trunk GENESIS G80 2023 Workshop Manual

9-48
Maintenance
Battery Junction Block
Fuse Name Fuse Rating Circuit Protected
B+8 100ARear Junction Block (Fuse(B+2, B+4, Solar Charger 1,
P/Door Rear LH, P/Door Rear RH, Presafety Seat Belt 2))
B+7 100ARear Junction Block (Fuse(B+3, S/Heater Rear LH, Child
Lock, S/Heater Rear RH, Power Trunk, P/Door DRV, P/Door
PASS))
B+6 100ARear Junction Block (Fuse(B+1, AMP, P/Window RH, ECS,
Presafety Seat Belt 1, Charger))
AMS 10A 12V Battery Sensor

9-54
Maintenance
„Glove box lamp
ORG3EV091034
„Inner door handle lamp (1) / Mood lamp (2) / Door foot lamp (3)
ORG3EV051063
(1) Inner door handle lamp
(2) Mood lamp
(3) Door foot lamp
„Trunk lamp
ORG3EV091023
If the LED lamp (1) does not operate,
have the system inspected by an
authorized retailer of Genesis Branded
products.
The LED lamps cannot be replaced as
a single unit because it is an integrated
unit. The LED lamps has to be replaced
with the unit.
A skilled technician should check or
repair the LED lamp, for it may damage
related parts of the vehicle.

9-56
Maintenance
NOTICE

[Do not use strong soap, chemical
detergents or hot water, and do not
wash the vehicle in direct sunlight
or when the body of the vehicle is
warm.

[Be careful when washing the side
windows of your vehicle.

[Especially, with high-pressure water,
water may leak through the windows
and wet the interior.

[To prevent damage to the plastic
parts, do not clean with chemical
solvents or strong detergents.
NOTICE
ORG3EV091039

[Water washing in the motor
compartment including high
pressure water washing may cause
the failure of electrical circuits
located in the vehicle compartment.

[Never allow water or other liquids
to come in contact with electrical/
electronic components inside the
vehicle as water or other liquids may
flow in to the motor compartment
through the front trunk and damage
electrical/electronic components.
NOTICE
Matte paint finish vehicle (if equipped)
Automatic car wash which uses rotating
brushes should not be used as this can
damage the surface of your vehicle. A
steam cleaner which washes the vehicle
surface at high temperature may result
the oil to adhere and leave stains that is
difficult to remove.
Use a soft cloth (e.g. microfiber towel
or sponge) when washing your vehicle
and dry with a microfiber towel. When
you hand wash your vehicle, you should
not use a cleaner that finishes with wax.
If the vehicle surface is too dirty (sand,
dirt, dust, contaminant, etc.), clean the
surface with water before washing the
car.
Waxing
A good coat of wax is a barrier between
your paint and contaminate. Keeping
a good coat of wax on your vehicle will
help protect it.
Wax the vehicle when water will no
longer bead on the paint.
Always wash and dry the vehicle before
waxing. Use a good quality liquid or
paste wax, and follow the manufacturer’s
instructions. Wax all metal trim to protect
it and to maintain its luster.
Removing oil, tar, and similar materials
with a spot remover will usually strip the
wax from the finish. Be sure to re-wax
these areas even if the rest of the vehicle
does not yet need waxing.