wheel torque DODGE DURANGO SRT 2019 User Guide

Page 384 of 572

5. After 25 miles (40 km), check the lug nut torque with atorque wrench to ensure that all lug nuts are properly
seated against the wheel.
JUMP STARTING
If your vehicle has a discharged battery, it can be jump
started using a set of jumper cables and a battery in another
vehicle, or by using a portable battery booster pack. Jump
starting can be dangerous if done improperly, so please
follow the procedures in this section carefully.
WARNING!
Do not attempt jump starting if the battery is frozen. It
could rupture or explode and cause personal injury.
CAUTION!
Do not use a portable battery booster pack or any other
booster source with a system voltage greater than 12
Volts or damage to the battery, starter motor, alternator
or electrical system may occur.
NOTE: When using a portable battery booster pack, follow
the manufacturer’s operating instructions and precautions.
Preparations For Jump Start
The battery in your vehicle is located under the passenger’s
front seat. There are remote terminals located under the
hood to assist in jump starting.
Jump Starting Locations
(+) — Remote Positive Post (Covered With Protective Cap)
(-) — Remote Negative Post
382 IN CASE OF EMERGENCY

Page 455 of 572

TECHNICAL SPECIFICATIONS
CONTENTS
IDENTIFICATION DATA ...................454
▫ Vehicle Identification Number .............454
 BRAKE SYSTEM ....................... .455
 WHEEL AND TIRE TORQUE SPECIFICATIONS . .455
▫ Torque Specifications ....................455
 FUEL REQUIREMENTS ...................457
▫ 6.4L Engine .......................... .457
▫ Reformulated Gasoline ..................457
▫ Materials Added To Fuel .................457
▫ Gasoline/Oxygenate Blends ...............458 ▫
Do Not Use E-85 In Non-Flex Fuel Vehicles . . . .458
▫ CNG And LP Fuel System Modifications ......459
▫ MMT In Gasoline ...................... .459
▫ Fuel System Cautions ....................459
▫ Carbon Monoxide Warnings ...............460
 FLUID CAPACITIES ..................... .460
 FLUIDS AND LUBRICANTS ................461
▫ Engine ............................. .461
▫ Chassis ............................ .462
9

Page 457 of 572

NOTE:It is illegal to remove or alter the VIN.
BRAKE SYSTEM
Your vehicle is equipped with dual hydraulic brake sys-
tems. If either of the two hydraulic systems loses normal
capability, the remaining system will still function. How-
ever, there will be some loss of overall braking effective-
ness. You may notice increased pedal travel during appli-
cation, greater pedal force required to slow or stop, and
potential activation of the Brake Warning Light. In the event power assist is lost for any reason (i.e.,
repeated brake applications with the engine OFF) the
brakes will still function. However, the effort required to
brake the vehicle will be much greater than that required
with the power system operating.
NOTE:
Due to the performance nature of our brake sys-
tems, some noise is to be expected.
WHEEL AND TIRE TORQUE SPECIFICATIONS
Proper lug nut/bolt torque is very important to ensure that
the wheel is properly mounted to the vehicle. Any time a
wheel has been removed and reinstalled on the vehicle, the
lug nuts/bolts should be torqued using a properly cali-
brated torque wrench using a high quality six sided (hex)
deep wall socket.
Torque Specifications
Lug Nut/Bolt Torque **Lug Nut/Bolt
Size Lug Nut/Bolt
Socket Size
110 Ft-Lbs (149 N·m) M14 x 1.50 22 mm
**Use only your authorized dealer recommended lug nuts/
bolts and clean or remove any dirt or oil before tightening.
Right Front Body VIN Location
9
TECHNICAL SPECIFICATIONS 455

Page 458 of 572

Inspect the wheel mounting surface prior to mounting the
tire and remove any corrosion or loose particles.
Tighten the lug nuts/bolts in a star pattern until each
nut/bolt has been tightened twice. Ensure that the socket is
fully engaged on the lug nut/bolt (do not insert it half
way).
NOTE:If in doubt about the correct tightness, have them
checked with a torque wrench by your authorized dealer or
service station. After 25 miles (40 km), check the lug nut/bolt torque to be
sure that all the lug nuts/bolts are properly seated against
the wheel.
WARNING!
To avoid the risk of forcing the vehicle off the jack, do
not tighten the lug nuts/bolts fully until the vehicle has
been lowered. Failure to follow this warning may
result in personal injury.
Wheel Mounting Surface
Torque Patterns
456 TECHNICAL SPECIFICATIONS

Page 568 of 572

Power............................... .281
Tilt Column .............................64
Wheel, Heated ...........................65
Wheel, Tilt ..............................64
Steering Wheel Audio Controls .................512
Steering Wheel Mounted Sound System Controls . . . .512
Storage ..................................115
Door .................................115
Storage, Vehicle .............................96
Sunglasses Storage ......................... .128
Sun Roof ............................ .101, 103
Sunshade Operation ........................ .102
Sun Visor .................................69
Sway Control, Trailer ....................... .179
Synthetic Engine Oil ....................... .402
System, Remote Starting ......................27
Telescoping Steering Column ...................64
Temperature Control, Automatic (ATC) ............94
Tie Down Hooks, Cargo ..................... .108
Tilt Steering Column .........................64
Tire And Loading Information Placard ............429
Tire Markings ............................ .424
Tires......................... .253, 433, 440, 445
Aging (Life Of Tires) ..................... .437Air Pressure
........................... .433
Chains ............................... .444
Changing ...................... .371, 381, 423
Compact Spare ......................... .441
Flat Changing .......................... .381
General Information ...................433, 440
High Speed ............................ .435
Inflation Pressure ....................... .434
Jacking ............................... .423
Life Of Tires ........................... .437
Load Capacity ...................... .429, 430
Pressure Monitoring System (TPMS) ........160, 191
Quality Grading ........................ .445
Radial ............................... .435
Replacement ........................ .381,
438
Rotation .............................. .444
Safety ............................ .424, 433
Sizes ................................ .425
Snow Tires ............................ .440
Spare Tires ..................... .372, 440, 442
Spinning .............................. .436
Trailer Towing .......................... .342
Tread Wear Indicators .....................436
Wheel Mounting ........................ .381
Wheel Nut Torque ....................... .455
566 INDEX

Page:   < prev 1-10 11-20