trip computer FORD SIERRA 1982 1.G Bodywork And Fittings Workshop Manual

4Unclip the trim panel from the lower edge of
the lower facia panel.
5Remove the four securing screws and
withdraw the lower facia panel. Where
applicable, disconnect the loudspeaker
wiring.
6Refitting is a reversal of removal.
Passenger side lower facia panel
7Remove the two securing screws and
withdraw the side trim panel from the left-
hand side of the footwell.
8Remove the centre console to gain access
to the lower facia panel securing screws.
9Unclip the trim panel from the lower edge of
the lower facia panel.
10Unscrew the seven securing screws and
withdraw the lower facia panel. Disconnect
the wiring from the loudspeaker, glovebox
lamp, ashtray lamp, heater switch, cigarette
lighter, radio/cassette player, and
loudspeaker balance control, as applicable. It
is advisable to label the wiring plugs to assist
refitting in the correct positions.
11Refitting is a reversal of removal.
Upper facia panel
12Remove the lower facia panels as
described previously in this Section.13Remove the instrument panel (Chapter 13).
14Where applicable, remove the trip
computer and “door ajar” monitor.
15Remove the heater control panel.
16Prise out the front and rear foglamp, heated
rear window and heated windscreen switches
and the instrument light and intermittent wiper
rheostats, as applicable, from the upper facia
panel, and disconnect their wiring plugs. It is
advisable to label the wiring plugs to assist
refitting in the correct positions.
17Remove the five securing screws and
withdraw the upper facia panel through the
passenger door aperture. Disconnect the
heater vent hoses, and ensure that any
remaining wiring is disconnected and where
applicable unclipped from the facia panel.
18Refitting is a reversal of removal.
Models from 1992
19A restyled facia is fitted from 1992. The
procedures for removal and refitting of the
various panels are essentially as described
above, noting the following points(see
illustration).
Bodywork and fittings 12•17
1243.19 Facia components and securing screw locations (arrowed) - models from 1992
A Upper facia panel
B Passenger’s side lower facia panel
C Driver’s side lower facia panel
D Heater fan control cover and bezel
E Clock/auxiliary warning system displayF Instrument panel surround and screw covers
G Clock/auxiliary warning system display
surround
H Instrument cluster
J Instrument cluster surround
A Upper facia panel
B Passenger side lower facia panelC Driver’s side lower facia panel
43.1 Facia panel securing screw locations (arrowed)
43.2 Withdraw the side trim panel from the
footwell