change time GENESIS G90 2023 Owners Manual

All information in this Owner’s Manual is current at the time
of publication. However, Genesis reserves the right to make
changes at any time so that our policy of continual product
improvement may be carried out.
This manual applies to all Genesis Branded Vehicle models and
includes descriptions and explanations of optional as well as
standard equipment.
As a result, you may find material in this manual that does not
apply to your specific vehicle.
OWNER’S MANUAL
Operation
Maintenance
Specifications

3-8
Safety System
CAUTION
To prevent injury:

[Do not adjust your seat while
wearing your seat belt. Moving the
seat cushion forward may cause
strong pressure on your abdomen.

[Do not allow your hands or fingers to
get caught in the seat mechanisms
while the seat is moving.
WARNING
NEVER allow children in the vehicle
unattended. The power seats are
operable when the vehicle is turned off.
NOTICE
To prevent damage to the seats:

[Always stop adjusting the seats when
the seat has been adjusted as far
forward or rearward as possible.

[Do not adjust the seats longer than
necessary when the vehicle is turned
off. This may result in unnecessary
battery drain.

[Do not operate two or more seats at
the same time. This may result in an
electrical malfunction.
Forward and rearward adjustment
ORS031004
To move the seat forward or rearward:
1. Push the control switch forward or
rearward.
2. Release the switch once the seat
reaches the desired position.
Seat cushion tilt/height adjustment
ORS031007
Seat cushion tilt M
To change the angle of the front part of
the seat cushion:
Push the front portion of the control
switch up to raise or down to lower the
front part of the seat cushion.
Release the switch once the seat reaches
the desired position.

3-13
03
Seat massage function (for driver’s
seat) (if equipped)
ORS031016
Use the massage function to relax after
a long drive, or when resting inside the
vehicle.
1. While the Engine Start/Stop button is
in ‘ON’ position, press the massage
button on the driver’s seat door to
start the function.

[The light indicating massage
intensity level illuminates.
2. Press the button again to set the
intensity level.

[Each time you press the button, the
intensity setting of the Massage it is
changed as follows:
+LJK

3-22
Safety System
Information
Opening the door will return the calf
support to its original position.
CAUTION
Do not sit or place heavy objects on the
calf support. It may damage the system.
WARNING

[When lowering or raising the calf
support, be careful not to have your
hands or legs caught under the front
seats or other surrounding parts of
the calf support. Unexpected injuries
may occur.

[Do not allow children to adjust the
switch. Unexpected injuries may
occur.

[Make sure that the footrest and calf
support do not interfere with each
other while adjusting. The body parts
or objects may be damaged if it is
caught in the interference.
Rear seat massage function (if
equipped)
Use massage seat to relax after a long
drive, or when resting inside the vehicle.
ORS031033
Massage button
1. While the Engine Start/Stop button is
in ‘ON’ position, press the massage
button on the rear passenger seat
door to start the function.

[The light indicating massage
intensity level illuminates, and the
massage function will start.
2. Press the button again to set the
intensity level.

[Each time you press the button, the
intensity setting of the Massage is
changed as follows:
+LJK

3-23
03
ORS031137L
Setting the screen display
After pressing the massage button, you
can change the display method of each
massage mode from the armrest touch
screen. Follow the steps below.
1. Press 'Setup' from the home screen on
the armrest touchscreen, or press

from the left side menu.
2. Press 'Display'.
3. Select among 'Massage screen',
'Pop-up', or 'OFF' from the 'Massage
Notification/Status' menu.

[If Massage screen is selected,
pressing the Massage button will
move the armrest touchscreen
display to Massage mode tap.

[If 'Pop-up' is selected, pressing the
massage button will display the
massage mode pop-up screen on
the armrest touchscreen.
ORS031035L
Armrest touchscreen
1. Press from the left side menu on
the armrest touchscreen.

[Massage mode screen is displayed.
2. Select a desired mode.
M Whole-Body Energizing Mode
N Lumbar Therapy Mode
O Pelvis Balancing Mode
P Upper Body Refresh Mode
3. Select the desired duration.

[ Each time you press the button, the
intensity setting of the Massage it is
changed as follows:
+LJK

3-32
Safety System
Seat Warmers
Seat warmers are provided to warm the
seats during cold weather.
During mild weather or under conditions
where the operation of the seat warmer
is not needed, keep the seat warmers
OFF.
WARNING
The seat warmers can cause a SERIOUS
BURN, even at low temperatures and
especially if used for long periods of
time.
Passengers must be able to feel if the
seat is becoming too warm so they can
turn it off, if needed.
People who cannot detect temperature
change or pain to the skin should
use extreme caution, especially the
following types of passengers:

[Infants, children, elderly or disabled
persons, or hospital outpatients.

[People with sensitive skin or who
burn easily.

[Fatigued individuals.

[Intoxicated individuals.

[People taking medication that can
cause drowsiness or sleepiness.
WARNING
NEVER place anything on the seat
that insulates against heat when the
seat warmer is in operation, such as a
blanket or seat cushion. This may cause
the seat warmer to overheat, causing a
burn or damage to the seat.
NOTICE
To prevent damage to the seat warmers
and seats:

[Never use a solvent such as paint
thinner, benzene, alcohol or gasoline
to clean the seats.

[Do not place heavy or sharp objects
on seats equipped with seat
warmers.

[Do not change the seat cover. It may
damage the seat warmer.

3-33
03
Front seat warmers
ORS031040
While the engine is on, press the seat
heater button on the center console to
select the temperature level.

[Temperature level can be adjusted to
strong, medium, or weak. Pressing
the button each time will change the
temperature in turn from strong, to
medium, weak, and off.

[Press and hold the seat heater button
to turn it off.

[Auto. Controls That Use Climate
Control Settings (for driver’s seat)
The seat warmer automatically
controls the seat temperature
depending on the ambient
temperature when the engine is
running.
To use this function, it must be
enabled from the Settings menu in the
infotainment system screen. Select:
-6HWXS

3-35
03
2. Press next to the seat which
requires heating, from the air
conditioning screen.

[Seat heater is turned on with strong
temperature level.
3. Press
to lower the temperature.
Press to raise the temperature
again.

[Press and hold
or to turn off
the seat heater, or press multiple
times until it turns off.

[Seat heater automatically turns off
once the temperature reaches the
limit, and turns on again when the
temperature drops.

[Press
multiple times to turn
on the seat heater when the seat
ventilator is on. (if equipped)
Air Ventilation Seats
The air ventilation seats are provided
to cool the front seats by blowing air
through small vent holes on the surface
of the seat cushions and seatbacks.
When the operation of the air ventilation
seat is not needed, keep the air
ventilation seats OFF.
NOTICE
To prevent damage to the air ventilation
seats:

[Never use a solvent such as paint
thinner, benzene, alcohol or gasoline
to clean the seats.

[Avoid spilling liquids on the surface
of the front seats and seatbacks;
this may cause the air vent holes
to become blocked and not work
properly.

[Do not place materials such as
plastic bags or newspapers under
the seats. They may block the air
intake causing the air vents to not
work properly.

[Do not change the seat covers. It may
damage the air ventilation seat.

[If the air vents do not operate, restart
the vehicle. If there is no change,
we recommend that you have your
vehicle inspected by an authorized
retailer of Genesis Branded products.

3-36
Safety System
Front air ventilation seats (if
equipped)
ORS031041
While the engine is on, press the seat
ventilator button on the center console
to select the intensity level.

[Ventilation intensity level can be
adjusted to strong, medium, or weak.
Pressing the button each time will
change the intensity in turn from
strong, to medium, weak, and off.

[Press and hold the seat ventilator
button to turn it off.

[Auto. Controls That Use Climate
Control Settings (for driver’s seat)
The air ventilation seat automatically
controls the seat temperature
depending on the ambient
temperature when the engine is
running.
To use this function, it must be
enabled from the Settings menu in the
infotainment system screen. Select:
-6HWXS

4-21
04
LCD Display Messages
Vehicle is on
This message is displayed if you open the
driver’s door when the gear is in P (Park)
and the Engine Start/Stop button in the
ON or START position.
Turn the engine off before leaving the
vehicle.
Shift to P
This message is displayed if you try to
turn off the vehicle without the gear in
the P (Park) position.
If this occurs, the Engine Start/Stop
button turns to the ACC position.
Vehicle is in N. Press START button
and shift to P
This message is displayed if you try to
turn off the vehicle with the gear in N
(Neutral).
To turn off the vehicle:
1. Press the Engine Start/Stop button.
The button will change to the ON
position.
2. Press the P button to shift to P (Park).
3. Press the Engine Start/Stop button
again, then the vehicle will turn off.
Low key battery
This message is displayed if the battery
of the smart key is discharged while
changing the Engine Start/Stop button to
the OFF position.
Press brake pedal to start engine
This message is displayed if the Engine
Start/Stop button changes to the ACC
position twice by pressing the button
repeatedly without depressing the brake
pedal.
You can start the vehicle by depressing
the brake pedal and then pressing the
Engine Start/Stop button.
Key not in vehicle
This message is displayed if the smart
key is not in the vehicle when you leave
the vehicle with the Engine Start/Stop
button in the ON or Start position.
Always turn off the engine before leaving
your vehicle.
Key not detected
This message is displayed if the smart
key is not detected when you press the
Engine Start/Stop button.
Press START button again
This message is displayed if you were
unable to start the vehicle when the
Engine Start/Stop button was pressed.
If this occurs, attempt to start the engine
by pressing the Engine Start/ Stop button
again.
If the warning message appears each
time you press the Engine Start/Stop
button, we recommend that you have
the vehicle inspected by an authorized
retailer of Genesis Branded products.
004_RS4_HMA.indd 4-212022-04-06  3:02:32