bulb DODGE DAKOTA 2005 3.G User Guide

Removing Headlamp from AssemblyRemoving Headlamp Bulb
MAINTAINING YOUR VEHICLE 333
7

7. Reverse procedure to install new Headlamp bulb into
the headlamp assembly.
NOTE:These are Halogen bulbs. Take care not to touch
the bulb with your fingers. Body oils from your fingers
could cause excessive heat buildup which reduces bulb
life.
Front Park and Turn Signal Lamp.
•
Open the hood.
•Remove the (3) screws attaching the headlamp hous-
ing to the inner panel.
•Grasp the headlamp and pull firmly to disengage the
headlamp housing from the fender panel.
NOTE:It is not necessary to disconnect the connector to
replace this bulb. If the bulb socket needs replacement
disconnect the connector.
Disconnecting Headlamp Bulb Connector
334 MAINTAINING YOUR VEHICLE

•Rotate bulb socket 1/4 turn and remove socket from
housing.
•Pull bulb straight from socket.
•Reverse procedure to install new turn signal bulb.
Removing Turn Signal BulbDisconnecting Turn Signal Connector
MAINTAINING YOUR VEHICLE 335
7

Rear Side Marker, Taillamps/Stoplamp, and Turn
Signal Bulbs — Replacement
1. Remove the two (2) screws that pass through the bed
sheetmetal.
2. Pull the taillamp housing straight out from the body.
Removing the Two (2) Screws
Pulling Housing From Body
336 MAINTAINING YOUR VEHICLE

3. Rotate the bulb socket from the housing. 4. Pull bulb straight out of socket.
Rotating Bulb Socket From HousingPulling Bulb From Socket
MAINTAINING YOUR VEHICLE 337
7

5. Reverse Procedure to install bulb and housing. Place
the two raised blocks passed the body.Center High-Mounted Stoplamp And Cargo Lamp
1. Remove the two (2) screws holding the housing/lens
to the body as shown.
Sliding Raised Blocks Past Body
Removing Screws
338 MAINTAINING YOUR VEHICLE

4. Turn desired bulb socket14turn and remove socket
and bulb from housing.
5. Pull desired bulb straight from the socket.
•Outside Bulbs: Cargo Lamps
•Inside Bulb: Center High Mount Stop Lamp
6. Reverse procedure for installation of bulbs and hous-
ing.Removing Socket From Housing
Pulling Bulb From Socket
340 MAINTAINING YOUR VEHICLE

3. Pull bulb from socket.
4. Reverse procedure for installation.Fog Lamps
1. Disconnect connector from fog lamp by raising wire
harness lock tab and pulling on wire harness connector.
2. Rotate fog lamp bulb 1/4 turn counterclockwise and
pull to remove from fog lamp housing.
3. Reverse Procedure to install.
Pulling Bulb From Socket
342 MAINTAINING YOUR VEHICLE

Ball Joints............................. 309
Battery............................... 306
Charging............................ 283
Emergency Starting..................... 283
Gas Caution.......................... 283
Keyless Transmitter Replacement............ 26
Saving Feature (Protection)............... 115
Belts, Drive............................ 302
Belts, Seat.............................. 32
Body Mechanism Lubrication............... 309
B-Pillar Location........................ 229
Brake Fluid............................ 345
Brake System........................221,318
Anti-Lock.........................221,222
Disc Brakes.......................... 318
Fluid Check.......................... 318
Hoses.............................. 319
Master Cylinder....................... 318
Parking............................. 219Warning Light.....................155,157
Brake/Transmission Interlock............... 199
Break-In Recommendations, New Vehicle........ 72
Bulb Replacement....................... 330
Bulbs, Light............................ 330
Calibration, Compass..................... 131
Camper............................... 144
Capacities, Fluid........................ 343
Caps, Filler
Oil (Engine).......................... 301
Power Steering........................ 308
Car Washes............................ 325
Carbon Monoxide Warning..............145,250
Cargo Light............................ 118
Cargo (Vehicle Loading)................... 252
Catalytic Converter....................251,304
CD Player..........................161,166
Cellular Phone........................84,184
INDEX 377
10

Intermittent Wipers...................... 120
Introduction............................. 4
Jack Operation.......................274,278
Jacking Instructions...................... 279
Key, Replacement........................ 12
Key, Sentry............................. 11
Key-In Reminder......................... 10
Keyless Entry System...................... 21
Keys................................. 10
Knee Bolster............................ 41
Lane Change and Turn Signals......... 118,152,336
Lap/Shoulder Belts....................... 32
LATCH (Lower Anchors and Tether for CHildren) . 62
Lights..............................74,114
Airbag............................54,158
Anti-Lock Warning..................... 155Back-Up............................. 336
Brake Warning........................ 157
Bulb Replacement...................... 330
Cargo .............................. 118
Center Mounted Stop................... 338
Courtesy/Reading..................... 127
Cruise.............................. 158
Daytime Running...................... 117
Door Ajar........................... 156
Fog .......................... 117,153,342
Hazard Warning Flasher................. 272
Headlights........................... 116
High Beam........................... 119
High Beam/Low Beam Select.............. 119
Instrument Cluster..................... 152
Intensity Control....................... 115
Interior........................... 114,127
License............................. 341
Lights On Reminder.................... 117
INDEX 383
10