FIAT 500 ABARTH 2016 2.G Owners Manual
Page 431 of 432
INSTALLATION OF RADIO TRANSMITTING
EQUIPMENTSpecial design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped.The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.
Page 432 of 432
OWNER’S MANUAL
2016
2016 FIAT
® 500 ABARTH
FIAT
®
500 ABARTH
INCLUDES CABRIO
Fourth Edition
Printed in U.S.A.
©2016 FCA US LLC. All Rights Reserved.
FIAT, ABARTH and scorpion design are registered
trademarks used under license by FCA US LLC. 16FX24-126-AD