maintenance GMC C-SERIES 1999 Owner's Manual

yellowblue
6-30
NOTICE:

When using concentrated washer fluid,
follow the manufacturer's instructions for
adding water.

Don't mix water with ready
-to-use washer
fluid. Water can cause the solution to freeze
and damage your washer fluid tank and
other parts of the washer system. Also,
water doesn't clean as well as washer fluid.

Fill your washer fluid tank only
three
-quarters full when it's very cold.
This allows for expansion if freezing occurs,
which could damage the tank if it is
completely full.

Don't use engine coolant (antifreeze) in
your windshield washer. It can damage
your washer system and paint.
Brakes
Brake Fluid
If your vehicle has
hydraulic brakes, there's
a brake master cylinder.
The brake master cylinder
reservoir is here. Refer to
the Maintenance Schedule
to determine when to check
your brake fluid.
ProCarManuals.com

yellowblue
6-31
CAUTION:
Don't add brake fluid before you check the level.
If you do, you could get too much brake fluid.
Brake fluid could spill on the hot engine and it
can catch fire. You could be burned and your
vehicle could be damaged.
Checking Brake Fluid
Apply the brake pedal several times with the ignition
off. Then clean one of the reservoir caps and the area
around the cap, and remove it. The fluid level should be
even with the bottom ring of the filler opening.
If it's low, add enough fluid
to fill the reservoir to the
proper level.
What to Add
Use the proper fluid listed in your Maintenance
Schedule. Use new brake fluid from a sealed
container only.
Always clean the brake fluid reservoir cap and the area
around the cap before removing it. This will help keep
dirt from entering the reservoir.
ProCarManuals.com

yellowblue
6-34 Air Dryer (Option)
If your vehicle has air brakes, it may have an air dryer.
This collects and removes dirt, moisture or other foreign
matter from the air prior to entering the brake system. It
is mounted on the left frame rail.
If your dryer is a
Bendix
-Westinghouse, it
has a filter that you need to
change at intervals. See
your Maintenance Schedule
for more about servicing
this filter.
Alcohol Injector (Option)
If your vehicle has air brakes, it may have an alcohol
injector. It is on the frame or crossmember at the right
front corner of the vehicle.
The alcohol injector helps prevent moisture in the air
brake system from freezing. Use it only in cold weather,
32
F (0
C) or below.
ProCarManuals.com

yellowblue
6-37 Clutch Pedal Free Travel
If you have a manual transmission, your clutch will need
adjustment when pedal free travel gets down to about
1 1/4 inch (32 mm), as measured at the clutch pedal pad.
You should have 1 1/2 to 2 inches (38 to 51 mm) of
clutch pedal free travel. Your Maintenance Schedule has
more on this.
If your clutch ever needs service, be sure to use only
genuine GM clutch replacement parts.
Chassis Lubrication
Your Maintenance Schedule provides all of the required
chassis lubrication intervals and identifies proper
lubricants to use. Be sure to see your Maintenance
Schedule before performing any chassis lubrication
service. To determine location of chassis lubrication
items, use the following charts.
ProCarManuals.com

yellowblue
6-42
Battery
Your new vehicle comes with one or more ACDelco
Freedom
maintenance free batteries. When it's time
for a new battery, we recommend an ACDelco Freedom
maintenance free battery. Be sure it has the replacement
number shown on the original battery's label.
Vehicle Storage
If you're not going to drive your vehicle for 25 days or
more, remove the black, negative (
-) cable from the
battery. This will help keep your battery from running
down. (If your vehicle has more than one battery, be
sure to remove the negative (
-) battery cable from
each battery.)
CAUTION:
Batteries have acid that can burn you and gas
that can explode. You can be badly hurt if you
aren't careful. See ªJump Startingº in the Index
for tips on working around a battery without
getting hurt.
When you are ready to use the vehicle again, refer to the
engine starting procedure in the Index.
Contact your dealer to learn how to prepare your vehicle
for longer storage periods.
ProCarManuals.com

yellowblue
6-44
Other Service Items
Component Box
Your vehicle has a component box along the left frame rail.
What is in the box depends on what options are on your
vehicle. Normally, the fuel filter, air dryer, Luberfiner oil
filter, emission canister or other components are in there.
To get into the box, you first have to remove the top
cover. To do that, remove the two 8 mm bolts on top and
the single 8 mm bolt at the top front. Then, pull the
cover toward you and lift it off.You can then remove the front cover if you need to, by
removing the two 8 mm bolts and pulling it off.
When you're through, be sure to put the front cover on,
before you put on the top cover.
Fuel Filter (Gasoline Engines)
The steel fuel filter is located inside the component box
at the rear. See your Maintenance Schedule for
recommended service intervals.
If your vehicle is equipped with the optional Davco
spin
-on type filter, it is also located in the component box.
ProCarManuals.com

yellowblue
6-45 Fuel Filter (Diesel Engines)
The ACDelco
fuel filter is located in the component
box. See your Maintenance Schedule for recommended
service intervals.
Primary Fuel Filter and Water Separator
(Option)
If you have a Caterpillar

diesel engine, you may
have this spin
-on filter.
It is in the component box
on the driver's side behind
the fender.
It has a clear plastic drain bowl at the bottom. Check the
drain bowl occasionally for any water or particles. To
drain the bowl, shut off the engine. Then partially open
the drain valve at the bottom of the filter. See ªEngine
Oilº in the Index for proper disposal procedures.
Secondary Fuel Filter and Water
Separator/Heater (Option)
If you have a Caterpillar

diesel engine, you may have
this spin
-on filter and fuel
separator/heater. It is
mounted on the passenger's
side of the engine.
It has a metal drain bowl at the bottom. Occasionally, check
the bowl for any water or particles. To check or drain the
bowl, shut off the engine. Then push up on the spring loaded
drain valve until clear fuel is flowing from the valve. The
particles or water will drain out first. See ªEngine Oilº in the
Index for proper disposal procedures.
ProCarManuals.com

yellowblue
6-47 Front Wheel Bearings with Oil-Filled Hubs
If your vehicle has oil-filled
hubs, occasionally check to
see if they have enough oil.
You can tell by looking into
the sight glass to see if there
is oil there.
If there isn't, clean the rubber fill plug in the center of
the glass, and then remove it. Be careful not to allow
any dirt or water to get into the oil. Add enough of the
recommended oil to bring it up to the level mark that
you'll see on the glass.
Refer to your Maintenance Schedule for the proper oil
to use.
When you fill the hub, check the glass again after
driving a short distance. It takes a while for the oil to
flow through the system, and you may find that you
have to add a little more to fill it to the proper level.
Air Conditioning System
Every now and then, have your dealership check your
air conditioning system to be sure it has not lost any
cooling ability. If you think the system is not working
properly, have your GM Truck dealer check it out as
soon as possible.
The air conditioning won't work when the temperature
outside is below 40
F (4
C).
NOTICE:
If your vehicle is equipped with factory air
conditioning, the system is charged with the
R
-134a refrigerant. Servicing of the air
conditioning system should be performed by a
trained service technician.
ProCarManuals.com

yellowblue
6-65
Finish Damage
Any stone chips, fractures or deep scratches in the finish
should be repaired right away. Bare metal will corrode
quickly and may develop into a major repair expense.
Minor chips and scratches can be repaired with touch
-up
materials available from your dealer or other service
outlets. Larger areas of finish damage can be corrected
in your dealer's body and paint shop.
Underbody Maintenance
Chemicals used for ice and snow removal and dust control
can collect on the underbody. If these are not removed,
accelerated corrosion (rust) can occur on the underbody
parts such as fuel lines, frame, floor pan and exhaust
system even though they have corrosion protection.
At least every spring, flush these materials from the
underbody with plain water. Clean any areas where mud
and other debris can collect. Dirt packed in closed areas
of the frame should be loosened before being flushed.
Your dealer or an underbody vehicle washing system
can do this for you.
Chemical Paint Spotting
Some weather and atmospheric conditions can create a
chemical fallout. Airborne pollutants can fall upon and
attack painted surfaces on your vehicle. This damage
can take two forms: blotchy, ringlet
-shaped
discolorations, and small irregular dark spots etched into
the paint surface.
Although no defect in the paint job causes this, GM will
repair, at no charge to the owner, the surfaces of new
vehicles damaged by this fallout condition within
12 months or 12,000 miles (20 000 km) of purchase,
whichever occurs first.
This applies only to materials manufactured and sold by
General Motors. Bodies, body conversions or equipment
not made or sold by General Motors are not covered.
ProCarManuals.com

yellowblue
6-75
Extending the recommended oil change interval requires
the use of an infrared oil analysis program which shows
the condition of the oil and its additives. For more
information, consult your GM Truck dealer, who is an
authorized Caterpillar

engine dealer.
Transmission Capacity
Capacities (volumes) shown are approximate. For
manual transmissions, the correct oil level is to the
bottom of the fluid fill plug opening. The oil capacity
will vary, due to the angle of the transmission, with the
vehicle. For automatic transmissions, see the Allison
Automatic Transmission Operator's Manual for oil
check and maintenance information.
Manual Transmission Pints (Liters)
RT6609 12.0 (5.7). . . . . . . . . . . . . . . . . . . . . . . . . . . . .
RT6610 12.0 (5.8). . . . . . . . . . . . . . . . . . . . . . . . . . . . .
RTO6610 12.0 (5.8). . . . . . . . . . . . . . . . . . . . . . . . . . . RT6613 16.0 (7.5). . . . . . . . . . . . . . . . . . . . . . . . . . . . .
RT7608LL 19.5 (9.3). . . . . . . . . . . . . . . . . . . . . . . . . .
RT8609 15.0 (7.0). . . . . . . . . . . . . . . . . . . . . . . . . . . . .
FS4205A, FS4205B, FS4205C 12.5 (5.9). . . . . . . . . .
5205A, FS5205C 12.5 (5.9). . . . . . . . . . . . . . . . . . . . .
FS5306 18.0 (8.5). . . . . . . . . . . . . . . . . . . . . . . . . . . . .
FS6305A, FS6305B 19.0 (9.0). . . . . . . . . . . . . . . . . . .
FS6306 19.5 (9.2). . . . . . . . . . . . . . . . . . . . . . . . . . . . .
FS7206 20.0 (9.5). . . . . . . . . . . . . . . . . . . . . . . . . . . . .
T8607B 36.0 (17.0). . . . . . . . . . . . . . . . . . . . . . . . . . .
Automatic Transmission Pints (Liters)
AT542 (for oil pan filter change) 30.0 (14.0)*. . . . . . .
AT545 (for oil pan filter change) 40.0 (19.0)*. . . . . . .
MT643 (for oil pan filter change) 13.0 (24.5)*. . . . . .
MT653 (for oil pan filter change) 36.0 (17.0)*. . . . . .
*Add two pints (one liter) when changing spin
-on filter.
ProCarManuals.com