fuse FIAT 500L 2015 2.G User Guide

Interior Fuses
The interior fuse panel is part of the Body Control
Module (BCM) and is located on the driver’s side under
the instrument panel.
Rear Interior Fuses
The rear interior fuse panel is located on the driver’s side
in the rear compartment.
Interior Fuse Panel
Rear Fuse Panel
388 MAINTAINING YOUR VEHICLE

Filters
Air Cleaner...........................352
Air Conditioning.......................356
Engine Fuel...........................398
Engine Oil............................352
Engine Oil Disposal.....................352
Flashers
Turn Signal............................87
Flooded Engine Starting....................226
Fluid, Brake.............................400
Fluid Capacities..........................397
Fluid Leaks..............................87
Fluid Level Checks
Automatic Transmission..................376
Fluids, Lubricants and Genuine Parts...........398
Fog Lights..............................115
Fold and Tumble Rear Seat..................103
Freeing A Stuck Vehicle.....................337
Fuel...................................299
Adding..............................302
Additives.............................300
Capacity.............................397
Clean Air.............................299
Filler Cap (Gas Cap).....................169
Filler Door (Gas Cap)....................169
Gasoline..............................299
Gauge...............................169
Light................................169
Materials Added........................300
Octane Rating..........................299
Requirements..........................299
Tank Capacity..........................397
Fueling................................302
Fuses..................................384
Garage Door Opener (HomeLink®)............136
Gasoline, Clean Air........................299
Gasoline (Fuel)...........................299
10
INDEX 425

INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped.
The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.