oil GENESIS GV60 2023 Owners Manual

Page 86 of 690

2-15
02
5()5,*(5$17/$%(/í,)
ORG3EVQ011137L
A compressor label informs you the type
of compressor your vehicle is equipped
with such as model (1), serial number (2),
supplier part number (3), lot number (4),
refrigerant (4) and refrigerant oil (5).
AIR CONDITIONER
COMPRESSOR LABEL
(48,33('

Page 311 of 690

5-120
Convenience Features
Checking the amount of air
conditioner refrigerant and
compressor lubricant
When the amount of refrigerant is low,
the performance of the air conditioning
is reduced. Overfilling also reduces the
performance of the air conditioning
system.
Therefore, if abnormal operation is
found, have the system be inspected by
an authorized retailer of Genesis Branded
products.
NOTICE
It is important that the correct type and
amount of oil and refrigerant is used.
Otherwise, damage to the compressor
and abnormal system operation may
occur. To prevent damage, the air
conditioning system in your vehicle
should only be serviced by trained and
certified technicians.
NOTICE
[The refrigerant system should only
be serviced by trained and certified
technicians to insure proper and safe
operation.
[The refrigerant system should be
serviced in a well-ventilated place.
[The air conditioning evaporator
(cooling coil) shall never be repaired
or replaced with one removed from
a used or salvaged vehicle and new
replacement MAC evaporators shall
be certified (and labeled) as meeting
SAE Standard J2842.
WARNING
Vehicles equipped with R-1234yfSince the refrigerant is
mildly flammable and
operated at high pressure,
the air conditioning system
should only be serviced
by trained and certified
technicians. It is important
that the correct type and
amount of oil and refrigerant
are used.
All refrigerants should be reclaimed
with proper equipment.
Venting refrigerants directly to the
atmosphere is harmful to individuals
and environment. Failure to heed these
warnings can lead to serious injuries.
[
Check the coolant level when
the motor compartment
is cooled. Coolant level is
influenced by temperature,
and if the coolant reservoir
cap is removed when coolant
temperature is high, hot
coolant and steam may blow
out under pressure causing
serious injury.
[Make sure the coolant cap is properly
closed after refilling coolant.
Otherwise the motor could be
overheated while driving.

Page 329 of 690

5-138
Convenience Features
Rear Side Window Sunshades (if
equipped)
Use the rear side window sunshade to
block external light coming through the
rear window glass.
OJWEV051076
1. Lift the sunshade by the handle (1).
2. Hang the sunshade on both sides of
the hook (2). If the sunshade is hung
on one side of the hook, the sunshade
may be wrinkled.
NOTICE
[Do not hang any other object except
the rear side window sunshade on
the hooks.
[If you pull the rear side window
sunshade or apply force to return
the sunshade to its original position
after use, you may find the sunshade
wrinkled or out of shape. To lower
the sunshade, be sure to put the
handle downward and slowly return
the sunshade to its original position.
[Sunshades may not work properly if
foreign objects (coins, toys, cookies,
etc.) are stuck in the door. Be careful
that the foreign objects do not get
into the door.
Luggage Net Holder (if
equipped)
OJWEV051202
To keep items from shifting in the
luggage compartment, you can use the 4
holders located in the luggage board to
attach the luggage net.
Make sure the luggage net is securely
attached to the holders in the luggage
board.
If necessary, contact your authorized
retailer of Genesis Branded products to
obtain a luggage net.
WARNING
Avoid eye injury. DO NOT overstretch
the luggage net. ALWAYS keep your
face and body out of the luggage net’s
recoil path. DO NOT use the luggage net
when the strap has visible signs of wear
or damage.
Use the luggage net to keep only light
items from shifting in the luggage
compartment.

Page 332 of 690

5-141
05
INFOTAINMENT SYSTEM
NOTICE
[If you install an aftermarket HID
head lamp, your vehicle’s audio and
electronic devices may not function
properly.
[Prevent chemicals such as perfume,
cosmetic oil, sun cream, hand
cleaner, and air freshener from
contacting the interior parts
because they may cause damage or
discoloration.
USB-C Port
OJWEV051080L
You can use an USB-C cable to connect
audio devices to the vehicle USB-C port.
Information
:KHQXVLQJDSRUWDEOHDXGLRGHYLFH
connected to the power outlet, noise may
occur during playback. If this happens,
use the portable audio device’s power
source.
Antenna
OJWEV051077
The shark fin antenna will receive AM,
FM broadcast signals and transmit data.
Steering Wheel Remote Controls
OJWEV051249L
NOTICE
Do not operate multiple audio remote
control buttons simultaneously.

Page 436 of 690

7-22
Driver Assistance System
[The speed of the other vehicle is very
fast that it passes by your vehicle in a
short time
[Your vehicle passes by the other
vehicle
[Your vehicle has started at the same
time as the vehicle next to you and
has accelerated
[The vehicle in the next lane moves
two lanes away from you, or when the
vehicle two lanes away moves to the
next lane from you
[A motorcycle or bicycle is detected
[A vehicle such as a flat trailer is
detected
[A big vehicle such as a bus or truck is
detected
[A small moving obstacle such as a
pedestrian, animal, shopping cart or a
baby stroller is detected
[A vehicle with low height such as a
sports car is detected
[The lane is difficult to see due to
foreign material, such as rain, snow,
dust, sand, oil and water puddles
[The color of the lane marking is not
distinguishable from the road[There are markings on the road near
the lane or the markings on the road
looks similar to the lane markings
[The shadow is on the lane marking by
a median strip, trees, guardrail, noise
barriers, etc.
[The lane number increases or
decreases, or the lane markings are
crossing
[There are more than two lane
markings on the road
[The lane markings are complicated or
a structure substitutes for the lines,
such as a construction area
[There are road markings, such as
zigzag lanes, crosswalk markings and
road signs
[The lane suddenly disappears, such as
at the intersection
[The lane is very wide or narrow
[There is a curb or road edges without
a lane
[The vehicle in front is driving with one
side on the lane marking
[The distance to the front vehicle is
extremely short

Page 445 of 690

7-31
07
/DQH.HHSLQJ$VVLVW0DOIXQFWLRQ
and Limitations
Lane Keeping Assist malfunction
ORG3EV071192L
When Lane Keeping Assist is not working
properly, the ‘Check Lane Keeping Assist
(LKA) system’ warning message will
appear and the yellow
indicator
light will illuminate on the cluster. If this
occurs, have the vehicle be inspected by
an authorized retailer of Genesis Branded
products.
Limitations of Lane Keeping Assist
Lane Keeping Assist may not operate
properly or may operate unexpectedly
under the following circumstances:
[The lane is contaminated or difficult
to detect because:
- The lane markings (or road edge)
are covered with rain, snow, dirt,
oil, etc.
- The color of the lane marking (or
road edge) is not distinguishable
from the road
- There are markings (or road
edges) on the road near the lane
or the markings (or road edges) on
the road look similar to the lane
markings (or road edge)
- The lane marking (or road edge) is
indistinct or damaged
- The shadow is on the lane marking
(or road edge) by a median strip,
trees, guardrail, noise barriers, etc.
- The number of lanes change or the
lanes merge
[There are more than two lane
markings (or road edges) on the road
[The lane markings (or road edges) are
complicated or a structure substitutes
for the lines, such as a construction
area
[There are road markings, such as
zigzag lanes, crosswalk markings and
road signs
[The lane suddenly disappears, such as
at the intersection
[The lane (or road width) is very wide
or narrow
[There is a road edge without a lane
[There is a boundary structure in the
roadway, such as a tollgate, sidewalk,
curb, etc.
[The distance to the front vehicle is
extremely short or the vehicle in front
is covering the lane marking (or road
edge)

Page 641 of 690

9-14
Maintenance
Checking the Brake Fluid Level
OJWEV091003
Check the fluid level in the reservoir
periodically. The fluid level should be
between MAX and MIN marks on the side
of the reservoir.
Before removing the reservoir cap and
adding brake fluid, clean the area around
the reservoir cap thoroughly to prevent
brake fluid contamination.
If the level is low, add the specified brake
fluid to the MAX level. The level will fall
with accumulated kilometers. This is a
normal condition associated with the
wear of the brake linings. If the fluid level
is excessively low, have the brake system
be checked by an authorized retailer of
Genesis Branded products.
WARNING
If the brake system requires frequent
additions of fluid this could indicate
a leak in the brake system. Have the
vehicle be inspected by an authorized
retailer of Genesis Branded products.
WARNING
Do not let brake fluid enter into your
eyes. If brake fluid gets in your eyes,
flush your eyes with clean water for
at least 15 minutes and get immediate
medical attention.
NOTICE
[Do not allow brake fluid to contact
the vehicle’s body paint, as it will
result in paint damage.
[NEVER use brake fluid which has
been exposed to open air for an
extended time, as its quality cannot
be guaranteed. It should be disposed
of properly.
[Do not use the wrong type of brake
fluid. A few drops of mineral based
oil in your brake system can damage
brake system parts.
Information
Use only the specified brake fluid (refer
to “Recommended Lubricants and
Capacities” section in chapter 2).
BRAKE FLUID

Page 648 of 690

9-21
09
12V Battery Recharging
By battery charger
Should your vehicle’s 12V Battery
become discharged either run the
motor for at least 60 minutes driving.
Alternatively you may connect a fully
automatic regulated charger to the
motor compartment front jumper posts.
WARNING
Always follow these instructions when
recharging your vehicle’s battery to
avoid the risk of SERIOUS INJURY or
DEATH from explosions or acid burns:
[Before performing maintenance or
recharging the battery, turn off all
accessories and stop the vehicle.
[Keep all flames, sparks, or smoking
materials away from the battery.
[Always work outdoors or in an area
with plenty of ventilation.
[Wear eye protection when checking
the battery during charging.
[The battery must be removed from
the vehicle and placed in a well
ventilated area.
[Watch the battery during charging,
and stop or reduce the charging
rate if the battery cells begin boiling
violently.
[The negative battery cable must
be removed first and installed last
when the battery is disconnected.
Disconnect the battery charger in the
following order:
1. Turn off the battery charger main
switch.
2. Unhook the negative clamp from
the negative battery terminal.
3. Unhook the positive clamp from
the positive battery terminal.
[Always use batteries for replacement
from an authorized retailer of
Genesis Branded products.
NOTICE
AGM battery
[Absorbent Glass Matt (AGM)
batteries are maintenance-free and
have the AGM battery be serviced
by an authorized retailer of Genesis
Branded products. For charging
your AGM battery, use only fully
automatic battery chargers that
are specially developed for AGM
batteries.
[When replacing the AGM battery,
use parts for replacement from
an authorized retailer of Genesis
Branded products.
[Do not open or remove the cap on
top of the battery. This may cause
leaks of internal electrolyte that
could result in severe injury.

Page 658 of 690

9-31
09
Bias ply tire
A pneumatic tire in which the plies are
laid at alternate angles less than 90
degrees to the centerline of the tread.
Cold tire pressure
The amount of air pressure in a tire,
measured in pounds per square inch
(psi) or kilopascals (kPa) before a tire
has built up heat from driving.
Curb weight
This means the weight of a motor
vehicle with standard and optional
equipment including the maximum
capacity of fuel, oil and coolant, but
without passengers and cargo.
DOT markings
A code molded into the sidewall
of a tire signifying that the tire
is in compliance with the U.S.
Department of Transportation motor
vehicle safety standards. The DOT
code includes the Tire Identification
Number (TIN), an alphanumeric
designator which can also identify
the tire manufacturer, production
plant, brand and date of production.
GVWR
Gross Vehicle Weight Rating
GAWR FRT
Gross Axle Weight Rating for the
Front Axle.
GAWR RR
Gross Axle Weight Rating for the
Rear axle.
Intended outboard sidewall
The side of an asymmetrical tire,
that must always face outward when
mounted on a vehicle.
Kilopascal (kPa)
The metric unit for air pressure.
Light Truck (LT) tire
A tire designated by its manufacturer
as primarily intended for use on
lightweight trucks or multipurpose
passenger vehicles.
Load ratings
The maximum load that a tire is rated
to carry for a given inflation pressure.
Load index
An assigned number ranging from 1
to 279 that corresponds to the load
carrying capacity of a tire.
Maximum inflation pressure
The maximum air pressure to which
a cold tire may be inflated. The
maximum air pressure is molded
onto the sidewall.
Maximum load rating
The load rating for a tire at the
maximum permissible inflation
pressure for that tire.

Page 663 of 690

9-36
Maintenance
v
Blade type
v
Cartridge type
v
Multi typeNormal Blown
Normal Blown
Normal Blown
OTM078035
A vehicle’s electrical system is protected
from electrical overload damage by
fuses.
This vehicle has 2 fuse panels, one
located in the driver’s side panel bolster,
the other in the vehicle compartment.
If any of your vehicle’s lights,
accessories, or controls do not work,
check the appropriate circuit fuse. If a
fuse has blown, the element inside the
fuse will be melted or broken.
If the electrical system does not work,
first check the driver’s side fuse panel.
Before replacing a blown fuse, turn the
vehicle and all switches off, and then
disconnect the negative battery cable.
Always replace a blown fuse with one of
the same rating.
If the replacement fuse blows, this
indicates an electrical problem. Avoid
using the involved and immediately
consult an authorized retailer of Genesis
Branded products.
WARNING
NEVER replace a fuse with anything but
another fuse of the same rating.
[A higher capacity fuse could cause
damage and possibly cause a fire.
[Do not install a wire or aluminum
foil instead of the proper fuse -
even as a temporary repair. It may
cause extensive wiring damage and
possibly a fire.
NOTICE
Do not use a screwdriver or any other
metal object to remove fuses because
it may cause a short circuit and damage
the system.
FUSES

Page:   1-10 11-20 next >