ECU DODGE DART 2013 PF / 1.G Service Manual

TIRE CHAINS (TRACTION DEVICES)
Use of traction devices require sufficient tire-to-body
clearance. Follow these recommendations to guard
against damage.
•Traction device must be of proper size for the tire, as
recommended by the traction device manufacturer
•Install on Front Tires
•Due to limited clearance, a 225/45R17 tire with a
Security Chain Company (SCC) Super Z6 low profile
traction device or equivalent is recommended
WARNING!
Using tires of different size and type (M+S, Snow)
between front and rear axles can cause unpredictable
handling. You could lose control and have a collision.
CAUTION!
To avoid damage to your vehicle or tires, observe the
following precautions:
•Because of restricted traction device clearance be-
tween tires and other suspension components, it is
important that only traction devices in good con-
dition are used. Broken devices can cause serious
damage. Stop the vehicle immediately if noise
occurs that could indicate device breakage. Re-
move the damaged parts of the device before
further use.
•Install device as tightly as possible and then
retighten after driving about12mile (0.8 km).
•Do not exceed 30 mph (48 km/h).
•Drive cautiously and avoid severe turns and large
bumps, especially with a loaded vehicle.(Continued)
446 STARTING AND OPERATING

Curb Weight
The curb weight of a vehicle is defined as the total weight
of the vehicle with all fluids, including vehicle fuel, at full
capacity conditions, and with no occupants or cargo
loaded into the vehicle. The front and rear curb weight
values are determined by weighing your vehicle on a
commercial scale before any occupants or cargo are
added.
Overloading
The load carrying components (springs, tires, wheels,
etc.) of your vehicle will provide satisfactory service as
long as you do not exceed the GVWR.
The best way to figure out the total weight of your
vehicle is to weigh it when it is fully loaded and ready for
operation. Weigh it on a commercial scale to ensure that
it is not over the GVWR.Overloading can cause potential safety hazards and
shorten useful service life. Heavier suspension compo-
nents do not necessarily increase the vehicle’s GVWR.
Loading
To load your vehicle properly, first figure out its empty
weight. Store heavier items down low and be sure you
distribute their weight as evenly as possible. Stow all
loose items securely before driving. Improper weight
distribution can have an adverse effect on the way your
vehicle steers and handles, and the way the brakes
operate.
CAUTION!
Do not load your vehicle any heavier than the
GVWR. If you do, parts on your vehicle can break, or
it can change the way your vehicle handles. This
could cause you to lose control. Also, overloading can
shorten the life of your vehicle.
466 STARTING AND OPERATING

Towing Requirements
To promote proper break-in of your new vehicle drive-
train components, the following guidelines are recom-
mended:
CAUTION!
•Do not tow a trailer at all during the first 500 miles
(805 km) the new vehicle is driven. The engine,
axle or other parts could be damaged.
•Then, during the first 500 miles (805 km) that a
trailer is towed, do not drive over 50 mph
(80 km/h) and do not make starts at full throttle.
This helps the engine and other parts of the
vehicle wear in at the heavier loads.
Perform the maintenance listed in the Maintenance
Schedule. Refer to “Maintenance Schedule” for further
information. When towing a trailer, never exceed the
GAWR or GCWR ratings.
WARNING!
Improper towing can lead to a collision. Follow these
guidelines to make your trailer towing as safe as
possible:
•Make certain that the load is secured in the trailer
and will not shift during travel. When trailering
cargo that is not fully secured, dynamic load shifts
can occur that may be difficult for the driver to
control. You could lose control of your vehicle and
have a collision.
•When hauling cargo or towing a trailer, do not
overload your vehicle or trailer. Overloading can
cause a loss of control, poor performance or dam-
age to the brakes, axle, engine, transmission, steer-
ing, suspension, chassis structure or tires. (Continued)
472 STARTING AND OPERATING

3. Remove the fastener securing the jack and spare tire.
4. Remove the scissors jack and wheel bolt wrench from
the spare wheel as an assembly. Turn the jack screw to the
left to loosen the wheel bolt wrench, and remove the
wrench from the jack assembly.
5. Remove the spare tire.WARNING!
•A loose tire or jack thrown forward in a collision
or hard stop could endanger the occupants of the
vehicle. Always stow the jack parts and the spare
tire in the places provided.
•Have the deflated (flat) tire repaired or replaced
immediately.
Preparations For Jacking
1. Park the vehicle on a firm, level surface as far from the
edge of the roadway as possible. Avoid icy or slippery
areas.
Jack and Spare Tire Fastener
486 WHAT TO DO IN EMERGENCIES

Manual Transmission
•
Manual transmission vehicles can be flat towed (all
four wheels on the ground) with the transmission in
NEUTRAL.
•Manual transmission vehicles can also be towed with
the front wheels elevated, or on a flatbed truck (all
four wheelsOFFthe ground).
CAUTION!
DO NOT flat tow any disabled vehicle if condition is
related to a clutch, transmission or driveline compo-
nent. Damage to the drivetrain could result.
All Transmissions
If you must use the accessories (wipers, defroster, etc.)
while being towed, the key must be in the ON/RUN
position, not the ACC position. If the key fob is unavailable, or the battery is discharged,
see “Shift Lever Override” in “What To Do In Emergen-
cies” for instructions on shifting the automatic transmis-
sion out of PARK for towing.
CAUTION!
Do not use sling-type equipment when towing.
When securing the vehicle to a flatbed truck, do not
attach to front or rear suspension components. Dam-
age to your vehicle may result from improper towing.
514 WHAT TO DO IN EMERGENCIES

The A/C air filter is located in the fresh air inlet on the
lower right of center console. Perform the following
procedure to replace the filter:
1. Remove the passenger side console closeout. (located
on the right side of the center console).2. Disengage the retaining tab that secures the filter
cover to the HVAC housing, and remove the cover.
7
MAINTAINING YOUR VEHICLE 531

Use only manufacturer’s recommended brake fluid. Re-
fer to “Fluids, Lubricants, and Genuine Parts” in “Main-
taining Your Vehicle” for further information.
WARNING!
•Use only manufacturer’s recommended brake
fluid. Refer to “Fluids, Lubricants, and Genuine
Parts” in “Maintaining Your Vehicle” for further
information. Using the wrong type of brake fluid
can severely damage your brake system and/or
impair its performance. The proper type of brake
fluid for your vehicle is also identified on the
original factory installed hydraulic master cylin-
der reservoir.(Continued)
WARNING! (Continued)
•To avoid contamination from foreign matter or
moisture, use only new brake fluid or fluid that
has been in a tightly closed container. Keep the
master cylinder reservoir cap secured at all times.
Brake fluid in a open container absorbs moisture
from the air resulting in a lower boiling point.
This may cause it to boil unexpectedly during hard
or prolonged braking, resulting in sudden brake
failure. This could result in a collision.
•Overfilling the brake fluid reservoir can result in
spilling brake fluid on hot engine parts, causing
the brake fluid to catch fire. Brake fluid can also
damage painted and vinyl surfaces, care should be
taken to avoid its contact with these surfaces.(Continued)
7
MAINTAINING YOUR VEHICLE 543

5.Twist the bulb socket one quarter turn clockwise to install.
6. Install trim cover.
License Lamp
1. Remove the screws securing the lamp to the rear
fascia.
2. Remove the bulb and socket assembly.3. Disconnect the bulb from the socket assembly and
install the replacement bulb.
4. Reinstall the bulb and socket assembly.
5. Reattach the lamp to the rear fascia, and then install
the screws.
1 — License Lamp Bulb
2 — Socket
7
MAINTAINING YOUR VEHICLE 559

ABS (Anti-Lock Brake System).............. 415
Adding Engine Coolant (Antifreeze) .......... 538
Adding Fuel ........................... 462
Adding Washer Fluid ..................... 534
Additives, Fuel ......................... 460
Air Cleaner, Engine (Engine Air Cleaner Filter) . . . 527
Air Conditioner Maintenance ............... 529
Air Conditioning ........................ 361
Air Conditioning Controls ................. 361
Air Conditioning Filter .................374,530
Air Conditioning Refrigerant .............529,530
Air Conditioning System .............361,372,529
Air Pressure, Tires ....................... 437
Airbag .............................. 60,77
Airbag Deployment ....................... 79
Airbag Light ..................... 67,81,95,291
Airbag Maintenance ....................... 80
Airbag, Side ........................ 63,65,77
Airbag, Window (Side Curtain) ...........64,65,77Alarm (Security Alarm)
.................... 21
Alarm Light ........................... 291
Alarm System (Security Alarm) ............... 21
Alarm, Panic ............................ 26
Alterations/Modifications, Vehicle ............. 7
Anti-Lock Brake System (ABS) .............. 415
Anti-Lock Warning Light .............294,415,417
Anti-Theft Security Alarm (Theft Alarm) ........ 21
Antifreeze (Engine Coolant) ...........537,560,561
Capacities .......................... 560
Disposal ........................... 540
Appearance Care ........................ 546
Arming Theft System (Security Alarm) ......... 21
Assist, Hill Start ........................ 420
Assistance Towing ....................... 131
Auto Down Power Windows ................ 42
Auto Unlock, Doors ....................... 34
Auto Up Power Windows .................. 43
Automatic Dimming Mirror ................ 105
582 INDEX

Bulb Replacement.................... 557
Daytime Running .................... 214
Dimmer Switch, Headlight ...........216,217
Electronic Stability Program (ESP) Indicator . . 423
Exterior ............................ 97
Fog ............................ 215,288
Hazard Warning Flasher ............... 483
Headlight Switch ..................... 211
Headlights ...................... 21 1,557
Headlights On Reminder ............... 214
Headlights On With Wipers ..........212,222
High Beam ......................... 217
High Beam Indicator .................. 288
High Beam/Low Beam Select ............ 217
Illuminated Entry ..................... 23
Instrument Cluster .................... 211
Intensity Control ..................... 218
Interior ............................ 218
License ............................ 559 Lights On Reminder
.................. 214
Low Fuel ....................... 292,312
Malfunction Indicator (Check Engine) ...... 294
Oil Pressure ........................ 293
Parade Mode (Daytime Brightness) ........ 220
Passing ............................ 217
Reading ........................ 217,248
Seat Belt Reminder ................... 288
Security Alarm (Theft Alarm) ............ 291
Service Engine Soon
(Malfunction Indicator) ................ 294
SmartBeams ........................ 213
Theft Alarm (Security Alarm) ............ 291
Tire Pressure Monitoring (TPMS) ......... 284
Traction Control ..................... 423
Turn Signal ....................... 97,216
Vanity Mirror ....................... 109
Voltage ............................ 293
Warning (Instrument Cluster Description) . . . 284
10
INDEX 591