wheel torque GENESIS G70 2023 Owners Manual

Page 23 of 552

Vehicle Information, Consumer Information and Reporting Safety Defects2-10
Items Tire sizeWheel
size Inflation pressure
kPa (psi) Wheel nut
torque
NJI[P OEI[IW 1[P
Normal
load Maximum
Load OR
over 100 mph *
2
Full
size tire 2.0L
T-GDI
19 inch Front 225/40R19 8.0J X 19250 (36) 260 (38)
11~13 (79~94,
107~127)
Rear 255/35R19 8.5J X 19250 (36) 270 (39)
19 inch Front 225/40ZR19 8.0J X 19250 (36) 260 (38)
Rear 255/35ZR19 8.5J X 19250 (36) 270 (39)
3.3L
T-GDI
19 inch (2WD) Front 225/40R19 8.0J X 19
250 (36) 260 (38)
Rear 255/35R19 8.5J X 19250 (36) 270 (39)
Front 225/40ZR19 8.0J X 19250 (36) 260 (38)
Rear 255/35ZR19 8.5J X 19250 (36) 270 (39)
19 inch
(AWD) Front 225/40R19 8.0J X 19
260 (38) 260 (38)
Rear 255/35R19 8.5J X 19250 (36) 270 (39)
Front 225/40ZR19 8.0J X 19260 (38) 260 (38)
Rear 255/35ZR19 8.5J X 19250 (36) 270 (39)
Compact
spare tire *1T135/80R18 4.0T X 18420 (60) 420 (60)
*1 : If your vehicle is not equipped with a compact spare tire, your vehicle will be equipped
with a Tire Mobility Kit.
*2 : Must drive only where the speed is legal.
NOTICE
[ Ambient temperature affects tire pressure (about 1 psi (7 kPa) for every 12°F (7°C)
FKDQJH ,IFROGHUWHPSHUDWXUHVDUHDQWLFLSDWHGLWLVSHUPLVVLEOHWRLQFUHDVHFROG
tire inflation pressure by up to 3 psi (20 kPa) over the specification. If extreme
WHPSHUDWXUHFKDQJHVDUHH[SHFWHGEHVXUHWRFKHFNDQGDGMXVWWLUHSUHVVXUH
accordingly.
[ 7LUHLQIODWLRQSUHVVXUHGHFUHDVHVZLWKKLJKHUHOHYDWLRQDQGLQ FUHDVHVZLWKORZHU
elevation (about 2.4 psi (10 kPa) for every kilometer (or mile) elevation change).
%HVXUHWRFKHFNDQGDGMXVWWLUHSUHVVXUHDFFRUGLQJO\ZKHQGULY LQJWKURXJK
changing elevations.
[ 'RQRWH[FHHGWKHPD[LPXPLQIODWLRQSUHVVXUHDVIRXQGRQWKHVLGHZDOORIWKH
tire(s).
TIRES AND WHEELS

Page 286 of 552

Driving Your Vehicle6-34
Indicator lights
v ESC indicator light (blinks)
v ESC OFF indicator light (comes on)
When the Engine Start/Stop button is
pressed to the ON position, the ESC
indicator light illuminates, then goes off
if the ESC system is operating normally.
The ESC indicator light blinks whenever
ESC is operating.
If the ESC indicator light stays on, your
vehicle may have a malfunction with
the ESC system. When this warning light
illuminates, have the vehicle checked by
an authorized retailer of Genesis Branded
products as soon as possible.
The ESC OFF indicator light comes on
when ESC is turned off.
WARNING
When ESC is blinking, this indicates ESC
is active:
Drive slowly and NEVER attempt to
accelerate. NEVER turn ESC off while
the ESC indicator light is blinking or you
may lose control of the vehicle resulting
in an accident.
NOTICE
Driving with wheels and tires with
different sizes may cause the ESC
system to malfunction. Before replacing
tires, make sure all four tires and wheels
are the same size. Never drive the
vehicle with different sized wheels and
tires installed.
ESC OFF usage
hen Driving
The ESC OFF mode should only be used
brie
fly to help free the vehicle if stuck in
snow or mud, by temporarily stopping
operation of ESC, to maintain wheel
torque.
To turn ESC off while driving, press the
ESC OFF button while driving on a flat
road surface.
NOTICE
To prevent damage to the transmission:
[ Do not allow wheel(s) of one axle to
spin excessively while the ESC, ABS,
and Parking Brake warning lights
are displayed. The repairs would not
be covered by the vehicle warranty.
Reduce engine power and do not
spin the wheel(s) excessively while
these lights are displayed.
[ When operating the vehicle
on a dynamometer, make sure
ESC is turned off (ESC OFF light
illuminated).
Information
Turning ESC off does not affect ABS or
standard brake system operation.

Page 445 of 552

Emergency Situations8-16
OIK082040C
13. Use the wheel lug nut wrench to
tighten the lug nuts in the order
shown. Double-check each lug nut
until they are tight. After changing
tires, we recommend that an
authorized retailer of Genesis Branded
products tighten the lug nuts to their
proper torque as soon as possible. The
wheel lug nut should be tightened to
11~13 kgf·m (79~94 lbf·ft).
If you have a tire gauge, check the
tire pressure (see “Tires and Wheels”
section in chapter 2 for tire pressure
instructions.). If the pressure is lower or
higher than recommended, drive slowly
to the nearest service station and adjust
it to the recommended pressure. Always
reinstall the valve cap after checking
or adjusting tire pressure. If the cap
is not replaced, air may leak from the
tire. If you lose a valve cap, buy another
and install it as soon as possible. After
changing tires, secure the flat tire and
return the jack and tools to their proper
storage locations.
NOTICE
[ Check the tire pressure as soon
as possible after installing a spare
tire. Adjust it to the recommended
pressure.
[ Check and tighten the wheel lug nuts
after driving over 30 miles (50 km) if
tires are replaced. Recheck the tire
wheel lug nuts after driving over 600
miles (1,000 km).
CAUTION
Your vehicle has metric threads on
the studs and lug nuts. Make certain
during tire changing that the same
nuts that were removed are reinstalled.
If you have to replace your lug nuts
make sure they have metric threads to
avoid damaging the studs and ensure
the wheel is properly secured to the
hub. Consult an authorized retailer
of Genesis Branded products for
assistance.
If any of the equipment such as the jack,
lug nuts, studs, or other equipment is
damaged or in poor condition, do not
attempt to change the tire and call for
assistance.
Use of compact spare tires
Compact spare tires are designed for
emergency use only. Drive carefully on
the compact spare tire and always follow
the safety precautions.

Page 475 of 552

09
9-17
Brake Hoses and Lines
Visually check for proper installation,
chafing, cracks, deterioration and any
leakage. Replace any deteriorated or
damaged parts immediately.
Brake Fluid
Check the brake fluid level in the brake
fluid reservoir. The level should be
between the MIN and the MAX marks
on the side of the reservoir. Use only
hydraulic brake fluid conforming to DOT
4 specification.
Parking Brake
Inspect the parking brake system
including the parking brake pedal and
cables.
Brake Discs, Pads, Calipers and
Rotors
Check the pads for excessive wear, discs
for run out and wear, and calipers for
fluid leakage.
Exhaust Pipe and Muffler
Visually inspect the exhaust pipes,
muffler and hangers for cracks,
deterioration, or damage. Start
the engine and listen carefully for
any exhaust gas leakage. Tighten
connections or replace parts as
necessary.
Suspension Mounting Bolts
Check the suspension connections for
looseness or damage. Retighten to the
specified torque.
Steering Gear box, Linkage &
Boots/Lower Arm Ball Joint
With the vehicle stopped and the engine
off, check for excessive free-play in the
steering wheel. Check the linkage for
bends or damage. Check the dust boots
and ball joints for deterioration, cracks,
or damage.
Replace any damaged parts.
Drive Shafts and Boots
Check the drive shafts, boots and clamps
for cracks, deterioration, or damage.
Replace any damaged parts and, if
necessary, repack the grease.
Air Conditioning Refrigerant
Check the air conditioning lines and
connections for leakage and damage.

Page 494 of 552

Maintenance9-36
Tire Rotation
To equalize tread wear, Genesis
Branded Vehicle recommends that
the tires be rotated according to the
maintenance schedule or sooner if
irregular wear develops.
During rotation, check the tires for
correct balance.
When rotating tires, check for uneven
wear and damage. Abnormal wear
is usually caused by incorrect tire
pressure, improper wheel alignment,
out-of-balance wheels, severe braking
or severe cornering. Look for bumps or
bulges in the tread or side of the tire.
Replace the tire if you find any of these
conditions. Replace the tire if fabric or
cord is visible. After rotation, be sure to
bring the front and rear tire pressures
to specification and check wheel lug
nuts tightness (proper torque is 79~94
lbf·ft [11~13 kgf·m].
„19 inch tire
OHI078079
Disc brake pads should be inspected
for wear whenever tires are rotated.
Information
The outside and inside of the
unsymmetrical tire is distinguishable. hen installing an unsymmetrical
tire, be sure to install the side marked outside face the outside. If the side
marked inside is installed on the
outside, it will have a negative effect
on vehicle performance.
WARNING
[ Do not use the compact spare
tire for tire rotation.
[ Do not mix bias ply and radial ply
tires under any circumstances.
This may cause unusual handling
characteristics that may cause
loss of vehicle control resulting in
an accident.