instrument panel GEELY MK 2008 User Guide

Interior & Exterior Trim and Accessory -Dashboard, Middle Console and Instrument Panel6-134. Remove the instrument cluster assembly
a. Unfasten 4 screws;
b. Disconnect the connector and unfasten the instrument cluster
assembly.
5. Remove the glove compartment assembly
a. Detach the glove compartment assembly by pressing the top
releaser;
b. Pull the glove compartment upward and then take it out.
6. Remove the right front pillar trim panel
Unfix 2 clamps by use of a screwdriver and then unfasten the right
front pillar trim panel.
Tips:
Protect the trim panel from damage by wrapping the sharp end of
screwdriver up with adhesive tape before operation.
7. Remove the left front pillar trim panel
8. Disconnect the right airbag connector
9. Remove the instrument panel sub-assembly
a. Unfix 6 screws <D>, <H> and 2 bolts <B>;
b. Unfix the screw <A>
c. Loosen 8 clips;
d. Disconnect the connector;2 clips
Clip
8 clips
Clasp

6-14 e. Pull the instrument panel sub-assembly backward and then take it out.
10. Remove the instrument panel lower housing assembly
Loosen 6 clasps and then pull the lower housing assembly out.
11. Remove the radio set assembly with bracket
a. Unfix 4 screws;
b. Disconnect the connector and then unfasten the radio set
assembly with bracket.
12. Remove the horn button assembly
13. Remove the steering wheel assembly
14. Remove the steering column upper cover assembly
15. Remove the steering column lower cover assembly
16. Remove the cupholder
17. Remove the auxiliary fasia console assembly
a. Unfix 3 screws;
b. Unfix 3 clips by use of a clip remover and then unfasten the
auxiliary fasia console assembly.6 clasps
2 clamps
2 clipsInterior & Exterior Trim and Accessory -Dashboard, Middle Console and Instrument Panel

6-1518. Remove the auxiliary fasia console trim panel
Unfix 6 clips and then unfasten the auxiliary fasia console trim
board
19. Remove the instrument panel lower housing assembly
a. Unfix 2 nuts <I> and <J>, 2 bolts <B> and 3 screws <C>
<F> <H>;
b. Unfix 16 clasps;
c. Unfasten the lower housing assembly.6 clips
16 claspsInterior & Exterior Trim and Accessory -Dashboard, Middle Console and Instrument Panel

Fig. 5-7 Luggage Compartment Main
Cover Assembly
1. Luggage compartment main cover
2. Rear seat hook mounting plate assembly
3. Left/right side angle plate
4. Drip channelII. Movable Plate Work(1) Engine Hood & Front Fender The engine hood is used to protect the engine and fit the vehicle design. It is also helpful to the repair and
maintenance, and isolates the engine's noise. The engine hood has a double-lock device. The unlocking function
of the first locking is controlled by the cable handle under the instrument board. The unlocking function of the
second locking can raise the hood to a certain height. The double-lock function is designed in consideration of
safety. Especially when the vehicle is running at a high speed, it can prevent the engine hood from being raised,
which may cause traffic accident. The maximum angle at which the engine hood opens is 65°(See Fig.5-8).Fig. 5-7 Engine Hood & Front Fender
1. Engine hood
2. Hinge pin
3. Hinge support
4. Hinge
5.Inner hood panelSurvey -Body Structure7-642
3
51Max. opening angle less
than 65°compartment together with the rear floor and side walls. As shown in Fig. 5-7, a torsion resistant frame is also
formed at the rear part at the same time.3
4
213 2