DODGE DAKOTA 2011 3.G Owners Manual

CavityCartridge
Fuse Mini-
Fuse Description
18 20 Amp
Yellow Fuel Pump
19 15 Amp
Blue Rear Center Brake
Lamp
20 20 Amp
Yellow Instrument Cluster/
Door Locks/Brake
Transmission Shift
Interlock
21 25 Amp
Natural Audio Amp
22 20 Amp
Yellow Power Outlet
(Switchable)
23 20 Amp
Yellow Fog Lamps
24 20 Amp
Yellow Powertrain Control
Module B+Cavity
Cartridge
Fuse Mini-
Fuse Description
25 15 Amp
Blue Instrument Cluster
Illumination
26 20 Amp
Yellow Ignition Run/Start
Feed
27 10 Amp
Red Power Mirror
28 20 Amp
Yellow Power Outlet
29 20 Amp
Yellow Body Control Module
4 (Wipers)
30 Spare
31 30 Amp
Green Ignition Run/AC/
Windows
32 30 Amp Pink Body Control Module
1 (Ext. Lights # 1)
7
MAINTAINING YOUR VEHICLE 389

CavityCartridge
Fuse Mini-
Fuse Description
33 30 Amp Pink Automatic Shutdown
34 30 Amp Pink Body Control Module
2 (Ext. Light # 2)
35 40 Amp Green Climate Control Sys-
tem Blower Motor
36 Spare
37 Spare
38 20 Amp Blue Spare
39 30 Amp Pink Starter Solenoid
40 40 Amp Green Ignition Run Feeds
41 30 Amp Pink Wiper MotorCavity
Cartridge
Fuse Mini-
Fuse Description
42 25 Amp
Natural Body Control Module
5 (T-Case)
43 10 Amp
Red Lt Park Lamps
44 10 Amp
Red Rt Park Lamps
45 20 Amp
Yellow Trailer Tow Park
Lamps
46 10 Amp
Red Airbag System # 2
47 Spare
48 20 Amp Blue Sunroof/Sound Box
49 30 Amp Pink Trailer Tow B+
390 MAINTAINING YOUR VEHICLE

CavityCartridge
Fuse Mini-
Fuse Description
50 40 Amp Green Antilock Brakes
Module (Pump)
51 40 Amp Green Park Lamps
52 Spare
53 40 Amp Green Rear Defogger
54 Spare
55 Spare
56 10 Amp
Red Heated Seats
57 20 Amp
Yellow Airbag System # 2
58 20 Amp
Yellow Heated Seats
59 10 Amp Climate ControlCavityCartridge
Fuse Mini-
Fuse Description
Red System Module
60 10 Amp RedAntilock Brakes
Module
61 20 Amp
Yellow Body Control Module
3 (Reverse Lamps)
VEHICLE STORAGE
If you are leaving your vehicle dormant for more than
21 days you may want to take steps to protect your
battery. You may:
•Remove fuse #J13 in the Totally Integrated Power
Module (TIPM) labeled Main Ignition Off Draw (IOD).
•Or, disconnect the negative cable from the battery.
7
MAINTAINING YOUR VEHICLE 391

•Anytime you store your vehicle, or keep it out of
service (i.e. vacation) for two weeks or more, run the
air conditioning system at idle for about five minutes
in the fresh air and high blower setting. This will
ensure adequate system lubrication to minimize the
possibility of compressor damage when the system is
started again.
REPLACEMENT BULBS
LIGHT BULBS – InteriorBulb No.
Dome Lamp ........................ WL212–2
Cargo Lamp ............................ 921
Overhead Console Lamps ................... 192
Reading Lamp ...................... WL212–2LIGHT BULBS – Exterior
Bulb No.
Headlamp ............................. H13
Front Park/Turn/Side Marker ............3157NA
Back-Up .............................. 3157
Center High Mounted Stop Lamp ............. 921
Fog Lamp ............................. 9145
License Plate Lamp ....................... 168
Rear Tail, Stop, Turn Signal .................3057
BULB REPLACEMENT
Headlamp (Halogen)/Front Park and Turn Signal
Lamps
1. Open the hood
2. Remove the three bolts from the front of the headlamp
housing.
392 MAINTAINING YOUR VEHICLE

3. Grasp the headlamp and pull firmly to disengage the
headlamp housing from the fender panel.
4. While firmly holding the headlamp housing in your
hands, unlock and disconnect headlamp bulb connector.5. Twist 1/4-turn and remove headlamp bulb from hous-
ing and replace.
NOTE:
The headlamp bulb is a halogen bulb. Take care
not to touch the bulb with your fingers. Body oils from
your fingers could cause excessive heat buildup which
reduces bulb life.
7
MAINTAINING YOUR VEHICLE 393

To remove the park/turn signal bulb, rotate bulb socket
1/4-turn and remove socket from housing. Pull bulb
straight from socket.Rear Side Marker, Taillamps/Stop Lamps, And
Turn Signal Bulbs
1. Remove the two screws that pass through the bed
sheet metal.
394 MAINTAINING YOUR VEHICLE

2. Pull the taillamp housing straight out from the body. 3. Rotate the bulb socket counterclockwise to remove itfrom the housing.
7
MAINTAINING YOUR VEHICLE 395

4. Pull bulb straight out of socket.5. Reverse this procedure to install bulb and housing.
Place the two raised blocks past the body.
396 MAINTAINING YOUR VEHICLE

Center High-Mounted Stop Lamp And Cargo
Lamp
1. Remove the two screws holding the housing/lens to
the body, as shown.2. Remove housing from the cab.
7
MAINTAINING YOUR VEHICLE 397

3. Remove connector from housing tab for more clear-
ance.4. Turn desired bulb socket 1/4-turn and remove socket
and bulb from housing.
398 MAINTAINING YOUR VEHICLE