lamps
and sidelamps:P 21/5 W.
�Direction indicator: PY 21 W.
�Reversing lamp: P 21 W.
�foglamp:P 21 W.Removal
In the side storage compartment,
remove the trim covering the ac-
cess to the lamps.
- release the bottom of the lamp
unit by pressing the lower retain-
ing spring. (with a tool such as a
screwdriver, if necessary). From outside
:
- pull the unit downwards to release the upper retaining spring,
- remove the bulb- holder by squeezing the tabs,
- replace the faulty bulb.
To refit
Engage the top of the unit in order
to fix the upper retaining spring,
and press on the bottom of the unit
to clip the lower retaining spring.
฀1฀1฀2

VVR E P L A C I N G B U L B S
Third stop lamp
Open the tailgate and remove the
cap to reach the bulb.
Bulb:W 5 W (5 Bulbs). Rear number plate lamp
Unclip the lens cover.
Bulb:
W 5 W.
After replacing a bulb, check the correct operation of the lighting and signalling .
฀1฀1฀3

A
VVT o w b a r
ADimensions (in metres): 0.792.
Towbar
The installation of a towbar should be carried out by a CITROË N dealer, who
will be aware of the towing capacity of your vehicle, has info rmation on the fit-
ting procedure as well as any modifications to the cooling sy stem needed to
cater for the intended towing conditions.
Towing (a caravan or boat etc.)
If the vehicle is climbing a steep incline or the engine is ove rheating, certain
functions become unavailable (automatic gearbox sequenti al control, air
conditioning). Towing advice
When towing a trailer with a fully
laden vehicle, restrict your speed to
a maximum of 60 mph.
Vehicle performance reduces with
altitude. At altitudes of 1,000 me-
tres, and for every additional 1,000
metres, the maximum towing
weight should be reduced by
100kg.
฀1฀1฀4

VVR O O F B A R S
Roof bars
Both for your safety and to avoid damage to its roof, your vehicle is designed for the use of roof bars that are specifical-
ly tested and approved by the CITROËN network.
Recommendations
• Spread the load evenly, avoid overloading one side.
• Keep heavy objects at the bottom of the load.
• Strap the load securely, and signal any overhanging load.
• Drive gently, the effect of side winds will be increased.
• Remove the roof rack or roof bars when not in use.
Respect the authorised load capacities.
For maximum loads that can be distributed on the roof bars. See Chapter: “General information”.
฀1฀1฀5

฀
A
B
2
3
4
1
A
2
3
4
1
VVC O L D W E A T H E R G R I L L E
( S n o w g u a r d )
Instructions for fitting the snow
guard:
- Clip component1on the bumper
rib at A.
- Position the snow guard 2, first
engaging the lug 3on the bumper
rib at B.
- Secure the snow guard by tight- ening screw 4into component 1.
The snow-guard grille should on-
ly be fitted during the winter peri-
od. It should be removed for the
rest of the year.
It is essential to remove the
snow-guard grille whenever tem-
peratures rise above 10°C.
฀1฀1฀6