FIAT 500 2013 2.G Owners Manual
Page 421 of 423
UCI Connector...........................204
Uniform Tire Quality Grades.................401
Universal Consumer Interface (UCI) Connector . . . .204
Unleaded Gasoline........................285
Untwisting Procedure, Seat Belt................37
Vehicle Identification Number (VIN).............7
Vehicle Loading..........................264
Vehicle Modifications/Alterations...............8
Vehicle Storage...........................217
Wait to Start Light.........................148
Warning Lights (Instrument Cluster Description) . . .148
Warnings and Cautions.......................7
Warranty Information........................4
Washer
Adding Fluid..........................353
Washers, Windshield.......................117
Washing Vehicle..........................368
Water
Driving Through........................240
Wheel and Wheel Trim.....................369
Wheel and Wheel Trim Care.................369
Wind Buffeting............................27
Window Fogging.........................216
Windows................................26
Power................................26
Windshield Defroster.......................81
Windshield Washers.......................117
Windshield Wiper Blades....................350
Windshield Wipers........................117
Wiper Blade Replacement...................350
10
INDEX 419
Page 422 of 423
INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped.
The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.
Page 423 of 423
Chrysler Group LLCOWNER’S MANUAL
2013
2013 FIAT 500
13FF500-126-AEFifth Edition Rev 1Printed in U.S.A.
FIAT 500