DODGE RAM 1500 GAS 2007 3.G Owners Manual

Miles 123,000 126,000 129,000 132,000 135,000 138,000
(Kilometers) (198 000) (203 000) (208 000) (212 000) (217 000) (222 000)
Change engine oil and engine oil filter at inter-
val shown or 3 months, whichever comes first.X X XXXX
Lubricate Front Drive Shaft Fitting (2500/3500,
4X4).X X XXXX
Rotate tires. X X X
Check spare tire for proper pressure and cor-
rect stowage.XXX
Lubricate outer tie rod ends 2500/3500 (4X4)
models only.XXX
Change front and rear axle fluid (4X4). X
Inspect brake linings. X
Inspect engine air cleaner filter, replace if
necessary.X
Inspect auto tension drive belt and replace if
required (3.7L/4.7L/5.7L).X
SCHEDULE “B” 531
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S

Miles 141,000 144,000 147,000 150,000
(Kilometers) (227 000) (232 000) (237 000) (241 000)
Change engine oil and engine oil filter at interval shown
or 3 months, whichever comes first.XXXX
Lubricate Front Drive Shaft Fitting (2500/3500, 4X4). X X X X
Rotate tires. X X
Check spare tire for proper pressure and correct stowage. X X
Lubricate outer tie rod ends 2500/3500 (4X4) models only. X X
Drain and refill transfer case fluid (4X4). X
Change front and rear axle fluid (4X4). X
Inspect brake linings. X
Inspect engine air cleaner filter, replace if necessary.X
Replace spark plugs.X
Inspect PCV valve, replace as necessary. **X
Inspect auto tension drive belt and replace if required
(3.7L/4.7L/5.7L).X
532 SCHEDULE “B”
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S

Miles 141,000 144,000 147,000 150,000
(Kilometers) (227 000) (232 000) (237 000) (241 000)
Drain and refill automatic transmission fluid and change
main sump and spin-on cooler return filter (if equipped)*.X
Flush and replace engine coolant if not replaced at
120,000 miles (193 000 km).X
* This applies only if the vehicle is used for frequent
trailer towing, snowplowing, fleet vehicle or commercial
service.
** This maintenance is recommended by the manufac-
turer to the owner, but not required to maintain the
emissions warranty.**** This maintenance is not required if the belt was
previously replaced.
Inspection and service should also be performed anytime
a malfunction is observed or suspected. Retain all re-
ceipts.
SCHEDULE “B” 533
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S

Schedule “A”
Miles 6,000 12,000 18,000 24,000 30,000
(Kilometers) (10 000) (19 000) (29 000) (39 000) (48 000)
[Months] [6] [12] [18] [24] [30]
Change engine oil and engine oil filter. X X X X X
Rotate tires. X X X X X
Check spare tire for proper pressure and correct
stowage.X X XXX
Check transfer case fluid level (4X4).X
Lubricate Front Drive Shaft Fitting (2500/3500, 4X4). X X X X X
Lubricate outer tie rod ends 2500/3500 (4X4) models
only.X X XXX
Inspect brake linings. X
Inspect engine air cleaner filter, replace if neces-
sary.X
Replace spark plugs.X
534 SCHEDULE “A”
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S

Miles 36,000 42,000 48,000 54,000 60,000 66,000
(Kilometers) (58 000) (68 000) (77 000) (87 000) (97 00) (106 000)
[Months] [36] [42] [48] [54] [60] [66]
Change engine oil and engine oil filter. X X X X X X
Rotate tires. X X X X X X
Check spare tire for proper pressure and correct
stowage.XXXXXX
Check transfer case fluid level (4X4). X
Lubricate Front Drive Shaft Fitting (2500/3500, 4X4).XXXXXX
Lubricate outer tie rod ends 2500/3500 (4X4) mod-
els only.XXXXXX
Flush and replace engine coolant at 60 months, if
not replaced at 102,000 miles (170 000 km).X
Inspect brake linings. X X
Inspect engine air cleaner filter, replace if neces-
sary.X
Replace spark plugs.X
Inspect PCV valve, replace as necessary. **X
SCHEDULE “A” 535
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S

Miles 72,000 78,000 84,000 90,000 96,000
(Kilometers) (116 000) (126 000) (135 000) (145 000) (154 000)
[Months] [72] [78] [84] [90] [96]
Change engine oil and engine oil filter. X X X X X
Rotate tires. X X X X X
Check spare tire for proper pressure and correct stow-
age.X X XXX
Lubricate outer tie rod ends 2500/3500 (4X4) models
only.X X XXX
Check transfer case fluid level (4X4). X
Lubricate Front Drive Shaft Fitting (2500/3500, 4X4). X X X X X
Inspect brake linings. X X
Inspect engine air cleaner filter, replace if necessary.X
Replace spark plugs.X
Inspect PCV valve, replace as necessary. **X
Inspect auto tension drive belt and replace if required
(3.7L/4.7L/5.7L).X
536 SCHEDULE “A”
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S

Miles 102,000 108,000 114,000 120,000
(Kilometers) (164 000) (174 000) (183 000) (193 000)
[Months] [102] [108] [114] [120]
Change engine oil and engine oil filter. X X X X
Rotate tires. X X X X
Check spare tire for proper pressure and correct stowage. X X X X
Drain and refill transfer case fluid (4X4). X
Lubricate Front Drive Shaft Fitting (2500/3500, 4X4). X X X X
Flush and replace engine coolant, if not replaced at 60 months. X
Flush and replace engine coolant if not replaced at 102,00
miles (164 000 km/h).X
Lubricate outer tie rod ends 2500/3500 (4X4) models only. X X X X
Inspect brake linings. X
Inspect auto tension drive belt and replace if required (3.7L/
4.7L/5.7L).****XX
Inspect engine air cleaner filter, replace if necessary.X
Replace spark plugs.X
Inspect PCV Valve, replace as necessary. **X
SCHEDULE “A” 537
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S

Miles 126,000 132,000 138,000 144,000 150,000
(Kilometers) (203 000) (212 000) (222 000) (232 000) (241 000)
[Months] [126] [132] [138] [144] [150]
Change engine oil and engine oil filter. X X X X X
Rotate tires. X X X X X
Check spare tire for proper pressure and correct
stowage.X X XXX
Drain and refill transfer case fluid (4X4). X
Lubricate Front Drive Shaft Fitting (2500/3500,
4X4).X X XXX
Flush and replace engine coolant, if not replaced at
120,000 miles (193 000 km).X
Lubricate outer tie rod ends 2500/3500 (4X4) mod-
els only.X X XXX
Inspect brake linings. X X
Inspect auto tension drive belt and replace if re-
quired (3.7L/4.7L/5.7L).****X
538 SCHEDULE “A”
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S

Miles 126,000 132,000 138,000 144,000 150,000
(Kilometers) (203 000) (212 000) (222 000) (232 000) (241 000)
[Months] [126] [132] [138] [144] [150]
Inspect engine air cleaner filter, replace if neces-
sary.X
Replace spark plugs.X
Inspect PCV Valve, replace as necessary. **X
** This maintenance is recommended by the manufac-
turer to the owner, but not required to maintain the
emissions warranty.
**** This maintenance is not required if the belt was
previously replaced.
Inspection and service should also be performed anytime
a malfunction is observed or suspected. Retain all re-
ceipts.
WARNING!
You can be badly injured working on or around a
motor vehicle. Do only that service work for which
you have the knowledge and the right equipment. If
you have any doubt about your ability to perform a
service job, take your vehicle to a competent me-
chanic.
SCHEDULE “A” 539
8
M
A
I
N
T
E
N
A
N
C
E
S
C
H
E
D
U
L
E
S