overheating DODGE CHALLENGER 2010 3.G Owners Manual

CAUTION!
Repeated overheating of the seat could damage the
heating element and/or degrade the material of the
seat.
Easy Entry Seats
Pulling upward on the lever, located on the seatback,
allows the seatback to dump forward and the seat to slide
forward. You can also temporarily remove the seat belt
from the guide loop on the seat and allow the seat belt to
retract out of the way. This allows for easier access to the
rear seat.
Folding Rear Seat
The rear seatbacks can be folded forward to provide an
additional storage area. Pull on the loops shown in the
illustration to fold down either or both seatbacks. These
loops can be tucked away when not in use.
Easy Entry Seats
124 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

2. Return to the vehicle and press the programmed
HomeLinkbutton twice (holding the button for two
seconds each time). If the device is plugged in and
activates, programming is complete.
If the device does not activate, press the button a third
time (for two seconds) to complete the training.
If you have any problems, or require assistance, please
call toll-free 1–800–355–3515 or, on the Internet at
www.HomeLink.com for information or assistance.
To program the remaining two HomeLink buttons,
repeat each step for each remaining button. DO NOT
erase the channels.
Gate Operator/Canadian Programming
Canadian radio-frequency laws require transmitter sig-
nals to “time-out” (or quit) after several seconds of
transmission – which may not be long enough for
HomeLink to pick up the signal during programming. Similar to this Canadian law, some U.S. gate operators are
designed to “time-out” in the same manner.
It may be helpful to unplug the device during the cycling
process to prevent possible overheating of the garage
door or gate motor.
If you are having difficulties programming a garage door
opener or a gate operator, replace “Programming
HomeLink” Step 3 with the following:
3. Continue to press and hold the HomeLink
button,
while you press and release (“cycle”), your handheld
transmitter every two seconds until HomeLink has
successfully accepted the frequency signal. The EVIC
display will change from “CHANNEL # TRAINING” to
“CHANNEL # TRAINED.”
If you unplugged the device for training, plug it back in
at this time.
146 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

If Outside Ambient
Temperature IsMode Overrides To Temperature Overrides To Rear Window Defroster
Active
Less than 40°F Mix Full HeatYes
Between 40°F and 80°F No Override No Override No
More than 80°F Bi-Level Full Cool No
NOTE:
•The feature can be disable by parking the vehicle with
the blower control set to the “O” (or OFF) position.
•For maximum performance, it is recommended that
the vehicle is parked with the blower control set to the
“High” (full clockwise) position.
Operating Tips
NOTE: Refer to the chart at the end of this section for
suggested control settings for various weather condi-
tions.
Summer Operation
The engine cooling system in air-conditioned vehicles
must be protected with a high-quality antifreeze coolant
to provide proper corrosion protection and to protect
against engine overheating. A solution of 50% ethylene
glycol antifreeze coolant and 50% water is recommended.
Refer to “Maintenance Procedures” in “Maintaining Your
Vehicle” for proper coolant selection.
Winter Operation
Use of the air Recirculation mode during winter months
is not recommended because it may cause window
fogging.
4
UNDERSTANDING YOUR INSTRUMENT PANEL 237

HAZARD WARNING FLASHER
The Hazard Warning flasher switch is located in the
switch bank near the bottom center of the instrument
panel.Press the switch to turn on the Hazard Warning
flasher. When the switch is activated, all directional
turn signals will flash on and off to warn oncoming
traffic of an emergency. Press the switch a second time to
turn off the Hazard Warning flasher.
This is an emergency warning system and it should not
be used when the vehicle is in motion. Use it when your
vehicle is disabled and it is creating a safety hazard for
other motorists.
When you must leave the vehicle to seek assistance, the
Hazard Warning flasher will continue to operate even
though the ignition is placed in the OFF position. NOTE:
With extended use the Hazard Warning flasher
may wear down your battery.
IF YOUR ENGINE OVERHEATS
In any of the following situations, you can reduce the
potential for overheating by taking the appropriate ac-
tion.
•On the highways — slow down.
•In city traffic — while stopped, place the transmission
in NEUTRAL, but do not increase engine idle speed.
NOTE: There are steps that you can take to slow down
an impending overheat condition:
•If your air conditioner (A/C) is on, turn it off. The A/C
system adds heat to the engine cooling system and
turning the A/C off can help remove this heat.
6
WHAT TO DO IN EMERGENCIES 339

8. Disconnect the opposite end of the positive(+)jumper
cable from the positive (+)post of the booster battery.
9. Disconnect the positive (+)end of the jumper cable
from the remote positive (+)post of the discharged
vehicle.
If frequent jump-starting is required to start your vehicle
you should have the battery and charging system in-
spected at your authorized dealer.
CAUTION!
Accessories that can be plugged into the vehicle
power outlets draw power from the vehicle’s battery,
even when not in use (i.e., cellular phones, etc.).
Eventually, if plugged in long enough, the vehicle’s
battery will discharge sufficiently to degrade battery
life and/or prevent the engine from starting.
FREEING A STUCK VEHICLE
If your vehicle becomes stuck in mud, sand, or snow, it
can often be moved by a rocking motion. Turn your
steering wheel right and left to clear the area around the
front wheels. Then shift back and forth between RE-
VERSE and DRIVE. Using minimal accelerator pedal
pressure to maintain the rocking motion, without spin-
ning the wheels, is most effective.
CAUTION!
Racing the engine or spinning the wheels may lead to
transmission overheating and failure. Allow the en-
gine to idle with the shift lever in NEUTRAL for at
least one minute after every five rocking-motion
cycles. This will minimize overheating and reduce
the risk of transmission failure during prolonged
efforts to free a stuck vehicle.6
WHAT TO DO IN EMERGENCIES 365

NOTE:Turn off the Electronic Stability Program (ESP)
before rocking the vehicle. Refer to “Electronic Stability
Program,” or “Traction Control” in “Starting and Oper-
ating” for further information.
CAUTION!
•When “rocking” a stuck vehicle by moving be-
tween “1st” and REVERSE, do not spin the wheels
faster than 15 mph (24 km/h), or drivetrain damage
may result.
•Revving the engine or spinning the wheels too fast
may lead to transmission overheating and failure.
It can also damage the tires. Do not spin the
wheels above 30 mph (48 km/h) while in gear (no
transmission shifting occurring).
WARNING!
Fast spinning tires can be dangerous. Forces gener-
ated by excessive wheel speeds may cause damage, or
even failure, of the axle and tires. A tire could
explode and injure someone. Do not spin your vehi-
cle’s wheels faster than 30 mph (48 km/h) or for
longer than 30 seconds continuously without stop-
ping when you are stuck and do not let anyone near
a spinning wheel, no matter what the speed.
TOWING A DISABLED VEHICLE
Without The Key Fob
Special care must be taken when the vehicle is towed
with the ignition in the OFF position. The only approved
method of towing without the ignition key is with a
flatbed truck. Proper towing equipment is necessary to
prevent damage to the vehicle.
366 WHAT TO DO IN EMERGENCIES

Under normal operating conditions, the catalytic con-
verter will not require maintenance. However, it is im-
portant to keep the engine properly tuned to assure
proper catalyst operation and prevent possible catalyst
damage.
NOTE:Intentional tampering with emissions control
systems can result in civil penalties being assessed
against you.
In unusual situations involving grossly malfunctioning
engine operation, a scorching odor may suggest severe
and abnormal catalyst overheating. If this occurs, stop
the vehicle, turn off the engine and allow it to cool.
Service, including a tune-up to manufacturer’s specifica-
tions, should be obtained immediately. To minimize the possibility of catalytic converter dam-
age:
•Do not shut off the engine or interrupt the ignition,
when the transmission is in gear and the vehicle is in
motion.
•Do not try to start the engine by pushing or towing the
vehicle.
•Do not idle the engine with any spark plug wires
disconnected or removed, such as when diagnostic
testing, or for prolonged periods during very rough
idle or malfunctioning operating conditions.
7
MAINTAINING YOUR VEHICLE 389

DipsticksOil (Engine) .......................... 378
Power Steering ........................ 272
Disabled Vehicle Towing ................... 366
Disposal Antifreeze (Engine Coolant) ............... 394
Engine Oil ........................... 381
Door Locks ............................. 29
Door Locks, Automatic .................... 30
Door Opener, Garage ..................... 142
Driving On Slippery Surfaces ................... 268
Through Flowing, Rising, or Shallow
Standing Water ........................ 269
Driving to Achieve Maximum Fuel Economy .... 182
Electric Remote Mirrors .................... 83
Electrical Power Outlets ................... 152
Electronic Brake Control System ............. 279Electronic Power Distribution Center (Fuses)
.... 409
Electronic Speed Control (Cruise Control) ...... 137
Electronic Stability Program (ESP) ............ 283
Electronic Throttle Control Warning Light ...... 166
Electronic Vehicle Information Center (EVIC) .... 178
Emergency Deck Lid Release ................ 35
Emergency, In Case of Freeing Vehicle When Stuck ............... 365
Hazard Warning Flasher ................. 339
Jacking ............................. 351
Jump Starting ......................... 361
Overheating .......................... 339
Towing ............................. 366
Emergency Trunk Release ................... 35
Emission Control System Maintenance ......375,426
Engine ............................ 372,373
Air Cleaner .......................... 382
Block Heater ......................... 252
Break-In Recommendations ................ 70
458 INDEX

Checking Oil Level..................... 378
Compartment ...................... 372,373
Coolant (Antifreeze) ................. 390,422
Cooling ............................. 390
Exhaust Gas Caution .................. 72,318
Fails to Start .......................... 251
Flooded, Starting ...................... 251
Fuel Requirements ..................... 314
Jump Starting ......................... 361
Oil ........................... 378,421,422
Oil Change Interval .................. 172,379
Oil Filler Cap ......................... 380
Oil Filter ............................ 381
Oil Filter Disposal ..................... 381
Oil Selection ....................... 379,421
Oil Synthetic ......................... 381
Overheating .......................... 339
Starting ............................. 245
Temperature Gauge .................... 166 Engine Oil Viscosity
...................... 380
Enhanced Accident Response Feature .......... 57
Entry System, Illuminated .................. 20
Ethanol ............................... 315
Event Data Recorder ...................... 60
Exhaust Gas Caution ................... 72,318
Exhaust System ....................... 72,387
Exterior Folding Mirrors ................... 82
Exterior Lighting ........................ 127
Exterior Lights .......................... 75
Filler Location Fuel ...................... 319
Filters Air Cleaner .......................... 382
Engine Oil ........................ 381,422
Engine Oil Disposal .................... 381
Flashers Hazard Warning ....................... 339
Turn Signal ...................... 75,130,167
10
INDEX 459

Oil Change Indicator.................. 172,181
Oil Change Indicator, Reset ..............172,181
Oil, Engine ......................... 378,422
Capacity ............................ 421
Change Interval .................... 172,379
Checking ............................ 378
Dipstick ............................. 378
Disposal ............................ 381
Filter ............................ 381,422
Filter Disposal ........................ 381
Identification Logo ..................... 379
Materials Added to ..................... 381
Recommendation ................... 379,421
Synthetic ............................ 381
Viscosity ......................... 380,421
Oil Filter, Change ........................ 381
Oil Filter, Selection ....................... 381
Onboard Diagnostic System ..............374,375
Opener, Garage Door (HomeLink) ........... 142 Operating Precautions
.................... 374
Operator Manual (Owner’s Manual) ............ 4
Outside Rearview Mirrors .................. 82
Overhead Console ....................... 141
Overheating, Engine ................... 167,339
Owner’s Manual (Operator Manual) .........4,449
Paint Care ............................. 401
Panic Alarm ............................ 24
Parking Brake .......................... 273
Passing Light ........................... 131
Personal Settings ........................ 189
Pets .................................. 70
Phone, Cellular .......................... 85
Phone, Hands-Free (Uconnect™) .............. 85
Placard, Tire and Loading Information ......... 292
Power Brakes .............................. 276
Deck Lid Release ....................... 34
466 INDEX