change time FORD FUSION 2010 User Guide

Checking automatic transmission fluid (6F35) (if equipped)
Refer to yourscheduled maintenance informationfor scheduled
intervals for fluid checks and changes. Your transmission does not
consume fluid. However, the fluid level should be checked if the
transmission is not working properly, i.e., if the transmission slips or
shifts slowly or if you notice some sign of fluid leakage.
Automatic transmission fluid expands when warmed. To obtain an
accurate fluid check, drive the vehicle until it is warmed up
(approximately 20 miles [30 km]). If your vehicle has been
operated for an extended period at high speeds, in city traffic
during hot weather or pulling a trailer, the vehicle should be
turned off for about 30 minutes to allow fluid to cool before
checking.
1. Drive the vehicle 20 miles (30 km) or until it reaches normal operating
temperature.
2. Park the vehicle on a level surface and engage the parking brake.
3. With the parking brake engaged and your foot on the brake pedal,
start the engine and move the gearshift lever through all of the gear
ranges. Allow sufficient time for each gear to engage.
4. Latch the gearshift lever in P (Park) and leave the engine running.
5. Remove the dipstick, wiping it clean with a clean, dry lint free rag. If
necessary, refer toIdentifying components in the engine compartment
in this chapter for the location of the dipstick.
6. Install the dipstick making sure it is fully seated in the filler tube.
7. Remove the dipstick and inspect the fluid level. The fluid should be in
the operating range for normal operating temperature.
Your vehicle is equipped with one of the following dipsticks.
Maintenance and Specifications
313
2010 Fusion(fsn)
Owners Guide, 4th Printing
USA(fus)
ProCarManuals.com

Item Capacity Ford part nameFord part number / Ford
specification
Fuel tank (FWD)17.5 gallons
(66.2L)——
Fuel tank (AWD)16.5 gallons
(62.4L)——
1Add the coolant type originally equipped in your vehicle.2Use of synthetic or synthetic blend motor oil is not mandatory. Engine oil need only meet the
requirements of Ford specification WSS-M2C930-A and the API Certification mark.3Service refill capacity is determined by filling the transmission within 3/8 inch (10mm) of the
bottom of the filler hole with the vehicle on a level surface.4Indicates only approximate dry-fill capacity. Some applications may vary based on cooler size and
if equipped with an in-tank cooler. The amount of transmission fluid and fluid level should be set
by the indication on the dipstick’s normal operating range.5The power transfer unit is lubricated for life with synthetic lube. Lubricant levels are not to be
checked or changed unless a leak is suspected or repair required. Replace power transfer unit
lubricant with specified synthetic lubricant anytime the unit is submerged in water.
See your authorized dealer for fluid level checking or filling of the power transfer unit.
Maintenance and Specifications
324
2010 Fusion(fsn)
Owners Guide, 4th Printing
USA(fus)
ProCarManuals.com

E
Electronic message center .........18
Emergencies, roadside
jump-starting ..........................253
running out of fuel .........252, 302
Emission control system ..........306
Engine ........................................325
cleaning ...................................269
coolant .....................................289
fail-safe cooling .......................294
idle speed control ...................287
lubrication specifications .......321
refill capacities ........................321
service points ..................277–279
starting after a collision .........238
Engine block heater .................201
Engine oil ..................................281
change oil soon warning,
message center .......................281
checking and adding ..............281
dipstick ....................................281
filter, specifications ........286, 320
recommendations ...................286
refill capacities ........................321
specifications ..........................321
Event data recording ....................7
Exhaust fumes ..........................201
F
Fail safe cooling ........................294
Flexible Fuel Vehicle (FFV) ....295
Fluid capacities .........................321
Fog lamps ....................................56
Four-Wheel Drive vehicles
driving off road .......................229
Fuel ............................................295calculating fuel
economy ............................20, 303
cap ...........................................298
capacity ...................................321
choosing the right fuel ...........300
comparisons with EPA fuel
economy estimates .................306
detergent in fuel .....................302
filler funnel .............................302
filling your vehicle
with fuel ..................295, 298, 303
filter, specifications ........295, 320
fuel pump shut-off ..................238
fuel pump shut-off switch .....238
improving fuel economy ........303
octane rating ...........300–301, 325
quality ......................................301
running out of fuel .........252, 302
safety information relating to
automotive fuels .....................295
Fuel - flex fuel vehicle
(FFV) .........................295, 300–301
Fuel pump shut-off switch .......238
Fuses ..................................239–240
G
Gas cap (see Fuel cap) ............298
Gas mileage (see Fuel
economy) ...................................303
Gauges .........................................16
H
Hazard flashers .........................237
Headlamps ...................................55
aiming ........................................58
autolamp system .......................55
bulb specifications ....................61
daytime running lights .............56
Index
336
2010 Fusion(fsn)
Owners Guide, 4th Printing
USA(fus)
ProCarManuals.com