wipers FORD CROWN VICTORIA 2000 2.G Owners Manual

Page 64 of 224

TURN SIGNAL CONTROL
•Push down to activate the left
turn signal.
•Push up to activate the right turn
signal.
The flash rate of the turn signal will speed up considerably if the
Lighting Control Module detects a left or right turn lamp bulb (front or
rear) is burned out.
WINDSHIELD WIPER/WASHER CONTROLS
Rotate the windshield wiper control
to the desired interval, low or high
speed position.
The bars of varying length are for
intermittent wipers. When in this
position rotate the control upward
for fast intervals and downward for
slow intervals.
Push the control on the end of the
stalk to activate washer. Push and
hold for a longer wash cycle. The
washer will automatically shut off
after ten seconds of continuous use.
HI
LO
F
S
OFF
HI
LO
F
S
OFF
HI
LO
F
S
OFF
Controls and features
64

Page 174 of 224

6. Install a new air filter element. Be
careful not to crimp the filter
element edges between the air filter
housing and cover. This could cause
filter damage and allow unfiltered
air to enter the engine if not
properly seated.
7. Replace the air filter housing cover and secure the clamps.
8. Replace the air inlet tube and secure the clamp.
Failure to use the correct air filter element may result in severe
engine damage. The customer warranty may be voided for any
damage to the engine if the correct air filter element is not used.
WINDSHIELD WIPER BLADES
Check the wiper blades at least twice a year or when they seem less
effective. Substances such as tree sap and some hot wax treatments used
by commercial car washes reduce the effectiveness of wiper blades.
Checking the wiper blades
If the wiper blades do not wipe properly, clean both the windshield and
wiper blades using undiluted windshield wiper solution or a mild
detergent. Rinse thoroughly with clean water. To avoid damaging the
blades, do not use fuel, kerosene, paint thinner or other solvents.
Changing the wiper blades
To make changing the wiper blades easy, turn the ignition to ACC, then
turn the wipers on. When the wipers reach the vertical position, turn the
ignition to LOCK.
Maintenance and care
174

Page 223 of 224

Specification chart,
lubricants ............................202,204
Speed control ..............................66
Speedometer ...............................16
Starting your vehicle .........118,120
jump starting ..........................148
Steering
speed sensitive .......................126
Steering wheel
tilting .........................................65
Tilt steering wheel ......................65
Tires ......................144,175,176,177
changing ...........................144,145
checking the pressure ............177
replacing ..................................178
rotating ....................................177
snow tires and chains ............179
tire grades ...............................176
treadwear ................................176
Towing ................................133,177
recreational towing .................135
trailer towing ..........................133
wrecker ....................................153
Traction control ........................125
off light ......................................13
Traction-lok rear axle ...............130
Transmission .............................127fluid, checking and adding
(automatic) .............................168
fluid, refill capacities ..............201
lubricant specifications ...202,204
Trip odometer .............................18
Trunk ...........................................90
remote release .....................76,83
Turn signal .............................11,64
Vehicle dimensions ...................204
Vehicle Identification
Number (VIN) ...........................206
Vehicle loading ..........................131
Ventilating your vehicle ...........121
Warning chimes ......................14,15
Warning lights (see Lights) .........8
Washer fluid ..............................161
Water, Driving through .............136
Windows
power .........................................76
Windshield washer
fluid and wipers
checking and adding fluid .....161
checking and cleaning ............174
operation ...................................64
replacing wiper blades ...........174
Wrecker towing .........................153
Index
223