brake GMC ENVOY 2007 Get To Know Guide

A.Exterior Lamp Controls
B.Air Outlets
C.Turn Signal/Multifunction Lever
D.OnStar
®/Audio Steering Wheel
Controls
E.Instrument Panel Cluster
F.Audio Steering Wheel ControlsG.Ignition Switch
H.Audio System
I.Climate Controls
J.Hood Release
K.Driver Information Center (DIC)
Steering Wheel Controls
L.Transfer Case ControlsM.Shift Lever
N.Lighter
O.Accessory Power Outlets
P.Parking Brake
Q.Rear Window Washer/Wiper
R.Rear Window Defogger
S.Glove Box
Getting to Know YourEnvoy2
See Section 3 of your Owner Manual.
Instrument Panel
DRIVER INFORMATION

9
Rear Seat Climate Controls
(if equipped)Electric Adjustable Pedals
Adjust the brake and accelerator
pedals to comfortable positions
• Press the switch located on the
steering column toward you to move
the pedals closer to you.
• Press the switch away from you to
move the pedals away from you.
See Section 2 of your Owner Manual.
Note:The pedals cannot be positioned
farther away from the driver than theyare in their standard position. This
feature can be programmed to workwith the memory function (if equipped)
on your vehicle. Adjustment of the powered pedals requires that the vehicle be in Park.
Turn the rear controls on and off
• Press the Power button. The rear
controls do not function when the frontclimate control is in Defrost mode.
Change the direction of airflow
•Use the mode knob on SLE (or the
button on SLT models) to select
Upper, BiLevel or Floor.
Set the temperature of air through the
rear outlets
• Temperature of air from the rear
outlets is determined by the front passenger temperature setting.
See Section 3 of your Owner Manual.
SLT Model
SLE Model

17
StabiliTrak®– Stability Control
System
StabiliTrak combines antilock brake,
traction control, and stability control sys
tems that help the driver maintain direc
tional control of the vehicle in most driv
ing conditions. The system is designedto help keep the vehicle on the driver’s
intended path by using throttle andbrake intervention.
When activated, the system will apply
braking to individual wheels and mayreduce engine power as necessary tohelp you maintain directional control of
the vehicle. You may also hear a noise
or vibration, or feel a reduction in accel
eration, while the system is active. This
is normal.
StabiliTrak is automatically turned on
when the vehicle is started and does not require any driver input. It is recom
mended to leave the system on at all
times for normal driving. It may be necessary to turn off the traction control
portion of the system if the vehicle is
stuck in sand, mud or snow.
To turn off the traction control portion
of StabiliTrak, press and release the
(StabiliTrak) button located on the
transmission shift lever. TRACTION
CONTROLOFF will be displayed on the
DIC. Press the button again to turn thesystem back on.
To turn off StabiliTrak, which includes
traction control and stability control functions, press and hold the
(StabiliTrak) button for five seconds.STABILITRAK OFF will be displayed on
the DIC. Press the button again to turn
the system back on.
See Section 4 of your Owner Manual.
FourWheel Drive (if equipped)
Envoy’s four
wheel drivesystem rotarycontrols arelocated on theinstrument panel.
Shift into 4(4high) or AUTO
• Turn the knob to 4or AUTO.
This can be done at any speed
except when shifting from 4
(4low).
Shift into 2(2high)
•Turn the knob to 2. This can be
done at any speed except whenshifting from 4
.
Shift into or out of 4
• With the ignition in Run and the
vehicle stopped or moving less than
3 mph (4.8 km/h), shift the transmission into Neutral.
• Turn the knob to 4
,2, 4or
AUTO, preferably with the vehicle
moving 1 to 2 mph (1.6 to 3.2 km/h).
• Wait for the indicator lamp to stop
flashing and remain illuminated; then
shift your transmission into gear.
Shift into Neutral (N)
• Place the transfer case in Neutral
only when towing your vehicle. See Section 4 of your Owner Manual for towing information.
See Sections 2, 4 and 5 of your Owner Manual.