engine GEELY FC 2008 Workshop Manual

Engine cover/automobile door--Trunk cover
Trunk cover
Adjustment
1. Check the clearance of trunk cover.
(a) Check whether following data is in standard value.
2. Adjust the clearance of trunk cover.
(a) If you want to make front and rear, left and right adjustment,
please loosen the bolt at first.
(b) If the front end of trunk cover needs to adjust vertically, please
increase or decrease the number of washers between hinge
and trunk cover.
Torque: 7.0 N
⋅ ⋅⋅ ⋅
⋅m
(c) Use the hammer and copper stick to knock lightly the locker
pedestal to adjust.
Torque: 5.5 N
⋅ ⋅⋅ ⋅
⋅m
 377 

Engine cover/automobile door--Torsion spring of trunk cover
Torsion spring of trunk cover
Change
Hint:
zWhen assembling, please work by the sequence which is opposite with disassembling
sequence; if necessary, it will have assembling instruction.
zChanging procedure for right side is same as the left side.
zFor torsion spring is disassembled, trunk cover does not have any tension, at this time, when
opening and closing trunk cover, it is necessary to support it with hand to prevent trunk cover
from closing for other resistances.
zTorsion spring I of trunk cover locates the upper end, and Torsion spring II of trunk cover
locates the lower end, so it is necessary to work from left side to right side when assembling;
but it is necessary to work by opposite sequence when disassembling.
1. Disassemble torsion spring of trunk cover
[68000100]
(a) Disassemble torsion spring I from middle bracket.
(b) Assemble special tool at the side of hinge.
(c) Push the special tool downwards, then pull trunk cover hinge
upwards from torsion spring I.
(d) Raise the special tool slowly, then use the special tool to
disassemble torsion spring I from the bracket.
(e) Disassemble torsion spring I from the bracket.
(f) Implement the work at the other side with same method.
2. Assemble torsion spring I of trunk cover [68000100]
(a) When assembling torsion spring I, it is necessary to as-
semble it on fixing clamp stably.
 378 
special tool

Electric injection control of engineElectrical schematic diagram--Electric injection control of engine 396