key DODGE DURANGO 2006 2.G Workshop Manual

2. Shut engine OFF.
3. Turn the ignition key to the ON position without
starting the engine.
4. Depress brake pedal.
5. Shift automatic transmission to Neutral (N).
6. Using the point of a ballpoint pen or similar object,
depress the recessed transfer case Neutral (N) button for
4 seconds.
7. After shift is completed and the Neutral (N) light
comes on release Neutral (N) button.
8. Start engine.
9. Shift automatic transmission into Reverse (R).
10. Release brake pedal for five seconds and ensure that
there is no vehicle movement.11. Repeat steps 9 and 10 with the transmission in Drive
(D).
12. Turn ignition key to the unlocked OFF position.
13. Shift automatic transmission into Park (P).
14. Attach vehicle to tow vehicle with tow bar.
NOTE:Items 1 through 5 are requirements that must be
met prior to depressing the Neutral (N) selection button,
and must continue to be met until the 4 seconds elaspes
and the shift has been completed.
If any of these requirements (with the exception of3-Key
ON) are not met prior to depressing the Neutral (N)
button or are no longer met during the 4 second timer,
then the Neutral (N) indicator light will flash continu-
ously until all requirements are met or until the Neutral
(N) button is released.
310 STARTING AND OPERATING

NOTE:The ignition key must be ON for a shift to take
place and for the position indicator lights to be operable.
If the key is not ON, the shift will not take place and no
position indicator lights will be on or flashing.
CAUTION!
Damage to the transmission may occur if the trans-
mission is shifted into Park (P) with the transfer case
in Neutral (N) and the engine RUNNING. With the
transfer case in Neutral (N) ensure that the engine is
OFF prior to shifting the transmission into Park (P)
Shifting OUT of Neutral (N)
Use the following procedure to prepare your vehicle for
normal usage.
1. Bring vehicle to a complete stop.
2. Shut engine OFF.3. Turn the ignition key to the ON position without
starting the engine.
4. Depress brake pedal.
5. Shift automatic transmission to Neutral (N).
6. Using the point of a ballpoint pen or similar object,
depress the recessed transfer case Neutral (N) button for
1 second.
7. After the Neutral (N) indicator light turns off release
the Neutral (N) button.
8. After the Neutral (N) button has been released the
transfer case will shift to the position identified by the
selector switch.
9. Shift automatic transmission into Park (P).
10. Start the engine.
11. Shift automatic transmission into Drive (D).
STARTING AND OPERATING 311
5

NOTE:Items 1 through 5 are requirements that must be
met prior to depressing the Neutral (N) selection button,
and must continue to be met until 1 second elapses and
the shift has been completed.
If any of these requirements are not met prior to depress-
ing the Neutral (N) button or are no longer met during
the 1 second time, then all of the position indicator lights
will flash continuously until all requirements are met or
until the Neutral (N) button is released.
NOTE:The ignition key must be ON for a shift to take
place and for the position indicator lights to be operable.
If the key is not On, the shift will not take place and no
position indicator lights will be on or flashing.
NOTE:Flashing neutral (N) position indicator light
indicates that shift requirements have not been met.CAUTION!
•Do not use a bumper mounted clamp-on tow bar
on your vehicle. The bumper face bar will be
damaged.
•Do not disconnect the rear driveshaft because
fluid will leak from the transfer case and damage
internal parts.
TRACTION
When driving on wet or slushy roads, it is possible for a
wedge of water to build up between the tire and road
surface. This is known as hydroplaning and may cause
partial or complete loss of vehicle control and stopping
ability. To reduce this possibility, the following precau-
tions should be observed:
1. Slow down during rainstorms or when roads are
slushy.
312 STARTING AND OPERATING

HAZARD WARNING FLASHER
The flasher switch is on the top of the steering column,
just behind the steering wheel. Press the flasher switch
and all front and rear directional signals will flash
intermittently.
Press the switch a second time to turn off the emergency
flashers.This is an emergency warning system and should not be
used when the vehicle is in motion. Use it when your
vehicle is disabled and is creating a safety hazard for
other motorists.
If it is necessary to leave the vehicle to go for service, the
flasher system will continue to operate with the ignition
key removed and the vehicle locked.
ADDING FUEL
If using a portable fuel container, it should have a flexible
nozzle long enough to reach past the restriction in the
fuel filler tube.
316 WHAT TO DO IN EMERGENCIES

Four-Wheel Drive Vehicles
The manufacturer recommends towing with all wheels
OFFthe ground. Acceptable methods are to tow the
vehicle on a flatbed or with one end of the vehicle raised
and the opposite end on a towing dolly.
Two-Wheel Drive Vehicles
Provided that the transmission is operable, tow with the
transmission in Neutral and the ignition key in the OFF
position along with the front wheels raised and the rear
wheels on the ground. The speed must not exceed 30
mph (50 km/h) and the distance must not exceed 15
miles (25 km).If the vehicle is to be towed more than 15 miles (25 km )
or faster than 30 mph, it must be towed on a flatbed, or
with the rear wheels raised and the front wheels on the
ground, or with the front end raised and the rear wheels
on a towing dolly.
NOTE:Towing the vehicle, with the rear wheels on the
ground, at more than 30 mph (50 km/h) or for more than
15 miles (25 km ) can cause severe transmission damage.
WHAT TO DO IN EMERGENCIES 329
6

cap until aclickingsound is heard. This is an indication
that the gas cap is properly tightened. Press the odometer
reset button to turn the message off. If the problem
persists, the message will appear the next time the
vehicle is started. This might indicate a damaged cap. If
the problem is detected twice in a row, the system will
turn on the Malfunction Indicator Light (MIL). Resolving
the problem will turn the MIL light off.
EMISSIONS INSPECTION AND MAINTENANCE
PROGRAMS
In some localities, it may be a legal requirement to pass
an inspection of your vehicle’s emissions control system.
Failure to pass could prevent vehicle registration.
For states which have an I/M (Inspection and
Maintenance) requirement, this check verifies the
following: the MIL (Malfunction Indicator Lamp)is functioning and is not on when the engine is running,
and that the OBD (On Board Diagnostic) system is ready
for testing.
Normally, the OBD system will be ready. The OBD
system maynotbe ready if your vehicle was recently
serviced, if you recently had a dead battery, or a battery
replacement. If the OBD system is determined not ready
for the I/M test, your vehicle may fail the test.
Your vehicle has a simple ignition key actuated test
which you can use prior to going to the test station. To
check if your vehicle’s OBD system is ready, you must do
the following:
1. Insert your ignition key into the ignition switch.
2. Turn the ignition to the ON position, but do not crank
or start the engine. If you crank or start the engine, you
will have to start this test over.
338 MAINTAINING YOUR VEHICLE

3. As soon as you turn your key to the ON position, you
will see your MIL symbol come on as part of a normal
bulb check.
4. Approximately 15 seconds later, one of two things will
happen:
a. The MIL light will blink for approximately 5 sec-
onds and then remain on until the first engine crank or
the key is turned off. This means that your vehicle’s
OBD system isnot readyand you shouldnotproceed
to the I/M station.
b. The MIL light will remain fully illuminated until the
first engine crank or the key is turned off. This means
that your vehicle’s OBD system isreadyand you can
proceed to the I/M station.
If your OBD system isnot readyyou should see your
dealer or repair facility. If your vehicle was recently
serviced or had a battery failure or replacement, you mayneed to do nothing more than drive your vehicle as you
normally would in order for your OBD system to update.
A recheck with the above test routine may then indicate
that the system is now ready.
Regardless of whether your vehicle’s OBD system is
ready or not ready, if the MIL symbol is illuminated
during normal vehicle operation, you should have your
vehicle serviced before going to the I/M station. The I/M
station can fail your vehicle because the MIL symbol is on
with the engine running.
REPLACEMENT PARTS
Use of genuine Moparparts for normal/scheduled
maintenance and repairs is highly recommended to in-
sure the designed performance. Damage or failures
caused by the use of non-Moparparts for maintenance
and repairs will not be covered by the manufacturer’s
warranty.
MAINTAINING YOUR VEHICLE 339
7

Cavity Mini Fuse/Color Description
F11 10 Amp Red Heated Mirrors
F12 20 Amp Yellow Cluster Battery Feed
F13 10 Amp RedIgnition Run HVAC
Module/Heated Rear Glass
(EBL) Relay
F14 10 Amp Red ABS Module Ignition Run
F15 15 Amp BlueBattery Feed Blue Tooth,
Compass/Trip Computer
(CMTC), Sentry Key Diag-
nostics
F16 20 Amp YellowReconfigurable Power Out-
lets
F17 20 Amp Yellow Cigar Lighter Ignition
F18 10 Amp Red Spare Fuse
F19 15 Amp BlueHeating & Air Conditioning
w/ATC Only Battery Feed
F20 25 Amp Natural Amplifier Battery FeedUnderhood Fuses (Power Distribution Center)
CavityCartridge
Fuse / RelayMini Fuse Description
1 30 Amp Pink Starter
2 30 Amp Pink Front Wiper
3 40 Amp Green Brake Batt
4 30 Amp Pink JB Feed Acc #
2
5 40 Amp Green Power Seats
6 20 Amp Blue JB Feed Ign #
1
7 40 Amp Green JB Feed Ign #
2
8 40 Amp Green JB Feed Acc
Delay
9 Spare
10 30 Amp Pink ASD
11 40 Amp Green Power Liftgate
( If Equipped)
MAINTAINING YOUR VEHICLE 373
7

Ball Joints............................. 351
Battery............................... 348
Charging............................ 325
Emergency Starting..................... 325
Gas Caution.......................... 325
Keyless Transmitter Replacement (RKE)....... 26
Saving Feature (Protection)............... 132
Belts, Drive............................ 345
Belts, Seat.............................. 37
Body Mechanism Lubrication............... 351
B-Pillar Location........................ 269
Brake Assist System...................139,147
Brake Control System, Electronic............. 146
Brake Fluid............................ 387
Brake System........................260,360
Anti-Lock (ABS)....................146,260
Disc Brakes.......................... 360
Fluid Check.......................... 360
Hoses.............................. 361Master Cylinder....................... 360
Parking............................. 258
Warning Light.....................186,189
Brakes............................... 260
Brake/Transmission Interlock............... 245
Break-In Recommendations, New Vehicle........ 74
Bulb Replacement....................... 377
Bulbs, Light............................ 376
Calibration, Compass..................... 159
Capacities, Fluid........................ 385
Caps, Filler
Fuel.............................287,288
Oil (Engine).......................... 343
Power Steering........................ 350
Radiator (Coolant Pressure)............... 354
Car Washes............................ 367
Carbon Monoxide Warning............75,163,290
Cargo Management System................. 176
INDEX 421
10

Gasoline, Reformulated................... 286
Gauges
Coolant Temperature.................... 183
Fuel................................ 183
Odometer........................... 187
Speedometer......................... 185
Tachometer.......................... 186
Gear Ranges........................... 245
Glass Cleaning.......................... 369
Grease............................... 365
Gross Axle Weight Rating...............293,297
Gross Cargo Weight...................... 292
Gross Vehicle Weight Rating................ 296
GVWR............................293,295
Hands-Free Phone (UConnect™).............. 88
Hazard Warning Flasher................... 316
Headlights............................ 377
Delay.............................. 133High Beam........................... 137
High Beam/Low Beam Select Switch........ 137
Lights On Reminder.................... 135
Passing............................. 136
Replacing............................ 377
Heated Mirrors.......................... 87
Heated Seats........................... 115
Heater............................... 222
Heater, Engine Block..................... 244
High Beam Indicator..................... 184
High Beam/Low Beam Select (Dimmer) Switch . . 137
Hitches
Trailer Towing........................ 298
HomeLink(Garage Door Opener) Transmitter . . . 162
Hood Release.......................... 129
Hoses................................ 359
Ignition............................... 13
Key ................................. 10
426 INDEX