engine GENESIS G90 2023 Owners Manual

5-142
Convenience Features
WARNING
Windshield heating
Do not use the
position during
cooling operation in extremely humid
weather. The difference between the
temperature of the outside air and that
of the windshield could cause the outer
surface of the windshield to fog up,
causing loss of visibility could cause
an accident resulting in serious injury
or death. In this case, set the mode
selection button to the
position
and fan speed control knob to a lower
speed.

[For maximum defrost performance,
set the temperature control to the
highest temperature setting and
the fan speed control to the highest
setting.

[If warm air to the floor is desired while
defrosting or defogging, set the mode
to the floor-defrost position.

[Before driving, clear all snow and ice
from the windshield, rear window,
side view mirrors and all side
windows.

[Clear all snow and ice from the
hood and air inlet in the cowl grill
to improve heater and defroster
efficiency and to reduce the
probability of fogging up the inside of
the windshield.
NOTICE
If the engine temperature is still cold
after starting, then a brief engine warm
up period may be required for the
vented air flow to become warm or hot.
To Defog Inside Windshield
ORS051131L
1. Select the desired fan speed.
2. Select the desired temperature.
3. Press the defroster button (
).
4. Fresh mode will be selected
automatically.
Check to make sure the air intake control
is in Fresh mode. If the air intake control
indicator light is illuminated, press the
button once to enable Fresh mode
(indicator light OFF).
If the
position is selected, the fan
speed is automatically increased.
:,1'6+,(/''()5267,1*$1''()2**,1*

5-143
05
To Defrost Inside Windshield
ORS051130
1. Set the fan speed to the highest
(extreme right) position.
2. Set the temperature to the extreme
hot (HI) position.
3. Press the defroster button (
).
4. Fresh mode will be selected
automatically.
Check to make sure the air intake control
is in Fresh mode. If the air intake control
indicator light is illuminated, press the
button once to enable Fresh mode
(indicator light OFF).
If the
position is selected, lower fan
speed is adjusted to a higher fan speed.
Defogging Logic
To reduce the probability of fogging
up the inside of the windshield, the air
intake or air conditioning are controlled
automatically according to certain
conditions. To cancel or reset the
defogging logic, do the following.
1. Press the Engine Start/Stop button to
the ON position.
2. Press the defroster button (
) or
().
3. While pressing the air conditioning
button (A/C), press the air intake
control button at least 5 times within
3 seconds.
The air intake control button indicator
will blink 3 times to indicate that the
defogging logic has been disabled.
Repeat the steps again to re-enable the
defogging logic.
If the battery has been discharged or
disconnected, it resets to the defog logic
status.

5-144
Convenience Features
Rear Window Defroster
NOTICE
To prevent damage to the rear window
defroster conducting elements bonded
to the inside surface of the rear window,
never use sharp instruments or window
cleaners containing abrasives to clean
the window.
ORS051132
The defroster heats the window to
remove frost, fog and thin ice from the
interior and exterior of the rear window,
while the engine is running.

[To activate the rear window defroster,
press the rear window defroster
button located in the center control
panel. The indicator on the rear
window defroster button illuminates
when the defroster is ON.

[To turn off the defroster, press the rear
window defroster button again.
Information

[If there is heavy accumulation of snow
on the rear window, brush it off before
operating the rear defroster.

[The rear window defroster
automatically turns off after
approximately 20 minutes or when the
(QJLQH6WDUW6WRSEXWWRQLVLQWKH2))
position.
Side view mirror defroster
If your vehicle is equipped with the side
view mirror defrosters, they will operate
at the same time you turn on the rear
window defroster.

5-146
Convenience Features
Turning the Auto Defogging System
ON or OFF
&OLPDWHFRQWUROV\VWHP
Press the front windshield defroster
button for 3 seconds when the Engine
Start/Stop button is in the ON to turn the
system on or off.
To check whether the system is on
or off, go to the settings menu in the
infotainment system and see if 'Auto
Defog' is selected or not.
Infotainment system
Auto Defogging System can be turned
RQDQGRIIE\VHOHFWLQJ
S6HWXS

5-150
Convenience Features
UV-C sterilizer system
ORS051092
ORS051229
M: UV-C sterilizer system button,
N: UV-C LED,
O: UV-C Indicator light (upper part of armrest
touchscreen)
The rear seat console is equipped with
an antibacterial sterilization system for
personal belongings.
WARNING

[Press the button to turn UV-C
function off when it is not in use.
Being exposed to ultraviolet rays
from UV-C LED may be harmful to
your skin and eyes.

[Do not place magnetic items
(magnets, etc.) near the upper part
of the UV-C storage box. It may cause
malfunction to the UV-C sensor and
unnecessarily operate the UV-C
function.
NOTICE

[Press the button to turn UV-C
function off when it is not in use.
Prolonged exposure under ultraviolet
rays may change the color and shape
of the object.

['RQRWVWHULOL]HIRRG)RRGFDQQRW
be sterilized. Prolonged exposure
to ultraviolet rays may damage the
wrapping or container and affect the
food inside.
Using UV-C sterilizer system
Place the item in the UV-C storage box
and turn it on. Within 10 minutes, up to
99.9% of germs on the surface can be
removed.
1. Open the UV-C storage box while the
engine is running.
2. Press the button inside the storage
box.

[UV-C sterilizer system indicator light
illuminates.

[Antibacterial tray is ready to
operate.
3. Place the item in the center inside the
storage box and close the cover.

[UV-C indicator light illuminates.

[UV-C LED is turned on and
sterilization begins.

[After 10 minutes, the UV-C indicator
light turns off as sterilization is
complete.

[Press the UV-C sterilizer system
button to turn off the function, after
you are finished using the system.

5-156
Convenience Features
Power Outlet
ORS051096
ORS051097
A : Front seat,
B : Rear seat
The power outlet is designed to provide
power for mobile telephones or other
devices designed to operate with vehicle
electrical systems. The devices should
draw less than 180 W with the engine
running.
WARNING
Avoid electrical shocks. Do not place
your fingers or foreign objects (pin, etc.)
into a power outlet or touch the power
outlet with a wet hand.
NOTICE
To prevent damage to the power
outlets:

[Use the power outlet only when the
engine is running and remove the
accessory plug after use. Using the
accessory plug for prolonged periods
of time with the engine off could
cause the battery to discharge.

[Only use 12V electric accessories
which are less than 180 W in electric
capacity.

[Adjust the air-conditioner or heater
to the lowest operating level when
using the power outlet.

[Close the cover when not in use.

[Some electronic devices can
cause electronic interference
when plugged into a vehicle’s
power outlet. These devices may
cause excessive audio static and
malfunctions in other electronic
systems or devices used in your
vehicle.

[Push the plug in as far as it will go. If
good contact is not made, the plug
may overheat and the fuse may open.

[Plug in battery equipped electrical/
electronic devices with reverse
current protection. The current
from the battery may flow into the
vehicle’s electrical/electronic system
and cause system malfunction.

5-157
05
USB Charger (if equipped)
ORS051098
ORS051099
ORS051200
A : Front seat,
B : Rear seat (if equipped),
C : Rear seat
The USB-C charger is designed to
recharge batteries of small size electrical
devices using a USB-C cable.
The electrical devices can be recharged
when the Engine Start/Stop button is in
the ON (or START) position.
The battery charging state may be
monitored on the electrical device.Disconnect the USB-C cable from the
USB port after use.

[A smart phone or a tablet PC may
get warmer during the re-charging
process. It does not indicate any
malfunction with the charging system.

[A smart phone or a tablet PC, which
adopts a different re-charging
method, may not be properly re-
charged. In this case, use an exclusive
charger of your device.

[The charging terminal is only to
recharge a device. Do not use the
charging terminal either to turn on
an audio or to play media In the
infotainment system.
Information
&KDUJLQJPD\QRWEHSRVVLEOHZKHQXVLQJ
D7\SH&FRQYHUWHUVROGE\DPRELOHSKRQH
manufacturer or commercially available.

5-158
Convenience Features
Wireless Smart Phone Charging
System (if equipped)
ORS051201
ORS051202
A : Front seat,
B : Rear seat (if equipped),
M : Indicator light,
N : Charging pad
Charging smart phone
The wireless smart phone charging
system charges only the Qi-enabled
smart phones (
). Read the label on
the smart phone accessory cover or
visit your smart phone manufacturer’s
website to check whether your smart
phone supports the Qi technology.The wireless charging process starts
when you put a Qi-enabled smart phone
on the wireless charging unit.
1. The system is available when all doors
are closed, and when the Engine
Start/Stop button is in the ON (or
START) position.
2. You can turn on or off the wireless
charging function from the Settings
menu. Select:
- Front seat (infotainment system):
6HWXS

5-160
Convenience Features

[When charging some smart phones
with a self-protection feature, the
wireless charging speed may decrease
and the wireless charging may stop.

[If the smart phone has a thick cover,
the wireless charging may not be
possible.

[If the smart phone is not completely
contacting the charging pad, wireless
charging may not operate properly.

[If the Engine Start/Stop button is in the
2))SRVLWLRQWKHFKDUJLQJDOVRVWRSV

[When any smart phone without a
wireless charging function or a metallic
REMHFWLVSODFHGRQWKHFKDUJLQJSDG
a small noise may sound. This small
sound is due to the vehicle discerning
FRPSDWLELOLW\RIWKHREMHFWSODFHGRQ
the charging pad. It does not affect
your vehicle or the smart phone in any
way.

[Some smart phones may not be able
to charge depending on the internal
structure of the smart phone. If this
occurs, try charging the mobile phone
by moving it to the left or right side of
the wireless charging pad. However, for
some foldable smart phones that have
magnets inside the smart phone, try
charging the smart phone while holding
it close to the left side of the wireless
charging pad.NOTICE
Some magnetic items like credit cards,
phone cards or rail tickets may be
damaged if left with the smart phone
during the charging process.
Information
This device complies with Part 15 of the
)&&UXOHV
2SHUDWLRQLVVXEMHFWWRWKHIROORZLQJWKUHH
conditions:
1. This device may not cause harmful
interference, and
2. This device must accept any
interference received, including
interference that may cause undesired
operation.
3. &KDQJHVRUPRGLILFDWLRQVQRWH[SUHVVO\
approved by the party responsible
for compliance could void the user’s
authority to operate the device.

5-163
05
Using armrest touchscreen
ORS051206L
1. Press from the left side menu of
armrest touchscreen.
Rear side sunshade adjustment screen
is displayed.
2. Press 'Open' or 'Close’ to open or
close the rear side window sunshades.
Information
If the operating sunshade is blocked by an
REMHFWWKHVXQVKDGHVWRSVIURPRSHQLQJ
or closing. The sunshade is only able to
open (move downward) once stopped by
obstruction.
NOTICE
Do not apply excessive external force
on the rear side window sunshade while
operating. It may cause a malfunction.
Resetting the rear side window
sunshades
1. Start the engine.
2. Continue pulling up on the power
window switch for at least 10 seconds
when the window is closed.
If the sunshade is not operating
normally, it must be reset as follows:
If the rear side window sunshade does
not work properly after following the
above procedure, it is recommended that
the system be checked by an authorized
retailer of Genesis Branded products.
Information
If the temperature inside the vehicle is
EHORZ