mirror controls FIAT 500L 2017 2.G Owners Manual

To gain access to the conversation mirror, pull down-
ward on the mirror to the open position.Power Mirrors
The power mirror controls are located on the driver ’s
door trim panel. To adjust a mirror, turn the control
knob toward the left or right mirror positions indicated.
Tilt the control wand in the direction you want the
mirror to move. When you are finished adjusting the
mirror, turn the control to the center position to prevent
accidentally moving a mirror.
Conversation Mirror
Power Mirror Controls
76 UNDERSTANDING THE FEATURES OF YOUR VEHICLE

STARTING PROCEDURES
Before starting your vehicle, adjust your seat, adjust
both inside and outside mirrors, and fasten your seat
belts.
WARNING!
•Never leave children alone in a vehicle, or with
access to an unlocked vehicle.
• Allowing children to be in a vehicle unattended is
dangerous for a number of reasons. A child or
others could be seriously or fatally injured. Chil-
dren should be warned not to touch the parking
brake, brake pedal or the transmission gear selec-
tor.
• Do not leave the key fob in or near the vehicle (or
in a location accessible to children). A child could
operate power windows, other controls, or move
the vehicle.
Automatic Transmission
The gear selector must be in the PARK or NEUTRAL
position before you can start the engine. Depress the
brake pedal before shifting to any driving gear. NOTE:
You must press the brake pedal before shifting
out of PARK.
Normal Starting
NOTE: Normal starting of either a cold or a warm
engine is obtained without pumping or pressing the
accelerator pedal.
Turn the ignition switch to the AVV/ACC (START)
position and release it when the engine starts. If the
engine fails to start within 10 seconds, turn the ignition
switch to the STOP (OFF/LOCK) position, wait 10 to 15
seconds, then repeat the “Normal Starting” procedure.
Cold Weather Operation
To prevent possible engine damage while starting at
low temperatures, this vehicle will inhibit engine crank-
ing when the ambient temperature is less than –22°F
(–30°C) and the oil temperature sensor reading indi-
cates an engine block heater has not been used. An
externally powered electric engine block heater is avail-
able as a factory installed option.
The message “plug in engine heater” will be displayed
in the instrument cluster when the ambient temperature
is below 5°F (–15°C) at the time the engine is shut off as
218 STARTING AND OPERATING

Light...............................145
Materials Added .......................268
Methanol ............................267
Octane Rating ........................ .266
Requirements ........................ .266
Tank Capacity ........................339
Fueling ...............................269
Fuses .................................327
Garage Door Opener (HomeLink) .............110
Gasoline, Clean Air .......................266
Gasoline (Fuel) .......................266, 339
Gasoline, Reformulated .................266, 267
Gear Ranges ............................222
Gear Select Lever Override .................290
General Maintenance ..................... .302
Glass Cleaning ..........................326
Hazard Driving Through Flowing, Rising, Or Shallow
Standing Water ........................229
Headlights ..............................91
Cleaning ............................325
Passing ..............................91
Heated Mirrors ...........................77 Hill Start Assist
........................ .234
Holder, Cup ............................120
HomeLink (Garage Door Opener) .............110
Hood Release ............................89
Ignition Key.................................11
Immobilizer (Sentry Key) ...................13
Inside Rearview Mirror .....................74
Instrument Cluster .................134, 139, 150
Instrument Cluster Display Instrument Cluster Display ...............152
Instrument Panel And Controls ..............133
Instrument Panel Cover ....................326
Instrument Panel Lens Cleaning ..............326
Interior Appearance Care ...................325
Interior Lighting ..........................93
Introduction .............................4
Jacking Instructions .......................282
Jack Location .......................... .280
Jack

Operation .......................280, 282
Jump Starting .......................... .286
Key-In Reminder .........................13
360 INDEX