DODGE DART 2016 PF / 1.G Owners Manual

Window Fogging
Interior fogging on the windshield can be quickly re-
moved by turning the mode selector to Defrost. The
Defrost/Floor mode can be used to maintain a clear
windshield and provide sufficient heating. If side win-
dow fogging becomes objectionable, increase blower
speed to improve airflow and clearing of the side win-
dows. Vehicle windows tend to fog on the inside in mild
but rainy or humid weather.
NOTE:
•Recirculate without A/C should not be used for long
periods, as fogging may occur.
• Automatic Temperature Controls (ATC) will automati-
cally adjust the climate control settings to reduce or
eliminate window fogging on the front windshield.
When this occurs, recirculation will be unavailable.
Outside Air Intake
Make sure the air intake, located directly in front of the
windshield, is free of obstructions such as leaves. Leaves
collected in the air intake may reduce airflow, and if they
enter the plenum, they could plug the water drains. In
winter months, make sure the air intake is clear of ice,
slush, and snow.
A/C Air Filter
The climate control system filters outside air containing
dust, pollen and some odors. Strong odors cannot be
totally filtered out. Refer to “Maintenance Procedures” in
“Maintaining Your Vehicle” for filter replacement instruc-
tions.
4
UNDERSTANDING YOUR INSTRUMENT PANEL 409

Operating Tips Chart
410 UNDERSTANDING YOUR INSTRUMENT PANEL

STARTING AND OPERATING
CONTENTS
STARTING PROCEDURES ...............415
▫ Manual Transmission — If Equipped .......415
▫ Automatic Transmission — If Equipped .....416
▫ Keyless Enter-N-Go ...................416
▫ Normal Starting ...................... .416
▫ Extreme Cold Weather (Below –20°F
or 29°C) .......................... .418
▫ Extended Park Starting ..................418
▫ If Engine Fails To Start .................419
▫ After Starting ....................... .419▫
Turbocharger “Cool Down” — If Equipped . . .420
 ENGINE BLOCK HEATER — IF EQUIPPED . . .420
 MANUAL TRANSMISSION — IF EQUIPPED . .421
▫ Shifting ............................ .422
▫ Downshifting ....................... .423
 AUTOMATIC TRANSMISSION — IF
EQUIPPED .......................... .425
▫ Key Ignition Park Interlock ...............428
▫ Brake/Transmission Shift Interlock System . . .428
5

▫Six-Speed Automatic Transmission (1.4L Turbo
Engine Only — DDCT) .................428
▫ Six-Speed Automatic Transmission (2.0L And
2.4L Engine Only — 6F24) ...............439
 AUTOSTICK ......................... .446
▫ Operation .......................... .446
 DRIVING ON SLIPPERY SURFACES .........448
▫ Acceleration ........................ .448
▫ Traction ........................... .448
 DRIVING THROUGH WATER .............449
▫ Flowing/Rising Water ..................449
▫ Shallow Standing Water .................449
 PARKING BRAKE ..................... .451
 BRAKE SYSTEM ...................... .454
POWER STEERING .....................455
 ELECTRONIC BRAKE CONTROL SYSTEM . . . .456
▫ Electronic Brake Force Distribution (EBD) . . . .456
▫ Brake System Warning Light ..............456
▫ Anti-Lock Brake System (ABS) ............456
▫ Anti-Lock Brake Warning Light ............458
▫ Brake Assist System (BAS) ...............459
▫ Hill Start Assist (HSA) .................459
▫ Traction Control System (TCS) ............462
▫ Electronic Stability Control (ESC) ..........463
▫ Electronic Roll Mitigation (ERM) ...........467
▫ Trailer Sway Control (TSC) ...............467
▫ Ready Alert Braking (RAB) ...............468
412 STARTING AND OPERATING

▫Rainy Brake Support (RBS) ...............468
▫ Dynamic Steering Torque (DST) ...........468
 TIRE SAFETY INFORMATION .............469
▫ Tire Markings ....................... .469
▫ Tire Identification Number (TIN) ...........473
▫ Tire Terminology And Definitions ..........475
▫ Tire Loading And Tire Pressure ...........476
 TIRES — GENERAL INFORMATION ........481
▫ Tire Pressure ....................... .481
▫ Tire Inflation Pressures .................482
▫ Tire Pressures For High Speed Operation . . . .484
▫ Radial Ply Tires ..................... .484
▫ Tire Types .......................... .485▫
Run Flat Tires — If Equipped .............487
▫ Spare Tires — If Equipped ...............487
▫ Tire Spinning ....................... .489
▫ Tread Wear Indicators ..................490
▫ Life Of Tire ........................ .491
▫ Replacement Tires .....................491
 TIRE CHAINS (TRACTION DEVICES) .......493
 TIRE ROTATION RECOMMENDATIONS .....494
 TIRE PRESSURE MONITORING SYSTEM
(TPMS) ............................. .495
▫ Base System ........................ .498
▫ Premium System — If Equipped ...........501
▫ General Information ...................504
5
STARTING AND OPERATING 413

FUEL REQUIREMENTS ..................504
▫ 1.4L Turbo Engine .....................504
▫ 2.0L And 2.4L Engine ...................505
▫ Reformulated Gasoline .................505
▫ Gasoline/Oxygenate Blends ..............506
▫ E-85 Usage In Non-Flex Fuel Vehicles .......506
▫ MMT In Gasoline .....................507
▫ Materials Added To Fuel ................507
▫ Fuel System Cautions ...................508
▫ Carbon Monoxide Warnings .............509
 ADDING FUEL ....................... .509
▫ Fuel Filler Cap (Gas Cap) ...............509
 VEHICLE LOADING ....................512 ▫
Vehicle Certification Label ...............512
 TRAILER TOWING .....................514
▫ Common Towing Definitions .............514
▫ Trailer Hitch Classification ...............517
▫ Trailer Towing Weights (Maximum Trailer
Weight Ratings) ..................... .517
▫ Trailer And Tongue Weight ..............518
▫ Towing Requirements ..................519
▫ Towing Tips ........................ .525
 RECREATIONAL TOWING (BEHIND
MOTORHOME, ETC.) ...................527
▫ Towing This Vehicle Behind Another
Vehicle ............................ .527
414 STARTING AND OPERATING

STARTING PROCEDURES
Before starting your vehicle, adjust your seat, adjust both
inside and outside mirrors, and fasten your seat belts.
WARNING!
•Never use the PARK position as a substitute for the
parking brake. Always apply the parking brake
fully when parked to guard against vehicle move-
ment and possible injury or damage.
• When leaving the vehicle, always remove the key
fob from the ignition and lock your vehicle. If
equipped with Keyless Enter-N-Go, always make
sure the keyless ignition node is in “OFF” mode,
remove the Key Fob from the vehicle and lock the
vehicle.
• Never leave children alone in a vehicle, or with
access to an unlocked vehicle. Allowing children to
(Continued)
WARNING! (Continued)
be in a vehicle unattended is dangerous for a
number of reasons. A child or others could be
seriously or fatally injured. Children should be
warned not to touch the parking brake, brake pedal
or the transmission gear selector.
• Do not leave the Key Fob in or near the vehicle (or
in a location accessible to children), and do not
leave the ignition of a vehicle equipped with
Keyless Enter-N-Go in the ON/RUN mode. A child
could operate power windows, other controls, or
move the vehicle.
Manual Transmission — If Equipped
Before starting the engine fully apply the parking brake,
press the clutch pedal to the floor, and place the shift
lever in NEUTRAL.
5
STARTING AND OPERATING 415

NOTE:
•The engine will not start unless the clutch pedal is
pressed to the floor.
• If the key will not turn and the steering wheel is
locked, rotate the wheel in either direction to relieve
pressure on the locking mechanism and then turn the
key.
Automatic Transmission — If Equipped
The shift lever must be in the PARK or NEUTRAL
position before you can start the engine. Press the brake
pedal before shifting to any driving gear.
NOTE: You must press the brake pedal before shifting
out of PARK.
Keyless Enter-N-Go
This feature allows the driver to oper-
ate the ignition switch with the push
of a button, as long as the Remote
Keyless Entry (RKE) transmitter is in
the passenger compartment.
Normal Starting
Using The ENGINE START/STOP Button
1. The transmission must be in PARK or NEUTRAL.
2. Press and hold the brake pedal while pushing the ENGINE START/STOP button once.
3. The system takes over and attempts to start the vehicle. If the vehicle fails to start, the starter will
disengage automatically after 10 seconds.
416 STARTING AND OPERATING

4. If you wish to stop the cranking of the engine prior tothe engine starting, push the button again.
NOTE: Normal starting of either a cold or a warm engine
is obtained without pumping or pressing the accelerator
pedal.
To Turn Off The Engine Using ENGINE
START/STOP Button
1. Place the shift lever/gear selector in PARK, then push and release the ENGINE START/STOP button.
2. The ignition switch will return to the OFF position.
3. If the shift lever/gear selector is not in PARK, the ENGINE START/STOP button must be held for two
seconds or three short pushes in a row with the vehicle
speed above 5 mph (8 km/h) before the engine will
shut off. The ignition switch position will remain in
the ACC position until the shift lever/gear selector is
in PARK and the button is pushed twice to the OFF position. If the shift lever/gear selector is not in PARK
and the ENGINE START/STOP button is pushed
once, the EVIC/DID will display a “Vehicle Not In
Park” message and the engine will remain running.
Never leave a vehicle out of the PARK position, or it
could roll.
NOTE: If the ignition switch is left in the ACC or RUN
(engine not running) position and the transmission is in
PARK, the system will automatically time out after 30
minutes of inactivity and the ignition will switch to the
OFF position.
ENGINE START/STOP Button Functions — With
Driver ’s Foot OFF The Brake Pedal (In PARK Or
NEUTRAL Position)
The ENGINE START/STOP button operates similar to an
ignition switch. It has four positions, OFF, ACC, RUN
5
STARTING AND OPERATING 417

and START. To change the ignition positions without
starting the vehicle and use the accessories follow these
steps:
•Starting with the ignition in the OFF position.
• Push the ENGINE START/STOP button once to place
the ignition to the ACC position (EVIC/DID will
display “ACC”).
• Push the ENGINE START/STOP button a second time
to place the ignition to the RUN position (EVIC/DID
will display “ON/RUN”).
• Push the ENGINE START/STOP button a third time to
return the ignition to the OFF position (EVIC/DID will
display “OFF”).
Extreme Cold Weather (Below –20°F or 29°C)
To ensure reliable starting under extreme cold conditions
an externally powered electric block heater (available from your authorized dealer) is required for the 1.4L
Turbo engine below -20°F (-29°C) and for the 2.4L engine
below -29°F (-34°C) and is recommended for the 2.0L
engine and 2.4L engine below -20°F (-29°C).
Extended Park Starting
NOTE:
Extended Park condition occurs when the vehicle
has not been started or driven for at least 30 days.
1. Install a battery charger or jumper cables to the battery to ensure a full battery charge during the crank cycle.
2. Cycle the ignition in the START position and release it when the engine starts.
3. If the engine fails to start within ten seconds, cycle the ignition to the STOP (OFF/LOCK) position, wait five
seconds to allow the starter to cool, then repeat the
Extended Park Starting procedure.
418 STARTING AND OPERATING